Effects of annealing treatment on the properties of MEH-PPV/titania hybrids prepared via in situ sol-gel reaction

A uniform poly[2-methoxy-5-(2′-ethylhexyloxy)-p-phenylenevinylene] (MEH-PPV)/titania hybrid film was successfully prepared by an in situ sol-gel reaction of titanium isopropoxide (TIP) in the presence of MEH-PPV/2-chlorophenol solution. The annealing treatment increased the conversion of TIP to titania as determined from evidence of the formation of Ti-O-Ti bonds in the Fourier transform infrared (FTIR) spectrum. Scanning electronic microscope (SEM) photographs showed that the morphology and distribution of titania in the hybrid film were strongly related to the amount of water in the in situ sol-gel reaction. The thermal stability of MEH-PPV/titania hybrids was enhanced by the annealing treatment. Small angle X-ray scattering (SAXS) and X-ray diffraction (XRD) analyses indicated that annealing treatment promoted the ordered aggregation of the MEH-PPV chains and crystallization of titania to a certain extent. The blue shift in Ultraviolet-visible (UV-vis) absorption of pure MEH-PPV after annealing was ascribed to the small extent of decomposition and coil conformation which occurred at high temperature. A more-obvious blue shift for the hybrids was observed, which resulted from irregular aggregation and coil conformation of the MEH-PPV chains induced by heterogeneous point, TIP (titania). The red shift in the photoluminescent (PL) emission for pure MEH-PPV resulted from a certain extent of ordered aggregation after annealing. However, only a slight red shift in the PL emission peak for the hybrids was found due to the hindrance of ordered aggregation of MEH-PPV chains in the presence of TIP (titania).     

Resonant effects in evanescent wave scattering of polydisperse colloids

Measurements and predictions are reported to understand large variations in evanescent wave (EW) scattering intensities between different particles from the same batch of single mode, polydisperse colloids. Measured EW scattering intensity distributions are obtained for three different micrometer sized latex particles irreversibly deposited onto glass surfaces. Predicted EW scattering intensity distributions are obtained using measured particle size distributions as input in a Mie theory for the three-dimensional scattering of a sphere under EW illumination. Good agreement is observed between measured and predicted EW scattering intensity distributions using no adjustable parameters. Our results indicate how finite polydispersity together with resonant effects produce large, nonlinear intensity variations between particles that appear to be physically and chemically uniform. Our findings allow such resonant effects to be understood and exploited in EW based particle-surface characterization techniques (e.g., using total internal reflections, surface plasmons) and chemical and biomolecular sensing applications (e.g., using whispering gallery modes).     

Synthesis of nano-sized TiO(2)/poly(AA-co-MMA) composites by heterocoagulation and blending with PET

Nano-sized TiO(2) or SiO(2)/TiO(2) particles were prepared by hydrolysis and condensation reactions in aqueous media, followed by mixing with poly(AA-co-MMA) latex to form different composites, then blending with poly(ethylene terephthalate), PET. The TGA results of composites indicated that negative charged latexes had greater interaction with TiO(2)/ or SiO(2)/TiO(2) particles through strong electrostatic forces, while cationic latexes incorporated with TiO(2) or SiO(2)/TiO(2) particles by pH induced coagulation, carbonyl group chelation and hydrogen bonding. The soapless latex polymer particles showed lower ability of adsorption to TiO(2) particles due to the decrease of total surface area of these larger particles. If SiO(2)/TiO(2) particles were used instead of TiO(2) particles, unexpected high adsorption result was observed. Morphology results observed by SEM showed that PET blended with positive charged composites was more homogeneous than PET blended with negative charged composites. DSC results also indicated that the T(g) of PET was increased, melting temperatures (T(m) or T(m)(')) were increased, and the temperature range of crystallization was narrowed after blending with the composites. The presence of composites affected the mobility and packing of PET molecular chains therefore changing the thermal properties of PET.     

Template-assisted assembly: scanning tunneling microscopy study of solvent-dependent adlattices of alkyl-derivatized tetrathiafulvalene

The self-assembly of an adsorbate as a function of the strength of solvent-substrate adsorption is an important yet relatively unexplored subject. In this study, how the strength of solvent-substrate adsorption and solvent-solvent attraction affects the assembly of tetrakis(octadecylthio)tetrathiafulvalene (1) is scrutinized by scanning tunneling microscopy (STM). For solvents with strong intermolecular interactions and adsorption onto graphite, such as long n-alkanes (C(n)H(2n+2), n ≥ 13), STM reveals that the solvent molecules form lamellae which become a template to direct the assembly of 1 into one-dimensional arrays. The lengths of one of the unit cell vectors for the assemblies are increased and well correlated with the solvent sizes. In situ STM monitoring of 1 introduced onto graphite with preadsorbed n-tetradecane adlattices shows that the developed assemblies of 1 have striped features aligned parallel to the underlying template. In contrast, for solvents with weak adsorption, such as short n-alkanes (C(n)H(2n+2), n ≤ 12), toluene, and 1,2,4-trichlorobenzene, the adlattice structures of 1 are solvent-independent.     

