Enantioselective Preparation of 2‐Aminomethyl Carboxylic Acid Derivatives: Solving the β2‐Amino Acid Problem with the Chiral Auxiliary 4‐Isopropyl‐5,5‐diphenyloxazolidin‐2‐one (DIOZ). Preliminary Communication

Multigram amounts of suitably protected β²‐amino acids with 17 of the 20 proteinogenic side chains are prepared by diastereoselective reactions of Li, B, or Ti enolates of the corresponding 3‐acyl‐4‐isopropyl‐5,5‐diphenyloxazolidin‐2‐ones (acyl‐DIOZ; 1 ) with appropriate electrophiles (amidomethylation, hydroxyalkylation, (benzyloxycarbonyl)methylation) in yields of 55–90% and with diastereoselectivities of 80 to >97% (Scheme). The primary products 2 – 8 thus obtained are converted to protected β²‐amino acids by standard procedures (Table 1). Many of the DIOZ derivatives are highly crystalline compounds (31 X‐ray crystal structures in Table 2). The chiral auxiliary DIOZ, readily prepared in either enantiomeric form, is recovered with high yield.     

Very general formation of tetrahydropterin cation radicals during reaction of iron porphyrins with tetrahydropterins: model for the corresponding NO-synthase reaction

Electron transfer from tetrahydropterins to iron porphyrins, with formation of intermediate tetrahydropterin cation radicals, is a very general reaction that was shown to occur not only with tetrahydrobiopterin, as originally found in NO-synthases, but also with another important biological cofactor, tetrahydrofolate, and various iron porphyrins, either in their ferric state, or in the Fe(II)O(2) state, as in the first model of the corresponding NO-synthase reaction described in this paper.     

Chemical modification of acetylcholinesterase with methoxypolyethylene glycol

Acetylcholinesterase (AChE) (EC 3.1.1.7) was modified with activated monomethoxypolyethylene glycol (mPEG). A decrease of 50% in the catalytic activity was measured during the coupling reaction and the change in the surface properties of AChE was used to separate by hydrophobic interaction chromatography the native and the modified enzyme. The native and the modified enzymes were found to have the same optimalcatalytic conditions. Moreover, the Michaelis constant of both enzymes were similar, whereas theV _m and the bimolecular-velocity constant calculated for organophosphorus inhibitors were slightly higher for the modified AChE. Finally, the modification with mPEG did not improve the thermal stability, whereas the stability in a few organic solvents increased.     

Collective behavior of Franck-Condon excited states and energy transfer in DNA double helices

Absorption of UV radiation by DNA bases is known to induce carcinogenic mutations. The lesion distribution depends on the sequence around the hotspots, suggesting cooperativity between bases. Here we show that such cooperativity may intervene at the very first step of a cascade of events by formation of Franck-Condon states delocalized over several bases and subsequent energy transfer faster than 100 fs. Our study focuses on the double helix poly(dA).poly(dT), whose fluorescence, induced by femtosecond pulses at 267 nm, is probed by the upconversion technique and time-correlated single photon counting, over a large time domain (100 fs to 100 ns). The time-resolved fluorescence decays and fluorescence anisotropy decays are discussed in relation with the steady-state absorption and fluorescence spectra in the frame of exciton theory.     

Straightforward Synthesis of 2‐Aryl‐1‐alkynylphosphonates and Arylpropiolates

A protocol for the direct cross coupling of trialkylsilyl‐alkynes bearing electron‐withdrawing groups and aryl halides using a Pd/Ag catalytic system is described. The procedure allows the straightforward synthesis of a variety of alkynylphosphonates and aryl propiolates derivatives in good yields.     

