Microstructure of laser melted Al18B4O33w/2024Al composite

The microstructure of a laser treated Al₁₈B₄O₃₃w/2024Al composite has been investigated using transmission electron microscope (TEM), low-angle (glancing angle) X-ray diffraction (XRD) techniques. Various surface microstructures were observed in the laser treated composite. The Al₁₈B₄O₃₃ whisker on the surface of the composite was decomposed during laser surface melting, various decomposition products were studied in the laser treated composite. Eutectic phases and the precipitation in the matrix of the composite with laser-treated were observed. The main phases detected in the molten zone were aluminum and decomposition products Al₂O₃. The effect of laser treatment on the hardness of the composite was also examined. A surface hardness of 400 Hv was noted.     

大焦深成像系统仿真实验研究

如何增大非相干光学成像系统的焦深是应用光学研究领域的热点问题.本文对采用高次非球面光学掩模板与图像处理相结合增大成像光学系统焦深的新方法进行了深入分析,建立了大焦深成像系统仿真实验模型,并进行了大焦深成像系统仿真实验.实验结果证明了该方法在维持原相对孔径的同时使光学系统在较大的离焦范围内有好的成像质量.实际应用中还要综合考虑模板参量、信噪比等关键因素.     

Pd (II)‐catalyzed vinyl addition polymerization of novel functionalized norbornene bearing dimethyl carboxylate groups

Three novel functionalized polynorbornenes (PNB) with pendant dimethyl carboxylate group (carboxylates—acetate, propionate, and butyrate) are synthesized as a vinyl‐type with a palladium (II) catalyst in high yield. The effects of size of substitutents, molar ratio of monomer to catalyst, solvent polarity, reaction time, and temperature on the polymerization of exo‐norbornene dimethyl propionate were systematically investigated. The low molar ratio and temperature, as well as high polarity of solvent, and long reaction time, are favorable for the enhancement of the monomer conversion, especially, the solvent have an obvious effect on the catalyst activity. The resulting poly(cis‐norbornene‐exo‐2,3‐dimethyl carboxylates) (PNB‐dimethyl carboxylates) show good solubility in common organic solvent and high thermal stability up to 360 °C. The glass transition temperature was detected by DMA at 331, 324, and 318 °C for acetate, propionate, and butyrate, respectively. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 3391–3399, 2007     

VOCs控制催化剂的研制

以堇青石蜂窝陶瓷体为第一载体、γ-Al2O3为第二载体,制成的含稀土La和过渡金属元素的复合氧化物催化剂,在连续流动的反应体系上评价了催化剂对苯、氰氢酸、乙酸和氯苯等VOCs的氧化反应活性.结果表明: 采用LaCuMn组合制备的催化剂,La的含量在7%～10%左右、Cu的含量在5.5%左右、Mn的含量在7.5%左右时,第二载体γ-Al2O3的负载以采用半胶、pH值4～5、加入某些活性剂、负载量以7%～10%、活化温度为400～500 ℃时制成的催化剂的活性最好,研制的VOCs控制催化剂对各种VOCs均具有很高的催化活性.     

Capillary electrophoresis with amperometric detection of curcumin in Chinese herbal medicine pretreated by solid-phase extraction

In the present study, curcumin from Chinese herbal medicine turmeric was determined by capillary electrophoresis with amperometric detection (CE-AD) pretreated by a self-designed, simple, inexpensive solid-phase extraction (SPE) cartridge based on the material of tributyl phosphate resin. An average concentration factor of 9 with the recovery of > 80% was achieved when applied to the analysis of curcumin in extracts of tumeric. Under the optimized CE-AD conditions: a running buffer composed of 15 mM phosphate buffer at a pH 9.7, separation voltage at 16 kV, injection for 6 s at 9 kV and detection at 1.20 V, CE-AD with SPE exhibited low detection limit as 3 x 10(-8) mol/l (S/N = 3), high efficiency of 1.0 x 10(5) N, linear range of 7 x 10(-4) -3 x 10(-6) mol/l (r = 0.9986) for curcumin extracted from light petroleum. The method developed resulted in enhancement of the detection sensitivity and reduction of interference from sample matrix in complicated samples and exhibited the potential application for routine analysis, especially in food, because a relatively complete process of sample treatment and analysis was described.     

Thermal characterization and thermal degradation of poly(norbornene-2,3-dicarboxylic acid dialkyl esters) synthesized by vinyl addition polymerization

The thermal properties and degradation behaviors of poly(norbornene-2,3-dicarboxylic acid dialkyl esters) (PNB-dialkyl esters) (alkyl = Me (PNB-Me), Et (PNB-Et), Pr (PNB-Pr), and Bu (PNB-Bu)) were investigated by thermogravimetric analysis (TGA) in dynamic conditions and by infrared (IR) spectroscopy. The PNB-dialkyl esters show good thermal stability up to 350 °C, and the thermal stability decreases in the order Me > Et > Pr > Bu with the increase in size of side chain. The effect of side-chain size on the thermal degradation behaviors of PNB-dialkyl esters is evidenced by one-step thermal degradation profile for PNB-Me while two-step thermal degradation profile for PNB-Et, PNB-Pr, and PNB-Bu. Transformation is deduced to undergo β-hydrogen elimination and formation of anhydride group in the first stage of thermal degradation reaction according to TGA and IR results for PNB-Et, PNB-Pr, and PNB-Bu. The apparent activation energy and thermal degradation model of PNB-dialkyl esters are estimated by means of Ozawa-Flynn-wall method and Phadnis-Deshpande method, respectively.     

