Dynamic surface tension measurements of surfactant solutions using the maximum bubble pressure method – limits of applicability

One of the essential differences in the design of bubble pressure tensiometers consists in the geometry of the measuring capillaries. To reach extremely short adsorption times of milliseconds and below, the so-called deadtime of the capillaries must be of the order of some 10 ms. In particular, for concentrated surfactant solutions, such as micellar solutions, short deadtimes are needed to minimize the initial surfactant load of the generated bubbles. A theoretical model is derived and confirmed by experiments performed for a wide range of experimental conditions, mainly in respect to variations in deadtime and bubble volume.     

Gelation of poly(n-butylisocyanate) in benzene

Poly (n-butylisocyanate)-benzene solutions prepared by solubilization at 45°C, followed by aging at room temperature were found to be metastable for months, although, eventually, they separated into a birefringent polymer-rich phase and an isotropic solution. These metastable solutions, as well as isothermally phase-separated biphasic samples, flowed and exhibited dynamic moduli indicative of low polymer connectivity. By contrast samples prepared by a freeze-thaw cycle were uniformly and highly birefringent and showed network (gel) behavior at room temperature. The mechanism of gel formation is most likely the exclusion of the polymer from the benzene crystal during crystallization, forcing the polymer to align and exist at grain boundaries. Films formed from solutions have different moduli than those formed from gels, and are consistent with the proposed mechanism.     

Ion Flux from the Cathode Region of a Vacuum Arc

This paper reviews the properties of the cathode ion flux generated in the vacuum arc. The structure and distribution of mass erosion from individual cathode spots and the characteristics of current carriers from the cathode region at moderate arc currents are described. An appreciable ion flux (～10% of total arc current) is emitted from the cathode of a vacuum arc. This ion flux is strongly peaked in the direction of the anode, though some ion flux may be seen even at angles below the plane of the cathode surface. The observed spatial distribution of the ion flux is expressed quite well as an exponential function of solid angle. The ion flux is quite energetic, with average ion potentials much larger than the arc voltage, and generally contains a considerable fraction of multiply-charged ions. The average ion potential and ion multiplicity increase significantly for cathode materials with higher arc voltages, but decrease with increasing arc current for a particular material. The main theories concerning ion acceleration in cathode spots are the potential hump theory (PH), which assumes that all ions are created at the same potential, and the gas dynamic theory (GD), which assumes that all ions are created with the same flow velocity. Experimental data on the potentials and energies of individual ions indicates that these theories in their original forms are not quite correct, however extensions or modifications of the PH and GD theories seem very likely to be able to predict correct values for the charge states, potentials, and energies of individual ions.     

Evaluation of parameters critical to observing proteins inside living Escherichia coli by in-cell NMR spectroscopy

Our recently developed in-cell NMR procedure now enables one to observe protein conformations inside living cells. Optimization of the technique demonstrates that distinguishing the signals produced by a single protein species depends critically on protein overexpression levels and the correlation time in the cytoplasm. Less relevant is the selective incorporation of (15)N. Poorly expressed proteins, insoluble proteins, and proteins that cannot tumble freely due to associations within the cell cannot yet be observed. We show in-cell NMR spectra of bacterial NmerA and human calmodulin and discuss limitations of the technique as well as prospects for future applications.     

Comparison of diatomics-in-molecules and simple valence-bond potential surfaces for FH2

The method of diatomics-in-molecules (DIM) is applied to the FH₂ system. With spin—orbit interaction neglected, all elements of the 24 × 24 hamiltonian matrix are tabulated as analytic functions of the six diatomic fragment potential curves. It is found that neglect of off-diagonal 8 × 8 blocks in the DIM hamiltonian matrix leads to an energy expression for the ground 1 ²A′ level which is identical to the valence-bond formula used by Blais and Truhlar in dynamical studies of the F + D₂ reaction. The ²A″ excited level from DIM theory is identical to the result derived by Blais and Truhlar, without neglect of the 8 × 8 off-diagonal blocks. The DIM and simple valence-bond energies are compared numerically for noncollinear geometries.     

The bromination of 2-amino- and 2-acetylamino-4-(2-furyl)-thiazoles

The bromination of 2-amino-and 2-acetylamino-4-(2-furyl)thiazoles has been studied, and it has been shown that bromination takes place first in the furan ring and then, with an excess of bromine, also in the thiazole ring in position 5.