Double stranded polymeric ladderphanes with 16-π-electron antiaromatic metallocycle linkers

Three double stranded polymeric ladderphanes with 16-π-electron antiaromatic metallocycle linkers are synthesised by ring opening metathesis polymerisation of the corresponding bisnorbornene monomers. Scanning tunnelling microscopic (STM) images indicate that these polymers can assemble nicely on a graphite surface to form a highly ordered pattern which has been observed in other ladderphanes with different kinds of aromatic linkers. Little change in (1)H NMR, absorption spectra and electrochemical oxidation potential between these polymers and the corresponding monomers suggest that there would be no interactions between adjacent antiaromatic linkers in these polymeric ladderphanes. Presumably, the distance between two antiaromatic rings in these ladderphanes (5-6 ?) is far too long in comparison with that between two rings in methylene-bridged antiaromatic superphanes (2.5 ?<), where stabilisation is predicted by theoretical calculations.     

Specific ion-dependent attraction and phase behavior of polymer-coated colloids

This paper presents results demonstrating the role of temperature and specific ions in mediating attraction between polymer-coated colloids and determining their equilibrium phase behavior. In particular, theoretical predictions of continuum van der Waals attraction between poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) (PEO-PPO-PEO)-coated polystyrene colloids are used to explain measured temperature and specific ion-dependent fluid-gel transitions in dispersions of these particles. Building on previous studies of PEO-PPO-PEO-coated polystyrene colloids dispersed in aqueous NaCl media, this work reports rheologically measured fluid-gel transitions as a function of temperature and NaCl/MgSO4 composition. Adhesive-sphere predictions of percolation thresholds are fit to measured fluid-gel data by allowing the adsorbed copolymer layer thickness as a single adjustable parameter. This allows the attraction between the PEO-PPO-PEO layers to be interpreted as a function of temperature and NaCl/MgSO4 composition. Quantitative predictions of a polymeric van der Waals attraction associated with the layer collapse in diminishing solvent conditions provides a simple mechanism for explaining the measured fluid-gel data as a dynamic percolation transition. Ultimately, this work identifies the importance of continuum polymeric van der Waals attraction for explaining specific ion-dependent phenomena.     

Mapping patterned potential energy landscapes with diffusing colloidal probes

We report a new method for mapping patterned surfaces based on monitoring the interactions of freely diffusing colloidal probes with pattern features to generate measured potential energy landscapes. Evanescent wave scattering and video microscopy are used to track 3D center positions of nominal 2 microm silica colloids as they diffuse over 5-20-nm-thick patterned gold films. An analysis of ensemble-averaged particle height histograms on different pattern features using Boltzmann's equation produces local electrostatic and van der Waals potentials in good agreement with independent measurements and predictions. Absolute separation is obtained from theoretical fits to measured potential-energy profiles and direct measurement by depositing silica colloids onto gold surfaces via electrophoretic deposition. As colloidal probe and pattern feature dimensions become comparable, potential energy profiles suffer some distortion due to the increased probability of probes sampling pattern feature edges. An analysis of interfacial colloidal probe diffusion in conjunction with potential energy measurements demonstrates a consistent interpretation of dissipative and conservative forces in these measurements. Future extensions of this work should produce similar approaches for interrogating physical, chemical, and biomolecular heterogeneous/patterned surfaces and structures with diffusing colloidal probes.     

Cucurbitane triterpenoids from Momordica charantia and their cytoprotective activity in tert-butyl hydroperoxide-induced hepatotoxicity of HepG2 cells

Two novel pentanorcucurbitane triterpenes, 22-hydroxy-23,24,25,26,27-pentanorcucurbit-5-en-3-one (1) and 3,7-dioxo-23,24,25,26,27-pentanorcucurbit-5-en-22-oic acid (2) together with a new trinorcucurbitane triterpene, 25,26,27-trinorcucurbit-5-ene-3,7,23-trione (3) were isolated from the methyl alcohol extract of the stems of Momordica charantia. The structures of the new compounds were elucidated by spectroscopic methods. Compounds 2 and 3 showed potent cytoprotective activity in tert-butyl hydroperoxide (t-BHP)-induced hepatotoxicity of HepG2 cells.     

Amino acid derivatized carbon dots with tunable selectivity as logic gates for fluorescent sensing of metal cations

Carbon dots (CDs) modified with ethylene diamine (EDA) and the amino acids (AAs) Cys, His, Lys or Arg were synthesized, and their structures were confirmed by high resolution transmission electron microscopy, Raman spectrometry and X-ray photoelectron spectrometry. It is found that derivatization of the CDs with various AAs systemically modulates their electronic properties, and this results in a tunable selectivity in detection of metal cations via fluorescence quenching. The probes can be performed in aqueous solutions around pH 7. CDs can be excited under 345 nm excitation at room temperature and exhibit fluorescent peak at 450 nm. The decreasing fluorescence intensity is directly proportional to the concentration of metal cations. The limits of detection is 8.8 μg L^?1 for Pb(II), 20 μg L^?1 for Hg(II), 3.7 μg L^?1 for Cu(II), 5.3 μg L^?1 for Zn(II), 16 μg L^?1 for Fe(III), and 7.2 μg L^?1 for Cr(III), respectively. The different fluorescence response of the AA-modified CDs can be converted to logic gates and applied to photoelectronic nanoprobes by using microprocessors. In our perception, this assay has a large potential in terms of high-throughput screening for trace amounts of metal ions.

Open image in new window

Graphical abstract Amino acid derivatized carbon dots with tunable selectivity were synthesized by a one pot method for fluorescent sensing of metal cations. The sensing events can be directly converted into different logic gates.