Spatial Vector Solitons in Nonlinear Photonic Crystal Fibers

We study spatial vector solitons in a photonic crystal fiber (PCF) made of a material with the focusing Kerr nonlinearity. We show that such two-component localized nonlinear waves consist of two mutually trapped components confined by the PCF linear and the self-induced nonlinear refractive indices, and they bifurcate from the corresponding scalar solitons. We demonstrate that, in a sharp contrast with an entirely homogeneous nonlinear Kerr medium where both scalar and vector spatial solitons are unstable and may collapse, the periodic structure of PCF can stabilize the otherwise unstable two-dimensional spatial optical solitons. We apply the matrix criterion for stability of these two-parameter solitons, and verify it by direct numerical simulations.     

Mineralogical analysis of auriferous ores from the El Diamante mine, Colombia

X-ray diffraction (XRD), Mössbauer spectrometry (MS), secondary ions mass spectroscopy (SIMS) and laser-ablation microprobe–inductively coupled plasma–mass spectrometry (LAM–ICP–MS) were used to study mineral samples of Colombian auriferous ores collected from the “El Diamante” mine, located in the municipality of Guachavez-Nariño, in Colombia. The samples were prepared as polished thin sections and polished sections. From XRD data, quartz, sphalerite and pyrite were detected and their respective cell parameters were estimated. From MS analyses, pyrite, arsenopyrite and chalcopyrite were identified; their respective hyperfine parameters and respective texture were deduced. Multiple regions of approximately 200 × 200 μm in each sample were analyzed with SIMS; the occurrence of “invisible gold” associated mainly with pyrite and secondarily with arsenopyrite could thus be assigned. It was also found that pyrite is of the arsenious type. Spots from 30 to 40 μm in diameter were analyzed with LAM–ICP–MS for pyrite, arsenopyrite and sphalerite; Au is “homogeneously” distributed inside the structure of the arsenious pyrite and the arsenopyrite (not as inclusions); the chemical composition indicates similarities of this “invisible gold”, forming a solid solution with arsenious pyrite and arsenopyrite. One hundred nineteen and 62 ppm of ‘invisible gold’ was quantified in 21 spots analyzed on pyrite and in 14 spots on arsenopyrite, respectively.     

Analysis of Antennas with PBG Substrate

The use of photonic materials has been used in the theory of optical waves. The PBG (Photonic Band Gap) theory and material, was developed recently for optical frequencies and can be easily applied to millimeter waves, microwaves and planar antenna frequencies. The presence of photonic materials as substrate in antennas has some good characteristics such as, supression of light spontaneous emission and suppression of surface waves, allowing the application in planar antenna array. In this work an elaborate analysis using the full wave Transverse Transmission Line - TTL method, that provides efficient and concise results is applied to the planar antennas array with PBG substrate.     

Structure,Chirality, and Formation of Giant Icosahedral Fullerenes and Spherical Graphitic Onions

We describe the topology, structure, and stability of giant fullerenes exhibiting various symmetries (I, I _h , D _2h , T). Our results demonstrate that it is possible to create two new families of nested chiral icosahedral (I) fullerenes namely C₂₆₀@C₅₆₀@C₉₈₀@C₁₅₂₀@, ...,and C₁₄₀@C₃₈₀@C₇₄₀@C₁₂₂₀@ ..., which exhibit interlayer separations of ca. 3.4 Å. These chiral fullerenes are thought to possess metalliclike conduction properties. We discuss in detail the transformation of polyhedral graphitic particles into quasispherical nested giant fullerenes by reorganization of carbon atoms, which result in the formation of additional pentagonal and heptagonal carbon rings. These spherical structures are metastable and we believe they could be formed under extreme conditions, such as those produced by high-energy electron irradiation. There is circumstantial experimental evidence for the presence of heptagonal rings within these spherical fullerenes.     

A new cytokinin from the fruits of zantedeschiaaethiopica

A new purine derivative with cytokinin activity was isolated from the cuckoo-pint fruits ($\text{Zantedeschia}$$\text{aethiopica}$) and identified as 6-(o-hydroxybenzylamino)-2-methylthio-9-β-D-glucofuranosylpurine $\text{1}$.     

Glass forming ability and thermal stability in the system ZrF46BaF26PrF3

New glasses have been synthesized in the system ZrF₄6BaF₂6PrF₃. Glasses were prepared by conventional fusion method and the vitreous domain was established. For vitreous samples the thermal stability parameters were determined, so that the best compositions could be selected according to a compromise between high glass forming ability and thermal stability vs. crystallization.     