Synthesis and biological activities of hydroxyl-protected fluorine-containing 4,4-dihydroxylmethyl-2-aryl-iminothiazolidines

Eight novel compounds were synthesized by a facile and mild method with high yields, and the structures of all the compounds were characterized by ¹H NMR IR mass and high resolution mass spectroscopy. Their inhibitory activity against insect-flight and trehalase in vitro were screened. Some target compounds have moderate inhibitory activity against trehalase, and show inhibition action to insect-flight.     

The evolution of morphology of ordered porous TiO2 films fabricated from sol-gel method assisted ZnO nanorod template

Ordered porous TiO₂ films, including TiO₂ nanotube arrays, are fabricated by a sol-gel dip-coating approach via ZnO nanorod templates obtained from aqueous solution approach. The results indicate that the morphologies of ordered porous TiO₂ films have been great affected by the sol-gel dip-coating cycle number. Open-ended TiO₂ nanotube arrays can be obtained in optimum dip-coating cycle numbers. The TiO₂ nanotubes with the inner diameter matching well with the diameters of ZnO nanorods, are well assembled and separate each other. When the cycle number is less than this optimum value, no intact porous TiO₂ film can be obtained. As the cycle number is larger than this optimum value, an ordered porous TiO₂ film with many throughout holes is formed. The evolutive mechanism of ordered porous TiO₂ films is proposed.     

碳点增强的Ru纳米颗粒复合材料用于碱性条件下高效电解水析氢

In the 21st century, hydrogen energy is a novel energy source. Its use is expected to mitigate the problems of environmental pollution and global warming caused by the excessive use of conventional fossil fuels. The hydrogen evolution reaction (HER) for water splitting has attracted considerable attention because of its environmental friendliness. To improve electrocatalyst performance and reduce operation cost, carbon-based metal hybrid materials exhibiting high efficiency and catalytic activity have been developed. Among them, carbon dots (CDs) have garnered significant research attention and have been widely applied in biosensing, bioimaging, and energy conversion/storage because of their facile synthesis, biocompatibility, tunable photoluminescence, excellent stability, and good electronic properties. CDs are widely used as carriers in the construction of electrocatalysts prepared from carbon-based metal hybrid materials. At present, it is believed that CDs exhibit excellent confinement effects, which can effectively inhibit the growth and agglomeration of metal nanoparticles, thereby preparing well-distributed carbon-based metal hybrid materials with a uniform and controllable size. However, the formation process of the small-molecule raw materials of CDs has not been elucidated. In this study, CDs and small-molecule raw materials from synthetic CDs were used as precursors to prepare nitrogen-doped CD-supported ruthenium nanoparticle (Ru@CDs) and small-molecule-supported ruthenium nanoparticle (Ru@Molecule) hybrid materials, respectively. The interaction between the small molecules and Ru in the process of CD formation and the effect on HER performance were explored. Moreover, we prepared different carriers such as metal organic frameworks(MOF), carbon nanotubes (CNTs), and graphene (GO)-supported ruthenium nanoparticle hybrid materials. Among them, Ru@CDs exhibited controllable size and excellent dispersibility and exhibited outstanding HER activity and good stability. Ru@CDs were found to require a low overpotential of 22 mV to reach a current density of 10 mA·cm⁻². Moreover, we observed the presence of an intermediate state between the molecules and CDs and demonstrated that the intermediate state exhibits no confinement effect. Furthermore, we found that with increasing calcination temperature, the intermediate state gradually changes to CDs. The unique spatial confinement between CDs and metal ions is key to the formation of monodisperse Ru nanoparticles. Our results confirmed that Ru@CDs serve as excellent HER catalyst supports. This work not only reveals the effect of the unique spatial confinement of CDs on the supported metals and their promoting effect on electrocatalytic activity but also provides guides the future development of CD-based metal hybrid electrocatalysts.     

Large-scale synthesis and microstructure of SnO2 nanowires coated with quantum-sized ZnO nanocrystals on a mesh substrate

Large-quantity single-crystal SnO(2) nanowires coated with quantum-sized ZnO nanocrystals (nc-ZnO/SnO(2) nanowires) were directly synthesized by thermal evaporation of SnO powder and a mixture of basic ZnCO(3) and graphite powders. A common stainless steel mesh was used to collect the products. The microstructure and possible growth mechanism of the nc-ZnO/SnO(2) nanowires were investigated. Results showed that tetragonal structured SnO(2) nanowires were obtained, whose surfaces were coated with single-layer ZnO nanocrystals with an average diameter of less than 5 nm. The nanowires had cross-rectangle section with width-to-thickness aspect ratio ranging from 2:1 to 5:1. The lengths of the nanowires were several tens of micrometers. ZnO nanocrystals were single crystalline wurtzite structures, which coated the whole nanowires and distributed uniformly. The possible growth mechanism of the composite nanowires may be enucleated that Zn atoms in the source vapor will replace the Sn atoms on the surface of the formed SnO(2) nanowires due to the higher reducibility of Zn than Sn. Two strong Raman scattering peaks at 626 and 656 cm(-1) appeared in the micro-Raman spectrum of nc-ZnO/SnO(2) nanowires. The origins of the peaks were discussed. Most importantly, the method can be extended to other composite oxide nanowires that are synthesized by oxidizing two kinds of metals, such as high reducibility elements Mg, Al, Zn, and Ti, and low reducibility elements In, Ge, Ga, etc.