Stability criteria for positive linear discrete-time systems

Positivity - We prove new characterisations of exponential stability for positive linear discrete-time systems in ordered Banach spaces, in terms of small-gain conditions. Such conditions have...     

Development of a quantitative FI-MS technique for the characterization of high- and nonboiling saturated hydrocarbon mixtures

Summary Using a saturated non-boiling hydrocarbon mixture, the influence of two parameters on the results of field ionization mass spectrometry (FI-MS) measurements was studied: (a) the potential difference between the FI emitter and the counterelectrode; (b) the emitter temperature.Variation of the potential difference had only a minor effect on the average molecular mass measured and had no evident effect on the relative ring number distribution in the sample. In contrast, when the emitter temperature was increased, higher average molecular masses were recorded. Moreover, the average molecular masses shifted to higher ring numbers. In order to control the relationship between the described influences during mixture analysis, measuring instructions have been developed that enable the quantitative analysis of unknown saturated samples. However, average molecular mass of the mixture must be known.

---

Entwicklung einer quantitativen FI-MS-Methode zur Charakterisierung von gesättigten hoch- und nichtsiedenden Kohlenwasserstoffgemischen

     

Influence of organic modifiers on morphology and crystallization of poly(ϵ‐caprolactone)/synthetic clay intercalated nanocomposites

ε‐caprolactone was polymerized in the presence of neat montmorillonite or organomontmorillonites to obtain a variety of poly(ε‐caprolactone) (PCL)‐based systems loaded with 10 wt % of the silicates. The materials were thoroughly investigated by different X‐ray scattering techniques to determine factors affecting structure of the systems. For one of the nanocomposites it was found that varying the temperature in the range corresponding to crystallization of PCL causes reversible changes in the interlayer distance of the organoclay. Extensive experimental and literature studies on this phenomenon provided clues indicating that this effect might be a result of two‐dimensional ordering of PCL chains inside the galleries of the silicate. Small angle X‐ray scattering and wide angle X‐ray scattering investigation of filaments oriented above melting point of PCL revealed that polymer lamellae were oriented perpendicularly to particles of unmodified silicate, while in PCL/organoclay systems they were found parallel to clay tactoids. Calorimetric and microscopic studies shown that clay particles are effective nucleating agents. In the nanocomposites, PCL crystallized 20‐fold faster than in the neat polymer. The crystallization rate in nanocomposites was also significantly higher than in microcomposite. Further research provided an insight how the presence of the filler affects crystalline fraction and spherulitic structure of the polymer matrix in the investigated systems. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2350–2367, 2007     

Photoreactions of benzonitrile with cyclic enol ethers

Upon irradiation, cyclic enol ethers such as 1-methoxy-cyclopentene (4) mainly add across the cyano group of benzonitrile (1), under formation of 2-azabutadienes of an imidoester type. This is in agreement with the so-called Δ G-correlation which was reported earlier (ref. 5 and 6). 4-Phenyloxazole (9) is formed from 1 and 1,3-dioxole (5) probably by a similar photochemical process followed by electrocyclic ring opening and hydrolysis. The low yield of the latter photoreaction and the almost exergonic electron transfer between 5 and 1 may point to back electron transfer as the main energy wasting process. From 1 and 2,3-dihydrido-furan (2) only the ortho cycloadduct 6 has been isolated in low yields.     

Kreiszylindrische Behälter auf nachgiebiger Unterlage

Ohne Zusammenfassung