Dosimetry of fast neutrons in 1W nuclear reactor with plastic nuclear-track detectors

A nuclear reactor at Kinki University is operated at the maximum of 1W. It produces fission neutrons as much as gamma-rays. To facilitate its use for neutron radiobiology, fast neutrons inside the reactor were measured with nuclear-track detectors TS 16 N and a pair of ion chambers. The angular dependence of TS 16 N response, an anisotropy of fast neutron fluxes in the reactor and misuse of the kerma factor assumed for radiation protection business are the major causes of discrepancy is measured doses by the two methods. Correction factors for the three causes are proposed. After correction, neutron doses estimated with TS 16 N and chambers agree within 5%. The dose-rate at the reactor's center is about 20 tissue-cGy/h. This is the first in situ dosimetry of fast neutrons in a reactor with track detectors attached to biologic samples. Our routine usage has demonstrated that, if used with caution, TS 16 N elements are handy, reliable monitors for fast neutron dosimetry as they are insensitive to contaminated gamma-rays and small enough to be attached to biologic samples.     

Structural studies of the carbon monoxide complex of [NiFe]hydrogenase from Desulfovibrio vulgaris Miyazaki F: suggestion for the initial activation site for dihydrogen

The carbon monoxide complex of [NiFe]hydrogenase from Desulfovibrio vulgaris Miyazaki F has been characterized by X-ray crystallography and absorption and resonance Raman spectroscopy. Nine crystal structures of the [NiFe]hydrogenase in the CO-bound and CO-liberated forms were determined at 1.2-1.4 A resolution. The exogenously added CO was assigned to be bound to the Ni atom at the Ni-Fe active site. The CO was not replaced with H(2) in the dark at 100 K, but was liberated by illumination with a strong white light. The Ni-C distances and Ni-C-O angles were about 1.77 A and 160 degrees, respectively, except for one case (1.72 A and 135 degrees ), in which an additional electron density peak between the CO and Sgamma(Cys546) was recognized. Distinct changes were observed in the electron density distribution of the Ni and Sgamma(Cys546) atoms between the CO-bound and CO-liberated structures for all the crystals tested. The novel structural features found near the Ni and Sgamma(Cys546) atoms suggest that these two atoms at the Ni-Fe active site play a role during the initial H(2)-binding process. Anaerobic addition of CO to dithionite-reduced [NiFe]hydrogenase led to a new absorption band at about 470 nm ( approximately 3000 M(-1)cm(-1)). Resonance Raman spectra (excitation at 476.5 nm) of the CO complex revealed CO-isotope-sensitive bands at 375/393 and 430 cm(-1) (368 and 413 cm(-1) for (13)C(18)O). The frequencies and relative intensities of the CO-related Raman bands indicated that the exogenous CO is bound to the Ni atom with a bent Ni-C-O structure in solution, in agreement with the refined structure determined by X-ray crystallography.     

Mechanical properties of twist grain boundaries in Cu

In a previous paper we studied the Young's and shear modulus of a high-angle twist grain boundary (5) in Cu, using the EAM, and related it to the uniaxial strain derivatives of single crystals. In this paper, we discuss elastic properties of ten additional twist grain boundaries, from 8.8–43.6°. The monolayer Young's modulus at each boundary was calculated and found to be 20–50% higher than the bulk value for all eleven boundaries for both csl and type1 structures. The monolayer shear modulus at each boundary was calculated and found to be 93–98% lower than the bulk value for six grain boundaries with csl structure and found to decrease with increasing twist angle. The critical shear stress was also calculated for eleven boundaries with csl structure and found to roughly decrease with increasing twist angle.     

Selective growth of ag nanowires on Si(111) surfaces by electroless deposition

Electroless deposition of Ag on atomically flat H-terminated Si(111) surfaces in aqueous alkaline solutions containing Ag ions produced two different sizes of Ag nanowires along atomic step edges: (1) a narrow nanowire of 10 nm in width and 0.5 nm in height and (2) a wide nanowire of 35 nm in width and 11 nm in height. The narrow and wide nanowires were formed by immersion in the solutions containing less than 1 ppb and 8 ppm dissolved-oxygen concentrations, respectively. This result indicates that the dissolved oxygen initiates the formation of Ag nucleation sites and that the fabrication method has a possibility of controlling the size of Ag nanowires.     

Chromium- and tungsten-triggered valence isomerism of cis-1-acyl-2-ethynylcyclopropanes via [3,3]sigmatropy of (2-acylcyclopropyl)vinylidene-metal intermediates.

The reaction of cis vicinal acetylethynylcyclopropanes 1 with a catalytic amount of M(CO)5(THF) (M = Cr or W) in the presence of Et3N at room temperature gave ortho-substituted phenols 7 in good yields as valence isomerized products. In the absence of Et3N the reactions did not work at all. The reaction of a cyclopropane having an ester or an amide instead of an acetyl moiety with M(CO)5(THF) did not take place, whereas an ethynylvinylcyclopropane gave a mixture of 1- and 2-substituted 1,3,5-cycloheptatrienes. These valence isomerization reactions are assumed to proceed via the formation of vinylidene-metal intermediates 2 from terminal alkynyl moieties followed by [3,3]sigmatropy of 2 to give seven-membered carbene complexes 3.     

Effect of lipid composition on phospholipase A2-catalyzed membrane leakage in immobilized liposomes: sensitization for polychlorinated biphenyls detection with antibody affinity column tandem with fluorescent liposome column

Phospholipase A(2) (PLA(2))-catalyzed membrane leakage can be detected by immobilized liposomes containing a self-quenching fluorescent dye, calcein, on an open column using off-line analysis with a fluorescent spectrophotometer. The calcein release was found to be affected by the pH value, incubation time, and liposome compositions. The fluorescent signal from the negatively charged liposomes hydrolyzed by PLA(2) was 5 times higher than that from neutral liposomes. We utilized this enzymatic reaction to amplify signal to detect polychlorinated biphenyls (PCBs). To achieve this goal, we conjugated an analogue of PCB, 3,4-dichloroaniline, to PLA(2). The competitive immunoreaction between the 3,4-dichloroaniline-PLA(2) conjugate and PCB samples on the anti-PCB antibody column caused the release of the bound PLA(2) conjugates in proportion to the PCB concentration. The released PLA(2) conjugates was then passed through the tandem fluorescent liposome column causing release of fluorescent dye from the liposomes. Therefore, the signal of immunocompetitive assay was amplified on the fluorescent liposome column. The tandem column system achieves a high sensitivity by detecting the PCB concentration as low as 0.5 ng/mL in less than 20 min. It has great potential in detecting other pollutants, and has been used for sensitive immunoassays.