Flow injection system for hydrolysable tannin determination

A flow injection system was proposed to evaluate the transient product of a colorimetric reaction between hydrolysable tannin and potassium iodate (KIO₃) solution. The system optimization was accomplished by using statistical methods based on experimental design. Flow rate of KIO₃ solution, sample volume, carrier flow rate, and reaction coil were the selected factors for evaluation. On screening step, complete factorial 2⁴ was used and two levels for each selected factor were studied. For the optimization phase, a centered face composite design 2² + star was employed to evaluate sample volume and flow rate of KIO₃ solution, which were the factors identified in the screening phase as having more influence on the absorbance signal. After optimization, the proposed system was compared with batch determination. Some characteristics, such as analytical frequency, reagent consumption and chemical residues generation presented better results by the use of the proposed system if compared with batch method. The system presented good repeatability with standard deviation lower than 3%, for n = 10, linearity (R² = 0.9974) for tannic acid standard, analytical frequency of 15 injections h^− 1 and limit of quantification of 24 mg L^− 1 of tannic acid. Good results were obtained when the proposed system was applied to hydrolysable tannin determination in Stryphnodendron barbatimão, Eucalyptus citriodora and Phyllanthus niruri, samples of plants commonly used in popular medicine.     

31P NMR spectroscopy as a powerful tool for the determination of enantiomeric excess and absolute configurations of alpha-amino acids

An easy method for the determination of the enantiomeric excess (ee) of mixtures of alpha-amino acids, and also for the elucidation of the absolute configuration of each component of the mixture, is reported. The method is based on the formation of diastereoisomers by reaction of the enantiomerically pure acetylacetonate derivative [Pd(acac-O,O')(P(2)-dach)]ClO(4) (4) [P(2)-dach = (1R,2R)-C(6)H(10)(NHPPh(2))(2)] with d,l-mixtures of alpha-amino acids AaH (Pd:AaH = 1:1 molar ratio, refluxing MeOH). The reaction occurs with protonation of the acac ligand and N,O-coordination of the amino acidate group, giving the corresponding [Pd(Aa-N,O)(P(2)-dach)]ClO(4) complexes l-5 and d-6. The composition of these mixtures of amino acidate complexes was analyzed by integration of the corresponding peaks (four doublets, two for each diastereomer) in their (31)P((1)H) NMR spectra. A series of 14 alpha-amino acids was studied (a, alanine; b, 2-aminobutyric acid; c, valine; d, phenylalanine; e, proline; f, leucine; g, isoleucine; h, norleucine; i, serine; j, threonine; k, methionine; l, aspartic acid; m, glutamine; n, cysteine), and excellent agreement between the expected values of ee and those obtained from integration of the (31)P((1)H) NMR spectra was obtained. Moreover, the position of the signals of each isomer is diagnostic, in such a way that the outer doublets are always due to the l-derivatives 5a-l, while the inner ones are due to the d-derivatives 6a-l, allowing the assignation of absolute configurations to each isomer in the mixture.     

The carbon isotope composition of CO2 respired by trunks: comparison of four sampling methods

The (13)C natural abundance of CO(2) respired by plants has been used in the laboratory to examine the discrimination processes that occur during respiration. Currently, field measurements are being expanded to interpret the respiration delta(13)C signature measured at ecosystem and global levels. In this context, forests are particularly important to consider as they represent 80% of the continental biomass. The objective of this investigation was to compare four methods of sampling the CO(2) respired by trunks for the determination of its carbon isotope composition: three in situ methods using chambers placed on the trunk, and one destructive method using cores of woody tissues. The in situ methods were based either on a Keeling plot approach applied at the tissue level or on an initial flush of the chamber with nitrogen or with CO(2)-free air. In parallel, we investigated the possibility of an apparent discrimination during tissue respiration by comparing the delta(13)C signature of the respired CO(2) and that of the organic matter. The study was performed on six tree species widely distributed in temperate and mediterranean areas. The four methods were not significantly different when overall means were considered. However, considering the individual data, the Keeling plot approach and the nitrogen flush methods gave fairly homogeneous results, whereas the CO(2)-free air method produced more variable results. The core method was not correlated with any of the chamber methods. Regardless of the methodology, the respired CO(2) generally was enriched in (13)C relative to the total organic matter. This apparent enrichment during respiration was variable, reaching as much as 3-5 per thousand. This study showed that, on the whole, the different sampling techniques gave similar results, but one should be aware of the variability associated with each method.