Characteristics of black carbon aerosol in Jiaxing,China during autumn 2013

We conducted measurements of black carbon（BC） aerosol in Jiaxing,China during autumn from September 26 to November 30,2013.We investigated temporal and diurnal variations of BC,and its correlations with meteorological parameters and other major pollutants.Results showed that hourly mass concentrations of BC ranged from 0.2 to 22.0 μg/m³,with an average of 5.1 μg/m³.The diurnai variation of BC exhibited a bimodal distribution,with peaks at 07:00 and 18:00.The morning peak was larger than the evening peak.The mass percentages of BC in PM_2.5 and PM₁₀ were 7.1%and 4.8%,respectively.The absorption coefficient of BC was calculated to be 44.4 Mm^-1,which accounted for 11.1%of the total aerosol extinction.BC was mainly emitted from local sources in southwestern Jiaxing where BC concentrations were generally greater than 11 μg/m³ during the measurement period.Correlation analysis indicated that the main sources of BC were motor vehicle exhaust,and domestic and industrial combustion.     

An effective interference suppression algorithm for visible light communication system based on DBSCAN

In order to improve the signal-to-noise ratio and mitigate the damage of noise to the communication quality,an effective interference suppression algorithm,which is based on the improved density-based spatial clustering of applications with noise algorithms,is proposed for visible light communication systems using the complementary metal–oxide–semiconductor image sensor as the receiver.Experimental results show that the algorithm can learn the region where the payload data is located,filter out the noise data,and greatly decrease the interference.The effect of the algorithm is also studied through bit error ratio performance.     

Optic Fiber Interferometer for Absolute Distance Measurement

1.IntroductionAbsolutedistancemeasurementisfarfromanewtopic.However,itisstillafieldstimulatinggreatinterestsnowadaysduetoitSimportantroleinmanufacturingandassembly['J.SincethegreatsuccessachievedbyMichelsonandBenoitwhentheyfirstdevelopedaninterferometertodeterminethestandardmeterintermsofthemonochromaticredcadmiumline,theopticinterferometerhasbeenprovedtobeoneofthemostpreciseandefficientwayindisplacementmeasurementbecauseofitshighdiscriminationandsimplestructure.However,thetraditionalinterfe…     

离心力场作用下多孔介质中强制对流换热的研究

对离心流化床中空气通过多孔物料层的强制对流换热进行了理论和实验研究。获得了气流和物料间强制对流换热的准则关联式。研究结果表明,在气流速度和温度梯度方向一致的条件下,强制对流换热比通常的边界层强制对流换热有所强化,其换热的准则关联式具有 Nu=CRePr的线性形式。从而验证了改变气流方向和热流密度矢量之间夹角可以强化换热的这一强化传热新原理。     

掺钕聚甲基丙烯酸甲酯的光学特性

研究了制备的掺钕螯合物Nd(DBM)3Phen材料的吸收光谱、激发光谱、荧光光谱,应用Judd-Ofelt理论计算了该材料的强度参量．分析了钕离子激发态4F3／2的辐射寿命(631 μs)和4F3／2→4IJ′跃迁的受激发射截面和荧光分支比．     

不同入射角度下强流脉冲电子束能量沉积剖面和束流传输系数模拟计算

 强流脉冲电子束在材料中的能量沉积剖面、能量沉积系数和束流传输系数受其入射角的影响很大，理论计算了0.5~2.0MeV的电子束以不同的入射角在Al材料中的能量沉积剖面和能量沉积系数，并且还计算了0.4~1.4MeV电子束以不同入射角穿透不同厚度C靶的束流传输系数。计算结果表明，随着入射角的增大，靶材表面层单位质量中沉积的能量增大，电子在靶材料中穿透深度减小，能量沉积系数减小，相应的束流传输系数也减小；能量为0.5~2.0MeV的电子束当入射角在60°~70°时在材料表面层单位质量中沉积的能量较大。     

A Promising MoO_x-based Catalyst for n-Heptane Isomerization

The increasing demand for higher-octane gasoline and the regulations limiting the amount of aromatics in the fuel motivate the interest in catalytic isomerization of n-alkanes. In the last ten years, transition metal oxides or oxycarbides based on molybdenum or tungstate have attracted much attention due to their high activity and isomerization selectivity compared to the conventional bifunctional supported platinum catalyst and high resistance to sulphur and nitrogen catalyst poisons1-5. Ma…     

纳米氧化钛-乙二醇溶胶溶液的研究

选用了钛酸丁酯、硬脂酸和乙二醇作为表面活性剂，采用表面化学修饰和表面物理修饰2种方法修饰纳米氧化钛，然后分散在乙二醇溶剂中形成溶胶溶液．并通过红外光谱仪、紫外分光计、原子力显微镜，分析了表面化学修饰后的纳米氧化钛表面化学结构的变化，观测了纳米氧化钛溶胶在乙二醇溶剂中稳定性．试验结果表明表面活性剂与纳米氧化钛的表面的不饱和键之间形成了新的化学结构，粒子表面可能接枝上有机长链，提高了纳米粒子在溶剂中的相容性．表面化学修饰后的纳米氧化钛与乙二醇溶剂形成了较稳定的溶胶体系，而且纳米溶胶粒径较小．表面活性剂添加量与纳米粒子添加量控制在(1～1．2)：1时，可以获得纳米溶胶粒径较小，同时溶胶稳定性较好的纳米氧化钛-乙二醇溶胶体系．