Silicon-Based Integrated Optic Pressure Sensor Using Intermodal Interference between TM-Like and TE-Like Modes

In this paper, a silicon-based integrated optic pressure sensor using an intermodal interference between the fundamental TM-like and TE-like modes is described. The sensor consists of a micromachined rectangular diaphragm and a straight polystyrene optical waveguide passing over the diaphragm. Its sensitivity is theoretically known to be strongly dependent on the position of the waveguide over the diaphragm. To experimentally investigate such dependence, we fabricated a sensor with a 1.2 mm ×10 mm ×20 μm diaphragm, over which waveguides were placed at 50 μm intervals. The measured phase sensitivity was 98 mrad/kPa for the waveguide nearest to the diaphragm edge. The measurement was also carried out for the other waveguides. As theoretically expected, the largest sensitivity was obtained for the waveguide nearest to the edge.     

Photoluminescence linewidth broadening due to alloy/thickness fluctuation of CdxZn1 − xSe/ZnSe triple quantum wells

Photoluminescence (PL) linewidth broadening of Cd_xZn_{1 − x}Se/ZnSe triple quantum wells, grown on GaAs substrates by molecular beam epitaxy (MBE), has been investigated. Various quantum well (QW) samples have been prepared with different QW thickness and composition (Cd-composition). Measured and calculated PL linewidth are compared. Both composition and thickness fluctuations are considered for the calculation with the parameters such as the volume of exciton, nominal thickness and composition of QWs. Surface roughness measured by atomic force microscopy (AFM) is used to estimate the interface roughness. Results show that when Cd-composition increases additional linewidth broadening due to Zn/Cd interdiffusion is enhanced.     

Experimental analysis, modeling, and theoretical design of McMaster pore-filled nanofiltration membranes

A side-by-side comparison of the performance of McMaster pore-filled (MacPF) and commercial nanofiltration (NF) membranes is presented here. The single-salt and multi-component performance of these membranes is studied using experimental data and using a mathematical model. The pseudo two-dimensional model is based on the extended Nernst–Planck equation, a modified Poisson–Boltzmann equation, and hydrodynamic calculations. The model includes four structural properties of the membrane: pore radius, pure water permeability, surface charge density and the ratio of effective membrane thickness to water content. The analysis demonstrates that the rejection and transport mechanisms are the same in the commercial and MacPF membranes with different contributions from each type of mechanism (convection, diffusion and electromigration). Solute rejection in NF membranes is determined primarily by a combination of steric and electrostatic effects. The selectivity of MacPF membranes is primarily determined by electrostatic effects with a significantly smaller contribution of steric effects compared to commercial membranes. Hence, these membranes have the ability to reject ions while remaining highly permeable to low molecular weight organics. Additionally, a new theoretical membrane design approach is presented. This design procedure potentially offers the optimization of NF membrane performance by tailoring the membrane structure and operating variables to the specific process, simultaneously. The procedure is validated at the laboratory scale.     

Effect of temperature on the luminescence processes of SrAl2O4:Eu

The UV excited and persistent luminescence properties as well as thermoluminescence (TL) of Eu²⁺ doped strontium aluminates, SrAl₂O₄:Eu²⁺ were studied at different temperatures. Two luminescence bands peaking at 445 and 520 nm were observed at 20 K but only the latter at 295 K. Both Sr-sites in the lattice are thus occupied by Eu²⁺ but at room temperature efficient energy transfer occurs between the two sites. The UV excited and persistent luminescence spectra were similar at 295 K but the excitation spectra were different. Thus the luminescent centre is the same in both phenomena but excitation processes are different. Two TL peaks were observed between 50 and 250 °C in the glow curve. Multiple traps were, however, observed by preheating and initial rise methods. With longer delay times only the high temperature TL peak was observed. The persistent luminescence is mainly due to slow fading of the low temperature TL peak but the step-wise feeding process from high temperature traps is also probable.     

Mutation detection in the drug-resistant hepatitis B virus polymerase gene using nanostructured reverse micelles.

The emergence of drug-resistant hepatitis B virus (HBV) has been reported in patients with prolonged administration of lamivudine, which is a potent drug for the prevention of HBV infection. Lamivudine-resistant HBV has several types of mutations at the YMDD motif of its DNA polymerase. We successfully demonstrated that monitoring the hybridization behavior in nanostructured reverse micelles enables us to detect single nucleotide polymorphisms (SNPs). With the aid of reverse micelles, a model 40-mer oligonucleotide containing a single-base substitution was clearly distinguished from the normal, complementary oligonucleotide. In addition, we extended this technique to a high-throughput analysis. The results obtained with a 96-well micro-plate reader indicated the possibility of SNPs detection toward multiple samples of patients.     

Addition–fragmentation chain transfer: Molecular weight distributions and retardation in the system methyl methacrylate/methyl α‐(bromomethyl)acrylate

A detailed investigation of addition–fragmentation chain transfer (AFCT) in the free‐radical polymerization of methyl methacrylate (MMA) in the presence of methyl α‐(bromomethyl)acrylate (MBMA) was carried out to elucidate mechanistic details with efficient macromonomer synthesis as an underlying goal. Advanced modeling techniques were used in connection with the experimental work. Curve fitting of simulated and experimental molecular weight distributions with respect to the rate coefficient for addition of propagating radicals to MBMA (k_add) over 60–120 °C resulted in E_add = 21.7 kJ mol^?1 and A_add = 2.18 × 10⁶ M^?1 s^?1 and a very weak temperature dependence of the chain‐transfer constant (E_add ≈ E_p). The rate coefficient for fragmentation of adduct radicals at 60 °C was estimated as k_f ≈ 39 s^?1 on the basis of experimental data of the MMA conversion and the concentration of 2‐carbomethoxy‐2‐propenyl end groups. The approach developed is generic and can be applied to any AFCT system in which copolymerization does not occur and in which the resulting unsaturated end groups do not undergo further reactions. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2640–2650, 2004     

Buchsbaum homogeneous algebras with minimal multiplicity

In this paper we first give a lower bound on multiplicities for Buchsbaum homogeneous k-algebras A in terms of the dimension d, the codimension c, the initial degree q, and the length of the local cohomology modules of A. Next, we introduce the notion of Buchsbaum k-algebras with minimal multiplicity of degree q, and give several characterizations for those rings. In particular, we will show that those algebras have linear free resolutions. Further, we will give many examples of those algebras.     

Reduction of dislocation density and improvement of optical quality in ZnO layers by MgO-buffer annealing

Optical properties of ZnO thin films with/without MgO-buffer annealing were investigated by low and room temperature photoluminescence measurements. The ZnO films were grown on c-sapphire substrates by plasma-assisted molecular-beam epitaxy employing a thin MgO-buffer layer. Dislocation density of ZnO layer was reduced from 5.3 × 10⁹ to 1.9 × 10⁹ cm⁻² by annealing MgO-buffer prior to the growth of ZnO. The intensity of free exciton emission from the sample with MgO-buffer annealing was almost twice of that from the sample without annealing, while the deep level emission from the sample with MgO-buffer annealing was about 1/3 of that without annealing. The MgO-buffer annealing improves optical quality of overgrown ZnO films.