Development of SPME on-fiber derivatization for the sampling of formaldehyde and other carbonyl compounds in indoor air

Solid-phase microextraction on-fiber derivatization applied to carbonyl compounds is known, but application to indoor air is poorly developed and the methods deserve to be complemented and optimized. In this work, two derivatization reagents, pentafluorophenylhydrazine and o-2,3,4,5,6-(pentaflurobenzyl)hydroxylamine (PFBHA), and three fiber coatings were tested in order to select the best combination. As Carboxen-based coatings were proven to induce the formation of by-products during the thermal desorption step, a polydimethylsiloxane–divinylbenzene fiber in association with PFBHA was finally chosen. The study of the derivatization kinetics showed that the reaction of PFBHA with carbonyl compounds was instantaneous, except for acetone. Analyses were performed by gas chromatography coupled with flame ionization detection and mass spectrometry. For 5 min fiber exposure, the limits of detection are below 0.5 μg m^-3 in selected ion monitoring mode, the reproducibility was 15 % on average, and the linearity of the calibration curves was satisfactory. For on-site application, the influence of air humidity and the conditions in which the impregnated fibers were stored were studied. It is possible to store the fibers for 3 days before and for at least 2 days after sampling. The relative humidity of air was shown to have no influence on solid-phase microextraction sampling in the range from 0 to 70 %. For formaldehyde, the method was compared with sampling on 2,4-dinitrophenylhydrazine cartridges, and the first results showed good agreement. Finally, the method was applied to three different indoor environments to check its feasibility.     

Biomimetic Mussel Adhesive Inspired Anchor to Design ZnO@Poly(3‐Hexylthiophene) Hybrid Core@Corona Nanoparticles

The functionalization of zinc oxide (ZnO) nanoparticles by poly(3‐hexylthiophene) (P3HT) brush is completed by the combination of a mussel inspired biomimetic anchoring group and Huisgen cyclo‐addition “click chemistry.” Herein, the direct coupling of an azide modified catechol derivative with an alkyne end‐functionalized P3HT is described. This macromolecular binding agent is used to access core@corona ZnO@P3HT with a stable and homogeneous conjugated organic corona. Preliminary photoluminescence measurement proves an efficient electron transfer from the donor P3HT to the acceptor ZnO nanoparticles upon grafting, thus demonstrating the potential of such a combination in organic electronics.

     

NMR studies of interactions of new CB2 cannabinoid receptor ligands with cyclodextrins hosts. Correlation with micellar electrokinetic chromatography and reversed phase high performance liquid chromatography

Three selective CB₂ cannabinoid receptor ligands have recently been discovered to be promising anti-inflammatory agents but their low water solubility hinder their per os administration. The popularity of the cyclodextrins, from a pharmaceutical standpoint lies on their ability to interact with poorly water-soluble drugs and improve their solubility. Herein, three experimental approaches for calculating the stability constant of complexes between the selective CB₂ ligands and either the β-CD or the HP-β-CD, were tested: nuclear magnetic resonance, micellar electrokinetic chromatography and high performance liquid chromatography in reversed phase. In NMR studies the calculated K values were relatively high and were between 1486 and 3571 M^?1 with β-CD. With HP-β-CD they were between 1203 and 2650 M^?1. Concerning the two others techniques the K values were found lower. In MECK studies with β-CD they were between 308 and 792 M^?1 and with HP-β-CD between 124 and 764 M^?1. Finally in RP-HPLC studies with β-CD, they were between 539 and 1144 M^?1 and with HP-β-CD between 196 and 396 M^?1. These calculated constants suggest that a complexation phenomenon occurs. A model for inclusion of one of the CB₂ ligands in the β-CD was then proposed from molecular modeling studies.     

Click approaches in sol–gel chemistry

The combination of the copper-catalyzed alkyne-azide cycloaddition (CuAAC) reaction with sol–gel processing enables the versatile preparation of sol–gel materials under different shapes with targeted functionalities through a diversity-oriented approach. In this account, the development of the CuAAC reaction under anhydrous conditions for the synthesis of sol–gel precursors and for the assembling of magnetic nanoparticles on self-assembled monolayers is related, as well as the use of the classical CuAAC methodologies for the functionalization of mesoporous silica nanoparticles and microdots arrays. Coupling CuAAC and Sol–Gel will result in simplified preparations of multifunctional materials with controlled morphologies.