The spectrum of Nd in rare earth orthoaluminates. The trigonal to orthorhombic transition study of the level

Some structural and spectroscopic features of rare earth orthoaluminates are examined.The trigonal→ orthorhombic transition is studied in a series of Nd_xSm_1−xAlO₃ compounds. The evolution of the crystal structure is followed by X-ray analysis and optical absorption. The free ion and crystal field parameters of Nd³⁺ (4f³ configuration) are determined in LuAlO₃:Nd³⁺.The anomaly of the calculated splitting of the levels is slight, but well characterized in NdAlO₃. The spin correlated crystal field and orbitally correlated crystal field models are tested as well as an empirical correction which was proposed earlier.     

Exploring Little Higgs models with ATLAS at the LHC-

The European Physical Journal C - We discuss possible searches for the new particles predicted by Little Higgs Models at the LHC. By using a simulation of the ATLAS detector, we demonstrate how the...     

Dynamic mechanical thermal analysis transitions of partially and fully substituted cellulose fatty esters

The main transitions of cellulose fatty esters with different degrees of substitution (DSs) were investigated with dynamic mechanical thermal analysis. Two distinct main relaxations were observed in partially substituted cellulose esters (PSCEs). They were attributed to the glass‐transition temperature and to the chain local motion of the aliphatic substituents. The temperatures of both transitions decreased when DS or the number of carbon atoms (n) of the acyl substituent increased. Conversely, all the transitions of fully substituted cellulose esters occurred within a narrow temperature range, and they did not vary significantly with n. This phenomenon was explained by the formation of a crystalline phase of the fatty substituents. The presence of few residual OH groups in PSCEs was responsible for a large increase in the storage bending modulus, and it eliminated the effect of n on damping. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 281–288, 2003     

Direction of magnetization and domain wall mobility in (Dy,Y)Fe2

Magnetization measurements in the (Dy _x Y_1−x )Fe₂ intermetallic compounds show evidence of blocking of domain wall motion. This effect is a function of concentrationx. The direction of magnetization is also dependent on the Dy concentration. We have used the Mossbauer spectroscopy of⁵⁷Fe to verify the direction of magnetization in the series as a function ofx and temperature. The results show that this change in easy direction occurs at higher temperatures than those where the blocking is detected through DC magnetization measurements. supported by RHAE/SCT.     

Immobilization of catalase on membranes of poly(ethylene)-g-co-acrylic acid and poly(tetrafluoroethylene)-g-co-acrylic acid and their application in hydrogen peroxide electrochemical sensors

The immobilization of catalase on grafted membranes of poly(ethylene)-g-co-acrylic acid and poly(tetrafluoroethylene)-g-co-acrylic acid and their application in hydrogen peroxide electrochemical sensors is described. The introduction of carboxylic acid groups onto a hydrophobic support provides a good environment for subsequent enzyme immobilization. This single membrane, hydrogen peroxide sensor showed significant improvement with respect to the double membrane versions. The response is very rapid, the linear range being from 10 μM up to 6 mM, with a detection limit of 4.7 μM, and a lifetime of more than 4 months.     

Extended X-ray absorption fine structure studies of thulium doped GaN epilayers

The local structure of Tm³⁺ ions incorporated into GaN epilayers was studied by means of Extended X-ray Absorption Fine Structure. The samples were doped either in situ during growth by Molecular Beam Epitaxy or by ion implantation of layers grown by Metal Organic Chemical Vapour Deposition. The implantation was done at ion energy of 300 keV and different nominal fluences of 3×10¹⁵, 4×10¹⁵ cm⁻² and 5×10¹⁵ cm⁻². The concentration of Tm in the samples studied was measured by Wavelength Dispersive X-ray analysis. For the in situ doped sample with concentration of 0.5%, and for all of the implanted samples, Tm was found on the Ga site in GaN. The ion implanted sample and an in situ doped sample with a similar concentration of Tm showed the same local structure, which suggests that the lattice site occupied by Tm does not depend on the doping method. When the average Tm concentration for in situ doped samples is increased to 1.2% and 2.0%, Tm is found to occupy the Ga substitutional site and the presence of a substantial number of Tm ions in the second coordination sphere indicates dopant clustering in the films. The formation of pure TmN clusters was found in an in situ doped sample with a dopant concentration of 3.4%.     

Scaling impacted structures

Summary The problem of non-scalability of structures under impact loads caused by strain-rate effects is solved in this article by properly correcting the impact velocity. The technique relies on the use of an alternative dimensionless basis, together with a mathematical model which allows the calculation of a correction factor for the impact velocity. This new velocity, when applied to the model, makes it to assure the satisfaction of the scaling laws. The indirect similitude method detailed here is applied to two strain-rate sensitive structures, a double plate under in-plane impact and a beam subjected to a blast load. The results show a very good agreement so that the model and a prototype made from strain rate sensitive materials behave the same.accepted for publication 3 March 2004     

Effect of aeration on lignin peroxidase production by Streptomyces viridosporus T7A

The effect of aeration on lignin peroxidase production by Streptomyces viridosporus T7A was studied in a bench-scale bioreactor using a previously optimized growth medium (0.65% yeast extract and 0.1% corn oil, pH7.0) at 37°C and natural pH. Airflow rates of 0.3, 1.0, and 1.5 vvm and a fixed agitation of 200 rpm were initially studied followed by 1.0 vvm and 200, 300, 400, and 500 rpm. The use of 1.0 vvm and 400 rpm increased enzyme concentration 1.8-fold (100–180 U/L) and process productivity 4.8-fold (1.4–6.7 U/[L·h]) in comparison with the use of 200 rpm and 0.3 vvm. The inexpensive corn oil, used as carbon source, besides its antifoam properties, proved to be nonrepressive for enzyme production.