Preparation and Tribological Behaviors of Lubricants—Oil Based on Modified Microbial Oil with Nano-Schiff Base Copper Complex

A W/O microemulsion reactor was used to prepare four kinds of modified lubricants: (i) modified lubricant 1, modified epoxidized microbial oil + rape oil in volume ratio of 1:1; (ii) modified lubricant 2, modified esterified microbial oil + rape oil in volume ratio of 1:3; (iii) modified lubricant 3, modified epoxidized rape oil; and (iv) modified lubricant 4, modified PAO. The individual modified lubricants were further modified with 0%, 0.5%, 1%, and 2% content of nano-Schiff base copper complex (nano-SBCC). A microtribometer was used to evaluate the friction coefficient between ball/flat point contacts immersed in the modified lubricants and operated in reciprocating and linear sliding mode. A comparison of the values of the friction coefficient with the lubricants further modified with nano-SBCC with those of their individual 0% nano-SBCC counterparts indicated significant decrease: (i) almost 19.18% was obtainable for the modified lubricant 1 with 2% of nano-Schiff base copper complex, (ii) almost 16.5% was obtainable for the modified lubricant 2 with 0.5% of nano-Schiff base copper complex; (iii) almost 7.42% was obtainable for the modified lubricant 3 with 1% of nano-SBCC; and (iv) almost 7.01% was obtainable for the modified lubricant 4 with 0.5% of nano-SBCC. These suggested that the addition of nano-Schiff base copper complex can efficiently decrease the friction coefficient of epoxidized or esterified microbial oil. Analyses of two-dimensional images, average profiles (across the mid-section y = 0 of the reciprocating sliding path), and three-dimensional topographies by confocal white light microscope for the worn surfaces of flats immersed in modified lubricant 1 and modified lubricant 2 suggested better wear-resistance of the modified lubricant 2 than that of the modified lubricant 1. The ability of wear resistance for the modified lubricant became better with the increasing content of nano-Schiff base copper complex from 0% to 2%. The study revealed the modification of epoxidized microbial oil + rape oil (1:1 volume ratio) and esterified microbial oil + rape oil (1:3 volume ratio) with Cu(II) chelate of bis(salicylaldehyde)ethylenediamine, reducing the magnitude of friction and wear because of their respective wear self-repairing ability. Such self-repairing ability furnishes the suitability of epoxidized microbial oil or esterified microbial oil to be effectively modified by nano-Schiff base copper complex and to substitute ordinary base oil as a mixture with rape oil.     

Microwave‐assisted extraction in combination with HPLC‐UV for quantitative analysis of six bioactive oxoisoaporphine alkaloids in Menispermum dauricum DC

A novel and reliable method based on microwave‐assisted extraction (MAE) followed by HPLC‐UV was developed and validated for the simultaneous quantification of six pharmacologically important oxoisoaporphine alkaloids in the total plants of Menispermum dauricum DC. The optimal MAE extraction condition was performed at 60°C for 11 min with ethanol–water (70:30, v/v) as the extracting solvent, and the solvent to solid ratio was 20:1. Chromatographic separation was achieved on a reversed‐phase YMC C₁₈ column (250 × 4.6 mm, i.d., 5 µm) with a gradient mobile phase consisting of A (1% aqueous formic acid) and B (acetonitrile containing 1% formic acid) at a flow rate of 1.5 mL/min. The detection wavelength was set at 422 nm. Excellent linearity over the investigated concentration ranges was observed with values of r >0.999 for all analytes. The method developed was validated with acceptable sensitivity, intra‐ and inter‐day precision and extraction recoveries. It was successfully applied to the determination of six alkaloids in Menispermum dauricum DC from different sources and different parts of Menispermum dauricum DC. The results obtained indicated that the method is suitable for the quality control of Menispermum dauricum DC. Copyright © 2015 John Wiley & Sons, Ltd.     

Discovery of Novel Non-Oxime Reactivators Showing In Vivo Antidotal Efficiency for Sarin Poisoned Mice

A family of novel efficient non-oxime compounds exhibited promising reactivation efficacy for VX and sarin inhibited human acetylcholinesterase was discovered. It was found that aromatic groups coupled to Mannich phenols and the introduction of imidazole to the ortho position of phenols would dramatically enhance reactivation efficiency. Moreover, the in vivo experiment was conducted, and the results demonstrated that Mannich phenol L10R1 (30 mg/kg, ip) could afford 100% 48 h survival for mice of 2*LD₅₀ sarin exposure, which is promising for the development of non-oxime reactivators with central efficiency.     

