High-Average-Power Nanosecond Quasi-Phase-Matched Single-Pass Optical Parametric Generator in Periodically Poled Lithium Niobate

A pulsed nanosecond optical parametric generator (OPG) in periodically poled lithium niobate (PPLN) crysal is presented. The pump laser is an acousto-optically Q-switched Nd:YVO4 laser with the maximum average power of 6.58 W. When the repetition rate is 50kHz and the pulse width of the pump source is 80ns, the maximum average total output power of the single-pass PPLN OPG is about 1.9 W, which includes 1.322 W of 1.536μm signal radiation. The length of the PPLN crystal is only 38.7mm (at room temperature) with a grating period of 28.93μm (at room temperature). The 1.502-1.536μm signal radiation and 3.652-3.465μm idler radiation are obtained by adjusting the PPLN crystal temperature from 155℃ to 250℃.     

过氧聚钨酸薄膜上光栅的制备

用过氧聚钨酸（PPTA）水溶液，通过离心涂膜法在显微镜载玻片上制备了具有光滑表面且厚度为100nm的PPTA薄膜，利用PPTA薄膜在紫外光照下可研制光栅以及其它光学元件的薄膜材料，具有很高的利用价值。     

轴流泵端壁区域流动三维粘性数值计算

本文采用通用流场分析软件FLUENT,基于N-S方程,选用RNG κ—ε湍流模型与SIMPLEC算法,对轴流泵叶轮内部(及端壁间隙)流动进行了三维粘性数值计算。通过实验验证,表明数值计算结果和实测数据吻合较好。详细分析了叶顶附近流场形态以及叶轮出口轴向、周向速度分布,进行了性能预估。并给出了实验装置图。     

氯化钠在球形纳米氧化铈形成过程中的作用

以水合碳酸铈为原料, 以氯化钠作为助磨剂和阻聚剂, 采用机械活化法制备了球形纳米氧化铈, 用XRD法研究了水合碳酸铈与氯化钠质量比、球磨时间、煅烧温度对CeO2粉体晶粒度的影响, 用TEM对最终产物粒子进行形貌观察. 结果表明: 在碳酸铈的球磨过程及其随后的煅烧过程中, 氯化钠的存在起到了很好的助磨和阻聚作用, 所得CeO2为类球形粒子, 分散性较好, 晶粒度约为30～50 nm.     

分子诱导效应指数与链烷烃的沸点

利用基团的诱导效应指数，首次提出了分子的诱导效应指数的概念，并定义了 链烷烃的有效碳链长度NC＝（MIs,N/MIb,N)·N，式中MIs,N,MIb,N分别为直链和支 链异构体的分子诱导效应指数。研究结果表明，链烷烃的沸点Tb(℃）与NC关系是 ：1n(806.5-Tb)=6.9824-0.11431NC^2/3     

超临界流体萃取—胶束电动毛细管色谱法分离测定大黄中蒽醌类组 …

采用ＳＦＥ－ＭＥＣＣ法分离测定大黄中的芦荟大黄素，大黄素和大黄素。萃取条件为压力４１．４ＭＰａ，温度５０℃，改性剂量０．４ｍＬ。被测组分在１０ｍｉｎ得到全部分离。本法准确，简便，快速，结果令人满意。     

电化学氟化的新进展

电化学氟化是利用电极反应将氟直接引入有机或无机物的一种重要方法。有机物的电化学氟化方法有两种: 一是Simons于1941年发明的, 用镍作阳极, 在无水氟化氢溶液中, 电解制备全氟化合物的方法。此方法在近年来有不少改进。另一是1970年Rozhkov提出的, 以有机溶剂(如含Et3N.3HF的MeCN)为介质, 在铂阳极上,氧化得到单氟化产物的方法。本文全面地综述了这两种方法, 并着重于最新民发展。     

Synthesis of N-（α-Alkoxyalkyl）benzotriazoles Catalyzed by Acidic Ionic Liquid at Room Temperature

N-（α-Alkoxyalkyl）benzotriazoles were synthesized via the condensation of benzotriazole with various aldehydes and alcohols catalyzed by acidic ionic liquid [hmim]HSO4 at room temperature. The yield was up to 99%. This novel method was effective when triethoxymethane was utilized instead of alcohols. Moreover, acidic ionic liquid could be reused easily with no significant degradation of its catalytic activity.     

水合醋酸铈直接热分解制备超细氧化铈及其抛光性能

Ultra fine ceria was prepared by calcining hydrate cerium acetate. The effects of pyrolysis temperature on the particle size, morphology, specific surface area and loose packing density of ceria were investigated, and the removal rate of optical glasses polishing by ceria was determined. The results show that with the increase of pyrolysis temperature, the loose deposit density and crystallinity increases and the specific surface area decreases, however, the particle size decreases firstly and then increases, the minimum medium particle size D₅₀ is 0.47 μm at pyrolysis temperature of 1 000 ℃. The SEM images of ceria prepared by the decomposition at 800 ℃ or at 1 100 ℃ show porous powders or quasi-sphere small particles with loosely agglomeration, respectively. It was found that the removal rate varied with pyrolysis temperature in preparation of ceria and the property of glass polished. The removal rate for three kinds of glasses was in the order of ZF7> F1> K9, and the maximum value appeared at around 1 000 ℃ for ZF7 and F1, and at around 1 100 ℃ for K9.     

多氟代烃类的反应 Ⅱ.氟氯烯烃与三氯化铝的反应

Park等曾报道全氟丙烯与三氯化铝在50-60℃下反应,分离出一系列取代反应产物,并阐明其分子中氟氯基团与三氯化铝反应时的稳定性次序。Haszeldine等做了2,3-二溴全氟丙烯在三溴化铝存在下的重排反应,并提出了相应的重排机理。本工作以CFCl_2CF_2CF=CF_2(1)为原料与三氯化铝反应,通过试验找到在极温和反应条件下(三氯化铝与1的摩尔比为0.5,10℃下反应3h)获得几乎定量的重排产物CF_3CF_2CF=CCl_2(3),这一反应可用在三氯化铝催化下,1分子内烯丙位氟原子在分子内完成两次1,3-转移,从而使双键发生连续的烯丙型转移来解释.