Kinetics of the solution polymerization of dioxolane in the presence of water

Water acts as a cocatalyst in the polymerization of dioxolane initiated by the ion pair ～Si^⊕HSO₄^?. The dependence of the reaction rate on the water concentration exhibits a maximum, the width of which strongly depends on the concentration of dioxolane. The change of the coordinates of the maximum and its shape with the decrease of the monomer concentration causes the reaction rate to decrease with increasing conversion. The point at which the slope of the conversion curve changes is a function of initial concentration of water. There is a very fast decrease of the concentration of free water in the polymerizing system. The consumption of water is associated with some peculiarities. The amount of free water which remains in the system is a function of the concentration of the original initiator. The ratio [H₂O]_∞/[initiator] is constant over a rather broad range of initial concentration of water.     

Direct determination of the enantiomeric purity of oxyphenonium using chiral HPLC with post-column extraction detection

Summary A method is described for the determination of the enantiomeric purity (enantiomeric excess) of the anticholinergic drug oxyphenonium. The method for this quaternary ammonium compound is based on the direct HPLC analysis with a chiral stationary phase. Two kinds of 1-acid glycoprotein-bonded phases were used.For the detection a post-column extraction with fluorescence detection of the ion-pair counter ion dimethoxyantracene sulphonate was used.     

A model of the chemical composition and pyrolysis kinetics of lignin

This study presents a novel approach for the chemical representation of lignin for modelling the reaction kinetics of lignin in lignocellulosic biomass. This methodology relies on the definition of dimeric pseudo-components containing phenolic functionalities, i.e., p-hydroxyphenyl, guaiacyl and syringyl groups, as measured in real biomass and native lignin through wet chemistry and spectroscopic techniques. The reactivities of the lignin pseudo-components are modelled through a series of lumped unidirectional reactions, whose product formation and reaction rate constants are optimised to replicate a comprehensive experimental dataset gathered from several works available in the literature. The new kinetic model contributes to the state-of-the-art by providing a more accurate depiction of the conversion rates, selectivity of char vs. volatiles, and aromatic composition in condensable products in line with the inherent reactivity of lignin functionalities and the empirical observations of lignin depolymerisation and thermal degradation at low (<1?K/s) and high heating rates (>50?K/s).     

Vortex locking in direct numerical simulations of quantum turbulence

Direct numerical simulations are used to examine the locking of quantized superfluid vortices and normal fluid vorticity in evolving turbulent flows. The superfluid is driven by the normal fluid, which undergoes either a decaying Taylor-Green flow or a linearly forced homogeneous isotropic turbulent flow, although the back reaction of the superfluid on the normal fluid flow is omitted. Using correlation functions and wavelet transforms, we present numerical and visual evidence for vortex locking on length scales above the intervortex spacing.     

Development of a manual method for the determination of mineral oil in foods and paperboard

So far the majority of the measurements of mineral oil saturated hydrocarbons (MOSH) and mineral oil aromatic hydrocarbons (MOAH) were obtained from on-line high performance liquid chromatography–gas chromatography–flame ionization detection (on-line HPLC–GC–FID). Since this technique is not available in many laboratories, an alternative method with more easily available tools has been developed. Preseparation on a small conventional liquid chromatographic column was optimized to achieve robust separation between the MOSH and the MOAH, but also to keep out the wax esters from the MOAH fraction. This was achieved by mixing a small portion of silica gel with silver nitrate into highly activated silica gel and by adding toluene into the eluent for the MOAH. Toluene was also added to the MOSH fraction to facilitate reconcentration and to serve as a keeper preventing loss of volatiles during solvent evaporation. A 50 μl volume was injected on-column into GC–FID to achieve a detection limit for MOSH and MOAH below 1 mg/kg in most foods.     

Suzuki–Miyaura coupling reactions of aryl chlorides catalyzed by a new nickel(II) σ‐aryl complex

A new nickel(II) σ‐aryl complex, trans‐chloro(9‐phenanthrenyl)bis(triphenylphosphine)nickel(II), was used as a precatalyst for the Suzuki–Miyaura coupling reactions of aryl chlorides. The catalytic conditions were optimized by investigating the cross‐coupling of p‐chloroanisole with phenylboronic acid. The results show that this complex is efficient for both electron‐rich and electron‐deficient aryl chlorides, though it gives better yields for activated arylboronic acids than deactivated ones. All isolated cross‐coupled biaryl products have been characterized by ¹H and ¹³C NMR, and their spectral data are consistent with those reported. Side products from the coupling of arylboronic acid with the precatalyst complex have also been isolated and characterized, which is helpful for understanding the coupling mechanism. Copyright © 2013 John Wiley & Sons, Ltd.     

A more convenient and general procedure for O-monobenzylation of diols via stannylenes: a critical reevaluation of the Bu2SnO method

A more consistent, straightforward, and economical protocol for generation of stannylene species and their reaction with BnBr leading to products of O-monobenzylation of diols has been set. It has shown to be specially indicated for substrates bearing vicinal trans 1,2-diol moieties on cyclohexane backbones, which are more resistant to these transformations. Such protocol has been successfully applied to myo-inositol derivatives and acyclic diols.     

Simulation of aerated lagoon using artificial neural networks and multivariate regression techniques

The aim of this study was to develop an empirical model that provides accurate predictions of the biochemical oxygen demand of the output stream from the aerated lagoon at International Paper of Brazil, one of the major pulp and paper plants in Brazil. Predictive models were calculated from functional link neural networks (FLNNs), multiple linear regression, principal components regression, and partial least-squares regression (PLSR). Improvement in FLNN modeling capability was observed when the data were preprocessed using the PLSR technique. PLSR also proved to be a powerful linear regression technique for this problem, which presents operational data limitations.     

Oxygen Isotope Labeling Experiments Reveal Different Reaction Sites for the Oxygen Evolution Reaction on Nickel and Nickel Iron Oxides

Nickel iron oxide is considered a benchmark nonprecious catalyst for the oxygen evolution reaction (OER). However, the nature of the active site in nickel iron oxide is heavily debated. Here we report direct spectroscopic evidence for the different active sites in Fe‐free and Fe‐containing Ni oxides. Ultrathin layered double hydroxides (LDHs) were used as defined samples of metal oxide catalysts, and ¹⁸O‐labeling experiments in combination with in situ Raman spectroscopy were employed to probe the role of lattice oxygen as well as an active oxygen species, NiOO^?, in the catalysts. Our data show that lattice oxygen is involved in the OER for Ni and NiCo LDHs, but not for NiFe and NiCoFe LDHs. Moreover, NiOO^? is a precursor to oxygen for Ni and NiCo LDHs, but not for NiFe and NiCoFe LDHs. These data indicate that bulk Ni sites in Ni and NiCo oxides are active and evolve oxygen via a NiOO^? precursor. Fe incorporation not only dramatically increases the activity, but also changes the nature of the active sites.