含氮杂环类润滑油添加剂CoMFA-QSTR及CoMSIA-QSTR抗磨损性能模型的构建

依据摩擦学定量构效关系理论(QSTR),采用比较分子力场分析(CoMFA)和比较分子相似性指数分析(CoMSIA)这两种方法研究了含氮杂环类润滑油添加剂的抗磨损性能的摩擦学三维定量构效关系(3D-QSTR),并建立了相应的3D-QSTR模型.结果表明:仅利用静电场构建CoMFA或CoMSIA模型时,模型预测能力最好,r~2,q~2均大于0.5.根据CoMFA或CoMSIA模型等高线图分析得出:分子静电场对含氮杂环类润滑油添加剂的抗磨损性能影响最大,在特定区域的引入带负电荷或带正电荷的基团将有助于抗磨性能的提高.     

DPD Simulation on the Transformation and Stability of O/W and W/O Microemulsions

The dissipative particle dynamics simulation method is adopted to investigate the microemulsion systems prepared with surfactant (H1T1), oil (O) and water (W), which are expressed by coarse-grained models. Two topologies of O/W and W/O microemulsions are simulated with various oil and water ratios. Inverse W/O microemulsion transform to O/W microemulsion by decreasing the ratio of oil-water from 3:1 to 1:3. The stability of O/W and W/O microemulsion is controlled by shear rate, inorganic salt and the temperature, and the corresponding results are analyzed by the translucent three-dimensional structure, the mean interfacial tension and end-to-end distance of H1T1. The results show that W/O microemulsion is more stable than O/W microemulsion to resist higher inorganic salt concentration, shear rate and temperature. This investigation provides a powerful tool to predict the structure and the stability of various microemulsion systems, which is of great importance to developing new multifunctional microemulsions for multiple applications.     

On the formation of hydrogen peroxide in water microdroplets

Recent reports on the formation of hydrogen peroxide (H₂O₂) in water microdroplets produced via pneumatic spraying or capillary condensation have garnered significant attention. How covalent bonds in water could break under such mild conditions challenges our textbook understanding of physical chemistry and water. While there is no definitive answer, it has been speculated that ultrahigh electric fields at the air–water interface are responsible for this chemical transformation. Here, we report on our comprehensive experimental investigation of H₂O₂ formation in (i) water microdroplets sprayed over a range of liquid flow-rates, (shearing) air flow rates, and air composition, and (ii) water microdroplets condensed on hydrophobic substrates formed via hot water or humidifier under controlled air composition. Specifically, we assessed the contributions of the evaporative concentration and shock waves in sprays and the effects of trace O₃(g) on the H₂O₂ formation. Glovebox experiments revealed that the H₂O₂ formation in water microdroplets was most sensitive to the air–borne ozone (O₃) concentration. In the absence of O₃(g), we could not detect H₂O₂(aq) in sprays or condensates (detection limit ≥250 nM). In contrast, microdroplets exposed to atmospherically relevant O₃(g) concentration (10–100 ppb) formed 2–30 µM H₂O₂(aq), increasing with the gas–liquid surface area, mixing, and contact duration. Thus, the water surface area facilitates the O₃(g) mass transfer, which is followed by the chemical transformation of O₃(aq) into H₂O₂(aq). These findings should also help us understand the implications of this chemistry in natural and applied contexts.

A. Gallo Jr, H. Mishra et al., pinpoint the origins of the spontaneous H₂O₂ formation in water microdroplets formed via spraying or condensation, i.e., without the addition of electrical energy, catalyst, or co-solvent.     

三相中空纤维式液相微萃取用于快速富集血浆中的尼古丁

建立了一种以三相中空纤维式液相微萃取(TP-HF-LPME)进行样品前处理,采用高效液相色谱快速、准确测定血浆中尼古丁含量的方法。研究表明该方法集萃取、富集、净化为一步,极大地简化了传统血浆成分测定的前处理过程,是一种快速、有效、绿色的前处理方法。方法的线性范围为0.1～50 mg/L,相关系数(r2)为0.9996,检测限为0.05 mg/L (信噪比为3),相对标准偏差小于5%。