Determination of the degree of cure under dynamic and isothermal curing conditions with electrical impedance spectroscopy

This article presents a new methodology for the quantitative determination of the progress of the curing reaction of a thermosetting resin, using the results of electrical impedance spectroscopy. The method is an extension of the use of the imaginary impedance maximum as a reaction progress indicator and is based on the demonstration of a close correlation between the reaction rate, as measured by conventional differential scanning calorimetry, and the rate of change of the value of the imaginary impedance spectrum maximum. Tests on a commercial aerospace epoxy resin under both isothermal and dynamic heating conditions with calorimetry and impedance spectroscopy have demonstrated the validity of the method and set the accuracy limits involved. This technique can be used as a real-time online control tool for thermoset composite manufacturing. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 146–154, 2004     

Insight into chain dimensions in PEO/water solutions

Small‐Angle Neutron Scattering has been performed from poly(ethylene oxide) in deuterated water at temperature ranging from 10 to 80 °C. A simple fitting model was used to obtain a correlation length and a Porod exponent. The correlation length L characterizes the average distance between entanglements in the semidilute region and is proportional to the individual coil sizes in the dilute region. L was found to increase with temperature in the semidilute region but it decreases with temperature in the dilute region. This decrease is the precursor to the single‐chain collapse which applies to very dilute polymer solutions. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2196–2200, 2007     

Current Trend in Synthesis,Post‐Synthetic Modifications and Biological Applications of Nanometal‐Organic Frameworks (NMOFs)

Since the early reports of MOFs and their interesting properties, research involving these materials has grown wide in scope and applications. Various synthetic approaches have ensued in view of obtaining materials with optimised properties, the extensive scope of application spanning from energy, gas sorption, catalysis biological applications has meant exponentially evolved over the years. The far‐reaching synthetic and PSM approaches and porosity control possibilities have continued to serve as a motivation for research on these materials. With respect to the biological applications, MOFs have shown promise as good candidates in applications involving drug delivery, BioMOFs, sensing, imaging amongst others. Despite being a while away from successful entry into the market, observed results in sensing, drug delivery, and imaging put these materials on the spot light as candidates poised to usher in a revolution in biology. In this regard, this review article focuses current approaches in synthesis, post functionalization and biological applications of these materials with particular attention on drug delivery, imaging, sensing and BioMOFs.     

Simultaneous Two-Photon Activation of Type-I Photodynamic Therapy Agents

The excitation and emission properties of several psoralen derivatives are compared using conventional single-photon excitation and simultaneous two-photon excitation (TPE). Two-photon excitation is effected using the output of a mode-locked titanium: sapphire laser, the near infrared output of which is used to promote non-resonant TPE directly. Specifically, the excitation spectra and excited-state properties of 8-methoxypsoralen and 4′-aminomethyl-4,5,8-trimethylpsoralen are shown to be equivalent using both modes of excitation. Further, in vitro feasibility of two-photon photodynamic therapy (PDT) is demonstrated using Salmonella typhimurium. Two-photon excitation may be beneficial in the practice of PDT because it would allow replacement of visible or UV excitation light with highly penetrating, nondamag-ing near infrared light and could provide a means for improving localization of therapy. Comparison of possible laser excitation sources for PDT reveals the titanium: sapphire laser to be exceptionally well suited for nonlinear excitation of PDT agents in biological systems due to its extremely short pulse width and high repetition rate that together provide efficient PDT activation and greatly reduced potential for biological damage     

The synthesis and electrochemistry of CpTiCl2(OR) (R = alkyl, aryl) complexes

The syntheses of several new CpTiCl₂(OR) (R = alkyl, aryl) complexes are described. It was possible to isolate pure product when the R group is substituted such as to cause steric crowding at the metal centre; for example, particularly good yields of the phenolate complexes were obtained when there were isopropyl substituents in the 2 and 6 positions of the phenolate. Electrochemical studies of the complexes in dry THF show that the Ti^III complexes are relatively stable, but only a diol complex could be reduced further to a Ti^II species. In general, the Ti^IV complexes undergo a reversible 1e⁻ reduction reaction. The chemistry is more complex if the electrolyte contains added water: both the Ti^IV and Ti^III complexes can react with water, the OR group being replaced by OH. The reaction is particularly rapid for the Ti^III alkoxide complexes.     

Conversion of clavulanic acid into thiadeoxa nuclear analogues

1,4-Addition of sulphur nucleophiles to the diene ($\text{12}$) derived $\text{via}$ the pen-2-em ($\text{5}$) from clavulanic acid provides the thiadeoxa analogues ($\text{14}$–$\text{15}$). X-ray analysis of the ester ($\text{14}$) shows the thermodynamically stable isomers to have the same relative stereochemistry as clavulanic acid.     

Parabolic focal conics in self-assembled solid films of cellulose nanocrystals

Suspensions of cellulose nanocrystals form colloidal chiral nematic phases. The liquid crystalline order in these suspensions can be captured in solid films by slow evaporation of the liquid. Studies of the microstructure of such chiral nematic solid films revealed parabolic focal conic (PFC) defects, a symmetric form of focal conic defects in which the line defects form a pair of perpendicular, antiparallel, and confocal parabolas. The cellulose films with PFC defects were characterized by polarized-light and atomic force microscopy. The film surface showed a regular array of large and small elevations resulting from the displacement of the structural layers. Film fracture lines showed a series of layered half-cones. The microstructure of the films was modeled by computer. The model revealed that many structural layers terminate at the film surface.     

Hydrogen-bonded networks through second-sphere coordination

The reaction of 4, 7-phenanthroline (1) with aqueous transitionmetal complexes [Mn(H2O)6][NO3]2, [Co(H2O)6][NO3]2, [Ni(H2O)6[NO3]2, [Mn(H2O)6][ClO4]2, and [Co(H2O)6][ClO4]2 does not produce coordination complexes between these metal cations and the N-donor ligand as expected. Instead, supramolecular hydrogenbonded networks are formed between the nitrogen donor atoms of 4, 7-phenanthroline and the OH groups of coordinated water molecules: M-O-H...N interactions. This motif of second-sphere coordination for 1 can be exploited as a tool for crystal engineering. As a demonstration of the generality of this new interaction as a supramolecular building block, five X-ray crystal structures are reported that utilise this hydrogen bonding scheme; [Co(H2O)4(NO3)2].(1)2 (2a), [Co(MeCN)2(H2O)4][ClO4]2.(1)2 (2b), [Ni(H2O)4(NO3)2].(1)2 (3a), [Mn(H2O)4(NO3)2].(1)2 (4a), and [Mn(H2O)6][ClO4]2.(1)(4).4H2O (4b). Each network involves complete saturation of the hydrogen-bond donor sets between the aqua complex and 1 using primarily M-O-H...N(1) and M-O-H...O(anion), interactions. Thermogravimteric analysis shows these materials to have stabililities similar to coordination polymers involving metal-ligand bonds; this demonstrates that second-sphere hydrogen bonding has potential for the construction of polymeric metal-containing materials.     

The synthesis of N-substituted ketimines from oxazirdines

N-Unsubstituted diaryl, alkyl aryl and dialkyl ketimines are prepared in good yield at ambient temperature by the reaction of KOBu^t on oxaziridines having an α-hydrogen atom on the N-alkyl substituent; the mechanism and stereochemistry of the reaction are discussed.