排序方式: 共有56条查询结果,搜索用时 328 毫秒
1.
Saulis G Lape R Praneviciūte R Mickevicius D 《Bioelectrochemistry (Amsterdam, Netherlands)》2005,67(1):101-108
The change of the pH of a NaCl solution (139-149 mM NaCl) buffered with 5-15 mM sodium phosphates (pH 7.4) during electromanipulation was studied. It has been determined that an increase in the pH value of electroporation solution of a whole chamber volume, caused by the application of electric field pulses, commonly used in cell electromanipulation procedures, can exceed 1-2 pH units. Several materials for the cathode were tested. In all cases a stainless steel anode was utilized. The aluminum cathode gave a two-fold greater DeltapH in comparison with platinum, copper or stainless steel cathodes. In addition, a substantial release of aluminum (up to 1 mg/l) from the cathode was observed. It has also been found that the shift in pH depended on the medium conductivity: DeltapH of the solution, in which sucrose was substituted for NaCl, was about 5 times less. On the basis of the results obtained here, to avoid the plausible undesirable consequences of the cathodic electrolysis processes, in particular under the conditions of strong electric treatment, it could be recommended that chambers with aluminum electrodes not be utilized and one should use strongly buffered solutions of low conductivity and alternating current (sine or square wave) bipolar electric pulses. 相似文献
2.
3.
Remigijus Ivanauskas Vitalijus Janickis Vitalija Jasulaitienė 《Central European Journal of Chemistry》2013,11(4):636-643
Some earlier synthesized copper selenide (Cu x Se) layers formed on the surface of polyamide 6 by sorption-diffusion method using potassium selenotrithionate (K2SeS2O6) as precursor of selenium were characterized by the XRD, XPS and SEM methods. According to the results of the SEM studies, the most uniform Cu x Se layers form at the 2.5 h polyamide seleniumized duration at the temperature of 60°C. The thickness of layers, which dependeds on the duration of seleniumization, changed in the range of 0.8–3.2 µm. The XRD patterns of not previously studied Cu x Se layers showed their phase composition of six copper selenides: Cu2Se, two phases of CuSe2, Cu3Se2, berzellianite, Cu2-x Se, and bellidoite Cu2Se. Analysis of the XRD and XPS data shows that the macrostructure and composition of the CuxSe layers depend on the conditions of formation of these layers. 相似文献
4.
Remigijus Mikulevičius 《随机分析与应用》2015,33(3):549-571
This article studies the rate of convergence of the weak Euler approximation for Itô diffusion and jump processes with Hölder-continuous generators. It covers a number of stochastic processes including the nondegenerate diffusion processes and a class of stochastic differential equations driven by stable processes. To estimate the rate of convergence, the existence of a unique solution to the corresponding backward Kolmogorov equation in Hölder space is first proved. It then shows that the Euler scheme yields positive weak order of convergence. 相似文献
5.
6.
R. Leipus 《Lithuanian Mathematical Journal》1988,28(4):348-352
V. Kapsukas Vilnius State University. Translated from Litovskii Matematicheskii Sbornik (Lietuvos Matematikos Rinkinys), Vol. 28, No. 4, pp. 716–723, October–December, 1988. 相似文献
7.
We consider a box-constrained global optimization problem with a Lipschitz-continuous objective function and an unknown Lipschitz constant. The well known derivative-free global-search DIRECT (DIvide a hyper-RECTangle) algorithm performs well solving such problems. However, the efficiency of the DIRECT algorithm deteriorates on problems with many local optima and when the solution with high accuracy is required. To overcome these difficulties different regimes of global and local search are introduced or the algorithm is combined with local optimization. In this paper we investigate a different direction of improvement of the DIRECT algorithm and propose a new strategy for the selection of potentially optimal rectangles, what does not require any additional parameters or local search subroutines. An extensive experimental investigation reveals the effectiveness of the proposed enhancements. 相似文献
8.
9.
The well known DIRECT (DIviding RECTangles) algorithm for global optimization requires bound constraints on variables and does not naturally address additional linear or nonlinear constraints. A feasible region defined by linear constraints may be covered by simplices, therefore simplicial partitioning may tackle linear constraints in a very subtle way. In this paper we demonstrate this advantage of simplicial partitioning by applying a recently proposed deterministic simplicial partitions based DISIMPL algorithm for optimization problems defined by general linear constraints (Lc-DISIMPL). An extensive experimental investigation reveals advantages of this approach to such problems comparing with different constraint-handling methods, proposed for use with DIRECT. Furthermore the Lc-DISIMPL algorithm gives very competitive results compared to a derivative-free particle swarm algorithm (PSwarm) which was previously shown to give very promising results. Moreover, DISIMPL guarantees the convergence to the global solution, whereas the PSwarm algorithm sometimes fails to converge to the global minimum. 相似文献
10.
Remigijus Ivanauskas Ingrida Ancutienė Vitalijus Janickis Rūta Stokienė 《Central European Journal of Chemistry》2009,7(4):864-869
The process of obtaining semiconductive and electrical conductive layers of copper sulfides by the sorption — diffusion method
on polymers (polyamide 6 and low density polyethylene) using solutions of potassium pentathionate, K2S5O6, and higher polythionic acids, H2S
n
O6 (n = 21, 33), was investigated. The layers were characterized for compositional and electrical properties by X-ray diffraction
(XRD) analysis and sheet resistance measurements. The thickness of copper sulfides layers on polyamide and polyethylene increased
with increasing time of polymer sulfurization and varied from 10 to 43 μm. The variations of the sheet resistance of copper
sulfides layers formed on the surface of polymers on sulfurization agent used, the conditions of sulfurization, chemical and
phase composition of the obtained layers were established. Sheet resistance of copper sulfides layers decreases with increasing
time of the duration of sulfurization and the number of sulfur atoms in the polythionate anion. The sheet resistance values
for copper sulfide layers formed on the polyamide surface are much lower than those of Cu
x
S formed on the polyethylene surface. XRD showed the predomination of Cu
x
S phases with low x values.
相似文献