Vacuum‐driven fluid manipulation by a piezoelectric diaphragm micropump for microfluidic droplet generation with a rapid system response time

Recently, we developed a convenient microfluidic droplet generation device based on vacuum‐driven fluid manipulation with a piezoelectric diaphragm micropump. In the present study built on our previous work, we investigate the influence of settings applied to the piezoelectric pump, such as peak‐to‐peak drive voltage (V_p‐p) and wave frequency, on droplet generation characteristics. Stepwise adjustments to the drive voltage in ±10‐V_p‐p increments over the range of 200?250 V_p‐p during droplet creation revealed that the droplet generation rate could be reproducibly controlled at a specific drive voltage. The droplet generation rate switched within <0.5 s after the input of a new voltage. Although the droplet generation rate depended on the drive voltage, this setting had almost no influence on droplet size. The frequency over the selected range (50?60 Hz) did not markedly influence the droplet generation rate or droplet size. We show that the current fluid manipulation system can be conveniently used for both droplet generation and for rapid droplet reading, which is required in many microfluidic‐based applications.     

Temperature dependence of the exafs spectrum in YBa2Cu3O7−δ compounds

The temperature dependence of the extended X-ray absorption fine structure (EXAFS) is studied in the high T_c superconductors, YBa₂Cu₃O_7−δ. The measurements were done at the Cu K-edge for samples of two orthorhombic phases (T_c≈90 K and ≈58 K, respectively) and a nonsuperconducting tetragonal phase. Interatomic distances and mean square relative displacements σ² for Cu-O bonds are determined by the least squares refinement. The results indicate that values of σ² increase near T_c for both the orthorhombic samples. It is concluded that this anomalous behavior related to T_c is caused by an anomalous vibration of oxygen atoms in the Ba-O layer. Changes in the Cu-O distances from 300 to 20 K are not found.     

Effects of oblique-incidence evaporation on magnetic properties of Fe20Ni80/Fe70Co30 bilayer film

Evaporative deposition at oblique incidence is shown to enhance the magnetic anisotropy of an Fe₂₀Ni₈₀ magnetic film and induce magnetic anisotropy in an overlying, strongly isotropic Fe₇₀Co₃₀ film. This deposition method for the formation of an underlayer of several lattice parameters in thickness and semi-hard overlayer of a few thousands Angstroms in thickness achieves a significant change in the magnetization process and strong suppression of the coercive forces of Fe₇₀Co₃₀ in the hard magnetization direction. Soft magnetization of the Fe₇₀Co₃₀ overlayer is not achieved when one of the layers is deposited at oblique incidence. It is anticipated that shape magnetic anisotropy is responsible in part for the magnetic anisotropy induced in both in Fe₂₀Ni₈₀ under- and Fe₇₀Co₃₀ overlayer by oblique incidence evaporation.     

Synthesis and properties of tricyclo[6.4.1.0]trideca-1,3(6),7,9,11-pentaene

A new cyclobutene-fused 1,6-methano[10]annulene was synthesized by pyrolysis of the sulfone and sulfinate adducts of 3,4-bis(methylene)-1,6-methano[10]annulene and its physical and chemical properties were disclosed.     

A facile non-oxidative method for synthesizing 1,3-disubstituted pyrroles from pyrrolidine and aldehydes

Reactions of pyrrolidine with 2 equiv of aldehydes without any catalyst in a pressurized vessel at 140–200 °C yielded 1,3-disubstituted pyrroles. -Branched aldehydes gave fairly good yields of the corresponding products by this method, which provides a facile non-oxidative procedure for synthesizing 1,3-dialkylpyrroles from inexpensive pyrrolidine and aldehydes.     

Synthesis of aromatic poly(thioether ketone)

Aromatic poly(thioether ketone)s were prepared by the direct polycondensation of aromatic dicarboxylic acids with aryl compounds containing ether or sulfide structures using phosphorus pentoxide/methanesulfonic acid (PPMA) as a condensing agent and solvent. Polycondensation proceeded smoothly and produced aromatic poly(thioether ketone)s with inherent viscosities up to 0.73 dL/g. The synthesis of substituted aryl ketones by the reaction of substituted benzoic acids with aryl compounds in PMMA was studied in detail to demonstrate the feasibility of the reaction for polymer formation. The thermogravimetry of the aromatic poly(thioether ketone)s showed a 10% weight loss in air and nitrogen at around 450 and 460°C, respectively. © 1992 John Wiley & Sons, Inc.     

Ethylene polymerization by chromium complexes with phosphorous‐bridged bisphenoxy ligand

Chromium catalysts combined with phosphorous‐bridged bisphenoxy ligands were found to be highly active for ethylene polymerization. The most efficient catalyst precursor among them, generated by combining bis[3‐tert‐butyl‐5‐methyl‐2‐hydroxyphenyl](phenyl)phosphine hydrochloride ( 1a ) and CrCl₃(THF)₃, was characterized. X‐ray analysis of (3‐tert‐butyl‐5‐methyl‐2‐phenoxy)(3‐tert‐butyl‐5‐methyl‐ 2‐hydroxyphenyl)(phenyl)phosphine bis(tetrahydrofuran)chromium dichloride ( 6 ), obtained by the reaction of 1a and CrCl₃(THF)₃ in the presence of NaH, revealed a unique structure in which one phenol moiety of the bisphenol did not coordinate to the chromium center. Complex 6 showed higher activities than those observed in the in situ catalyst system. Polyethylene of various molecular weights was obtained with differing activators. The highest activity (113.5 kg mmol (cat)^?1 h^?1) was observed when TIBA/TB was used as a cocatalyst. A medium molecular weight polymer with narrow molecular weight distribution (M_w = 128,700, M_w/M_n = 1.8) was obtained using a 6 ‐TIBA/B(C₆F₅)₃ system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 3668–3676, 2007     

Electron spin resonance studies on radiation graft copolymerization in polyethylene. II. Grafting initiated by allyl radicals trapped in irradiated polyethylene

The regions trapping allyl radicals in irradiated polyethylene and the reactivity of the radicals with various monomers have been studied by electron spin resonance. Most of the allyl radicals are trapped in defects or surfaces of the crystallite, and only 10% of the radicals are trapped inside the crystallites. Since the reactivity of the allyl radicals depends on whether they come in contact with reactive monomers, the rate of reaction is related to the concentration of the monomers. When grafting reactions are initiated by allyl radicals, the rate of initiation is rapid and the rate of termination at the initial stage is also very fast. Consequently the yield of grafting increases at the initial stage but soon levels off, which is in contrast to the grafting behavior with alkyl radicals.