Lateral interactions in the thermal desorption of H2 from clean Cu/Ni(110) alloy surfaces

The adsorption of hydrogen on a clean Cu10%/Ni90% (110) alloy single crystal was studied using flash desorption spectroscopy (FDS), Auger electron spectroscopy (AES), and work function measurements. Surface compositions were varied from 100% Ni to 35% Ni. The hydrogen chemisorption on a-surface of 100% nickel revealed strong attractive interactions between the hydrogen atoms in accordance with previous work on Ni(100). Three desorption states (β₁, β₂ and α) appeared in the desorption spectra. The highest temperature (α) state was occupied only after the initial population of the β₂-state. As the amount of copper was increased in the nickel substrate, desorption from the higher energy binding α-state was reduced, indicating a decrease in the attractive interactions among hydrogen atoms. The hydrogen coverage at saturation was not affected by the addition of copper to the nickel substrate until the copper concentration was greater than 25% at which a sharp reduction in saturation coverage occurred. This phenomenon was apparently due to the adsorption of hydrogen on Ni atoms followed by occupation of NiNi and CuNi bridged adsorption sites, while occupation of CuCu sites was restricted due to an energy barrier to migration.     

Global expression analysis of CESA and CSL genes in Arabidopsis

We have used Affymetrix gene chips to measure the expression of 10 CESA and 29 CSL genes of Arabidopsis in different developmental stages or organs. These measurements reveal that many of the genes exhibit different levels of expression in the various organs. While several CESA genes are highly expressed in all the tissues examined, very few CSL genes approach such high levels of expression. This suggests that the CSL genes either encode enzymes for the synthesis of minor components of cell walls or are expressed only in specific cell types. The expression data also highlights the potential importance of the CESA genes for primary and secondary cell wall formation during different developmental stages and in the different organs examined.     

Light scattering by aggregates of magnetite nanoparticles in a magnetic field

The effect of variation of the scattered light intensity in a magnetic fluid with aggregates of magnetite particles several microns in size under the action of a magnetic field is studied. The effect relaxation times are determined when the magnetic field is turned on and off. This effect is found to be caused by the orientation of anisotropically magnetized aggregates. Experimental data are used to calculate the average anisotropy of the magnetic susceptibility of the aggregate and estimate its magnetic permeability.     

Kinetic and structural characterization of human manganese superoxide dismutase containing 3-fluorotyrosines

Incorporation of 3-fluorotyrosine and site-specific mutagenesis have been used with stopped-flow spectrophotometry and pulse radiolysis to investigate the catalytic properties of human manganese superoxide dismutase (MnSOD). All of the nine tyrosine residues in each of the four subunits of the homotetramer of human MnSOD were replaced with 3-fluorotyrosine. Previous studies showed that the crystal structures of the unfluorinated and fluorinated human MnSOD are nearly superimposable with the root-mean-square deviation for 198 -carbon atoms at 0.3 Å. However, the catalytic activity k_cat/K_m of the fluorinated MnSOD at 30 μM⁻¹ s⁻¹ was less than unfluorinated wild type at 800 μM⁻¹ s⁻¹. Comparison of the values of k_cat/K_m for fluorinated and unfluorinated wild-type andY34F MnSOD showed that this decrease for the fluorinated enzyme was in significant part due to 3-fluorotyrosine residues distant (>7 Å) from the active-site metal, not to 3-fluorotyrosine at position 34 close (5 Å) to the metal. Although many rate constants for the catalysis are decreased by this fluorination, the rate of dissociation of the product-inhibited complex appears unchanged by the presence of fluorinated tyrosines. These results suggest that Tyr34 is not a proton donor in the release of the product-inhibited complex, which involves protonation of a peroxo complex of the metal with release of hydrogen peroxide.     

Electric dipole moments of magnetite colloidal particles in liquid dielectrics

The effects of alternating and pulsed fields on the electric birefringence in a colloided system of magnetite particles suspended in kerosene are studied. The permanent dipole moment is found to substantially influence the orientation of magnetite particles in alternating fields with frequencies of higher than 15 Hz. The mechanism for the generation of the permanent dipole moments in magnetite colloidal particles suspended in low-conductivity liquids is discussed.     

Radiation-induced grafting of hexafluoroacetone to polyethylene

Although hexafluoroacetone is not polymerized by ionizing radiation, it is shown that γ-irradiation of hexafluoroacetone dissolved in polyethylene films produces a graft with a G value of 500 and, therefore, a kinetic chain length of 200. The effects of dose rate (0.021–3.55 Mrad/hr), temperature (21–53°C), and pressure (1.5–6.2 atm) on the graft rates have been measured. Also the effect of temperature (21–53°C) on the postirradiation grafting reaction and on the physical properties of the grafted films have been investigated. Together with solubility, diffusivity, infrared, and EPR data, the results lead to the following mechanism: The first step represents production of secondary alkyl radicals in the polyethylene by irradiation of the polymer–monomer system. The second step involves the linkage of the monomer to the radical site to form the alkoxy radical. Since it cannot add to another monomer unit, this radical abstracts a hydrogen atom from an adjacent polyethylene chain in the third step. Radical R· can then continue the kinetic chain. Radical combination and radical–impurity reactions terminate the chain. The graft may be unique in that it is the only one we have found in which a pendant group containing only one monomer unit is attached by a chain reaction. At dose rates up to 0.215 Mrad/hr, the grafting was linear with time and proportional to the 0.73 power of the dose rate at 21°C and to the 0.81 power at 53°C. The reaction is insensitive to increases in dose rate above 0.215 Mrad/hr where diffusivity measurements show the reaction to be diffusion-controlled. The rate of reaction increased 10% when the temperature was increased from 21 to 53°C. While there was significant postirradiation grafting reaction at 21°C, there was none at 53°C. The results do not fit the equations of reaction-controlled steady-state graft-polymerization kinetics. The deviations arise from an observed increase in monomer solubility in the film with increasing graft combined with low diffusivity of the monomer in polyethylene, and the presence of a radical-scavenging impurity which terminates the kinetic chain with the appearance of a relatively stable radical. EPR data suggests that the impurity is a trace of oxygen which may be produced radiolytically.     

Polymerization of diacetylenes by hydrogen bond templated adlayer formation

Adlayers were formed on self-assembled monolayers (SAMs) formed by alkanethiols on gold. Base SAMs exposing amide functional groups at the SAM surface were formed with 12-mercaptododecanamide. Adlayers of diacetylene-containing monomers were then formed via amide hydrogen bonding in decalin and decalin/toluene mixtures. Grazing angle FTIR, contact angle measurements, and ellipsometry suggest that these adlayer films exhibit ordering and packing similar to that of SAMs on gold. Resonance Raman spectroscopy showed that these diacetylene adlayers could be readily polymerized by exposure to UV light.