Hyaluronic acid-copper(II) complexes: Spectroscopic characterization

Hyaluronic acid-copper(II) complexes were studied by ultraviolet and electron spin resonance spectroscopy (ESR), as well as by rheological measurements. Spin-Hamiltonian parameters were obtained from experimental spectra measured at 200 K by non-linear optimization method. These showg _x g _y <g _z and indicate the ground electronic state of copper ion, which is characteristic for carboxylato-copper(II) complexes. The non-axial symmetry of theg-tensor suggest rhombic crystal field symmetry. Formation of HA-Cu(II) complex is realized through the interaction of copper ions with carboxyl groups of the HA macromolecule. This complex is characteristic of the network-like rheological properties of its aqueous solution.     

Influence of the variable wall thickness of the sample tubes and a quartz Dewar on the EPR signal intensity in a single TE102 and double TE104 rectangular cavity

The response of a single TE₁₀₂ and double TE₁₀₄ rectangular cavity to the insertion of samples contained in tubes with variable wall thickness and a quartz Dewar into the cavity has been analyzed. A direct, indirect, and concurrent (positive or negative) “lens effect” inside the double TE₁₀₄ rectangular cavity is discussed. The experimental dependence of the EPR signal intensity on the wall thickness of the sample tube, δ, for the line-like samples with identical length of the sample material column, L=30 mm, recorded in the microwave cavity showed a directly proportional increase of the relative “lens effect” with the increase of the wall thickness of the tube in the interval, δ∈<0.1 mm, >0.5 mm. The insertion of the variable-temperature double-wall quartz Dewar (home-built, resonant frequency shift, ca. −300 MHz) into the single TE₁₀₂ rectangular cavity showed the same relative “lens effect”, with ca. 1.5-time increase of the EPR signal intensity, for a point-like sample and the line-like samples with material columns of diameter of 1 and 1.3 mm, and wall thickness of the sample tubes, δ∈<0.1 mm, >0.5 mm. The increased effect of the Dewar arises because the active volume of the quartz Dewar tube walls is always much more larger than the active volume of the sample tube wall. In the case of the double TE₁₀₄ rectangular cavity, the insertion of the quartz Dewar: (i) into the same cavity, in which the sample is present, caused a direct “lens effect”, with ca. 1.8-fold increase of the EPR signal intensity; however, (ii) into the complementary cavity, in which the sample is absent, caused an indirect “lens effect”, with ca. 0.6-fold decrease of the EPR signal intensity. With the Dewar and sample in one cavity and a large empty sample tube in the complementary cavity, a concurrent (positive or negative) “lens effect” can be observed. Thus, the possible increase/decrease of the EPR signal intensity depends on the volume ratio of the quartz Dewar tube walls and large sample tube wall inserted into the double TE₁₀₄ rectangular cavity. Each of the above phenomena may be a significant source error in quantitative EPR spectrometry unless the samples to be compared in the quantitative EPR analysis are contained in sample tubes having the same wall thickness and each EPR spectra should be recorded inside an identical quartz Dewar.     

Supramolecular dimer formation through hydrogen bond extensions of carboxylate ligands – Path for magnetic exchange

A new complex of unusual composition [Cu(3-O₂Nbz)₂(nia)(H₂O)₂] (1) (nia = nicotinamide, 3-O₂Nbz = 3-nitrobenzoate) has been prepared and studied together with two other complexes of composition [Cu(4-O₂Nbz)₂(nia)₂(H₂O)₂] (2) and [Cu(4-O₂Nbz)₂(nia)₂]?(4-O₂NbzH)₂ (3) (4-O₂Nbz = 4-nitrobenzoate). The composition of all complexes has been determined by elemental analysis, the complexes have been studied by electronic, infrared and EPR spectroscopy, as well as by magnetization measurements over the temperature range 1.8–300 K, and their structures have been solved. The structure of complex (1) consists of molecules, where Cu(II) atom is monodentately coordinated by the pair of 3-nitrobenzoato anions in trans  -positions together with water and nicotinamide molecules, forming nearly tetragonal basal plane, and by another water molecule in axial position of tetragonal-pyramidal coordination polyhedron. The neighboring molecule coordination polyhedron basal planes are coplanar and allow formation of supramolecular dimers with strong H-bonds between hydrogen atoms from equatorially coordinated water molecules and uncoordinated carboxylate oxygen atoms thus giving the nearest Cu?$?$Cu distance of 4.886(2) Å. Magnetization measurements showed that complex (1) exhibits maximum of magnetic susceptibility at 6.5 K and a fit to Bleaney-Bowers equation gave singlet–triplet energy gap 2J = −6.25 cm⁻¹, and zJ′ = −0.03 cm⁻¹. This might be an experimental proof that the carboxylate bridges extended with hydrogen bonds are the pathway of the spin–spin interactions. The temperature dependence of changes in EPR spectra of (1) and the spectrum at 4.2 K have confirmed its hydrogen bonded dimeric structure. The calculated Cu?$?$Cu distance 4.8 Å is in very good agreement with the value obtained from crystal structure. The complexes (2) and (3) at 300 K exhibit magnetic moment μ_eff = 1.98 B.M. and μ_eff = 1.84 B.M., respectively. These values practically do not change with lowering the temperature up to 5 K and only small drops to μ_eff = 1.87 B.M. (for (2)) and μ_eff = 1.79 B.M. (for (3)) at 1.8 K have been observed. The EPR spectra of complex (2) at room temperature as well as at 77 K are of axial type with g_⊥ = 2.062 and g_|| = 2.285 and exhibit resolved parallel hyperfine splitting with A_|| = 160 Gauss. The EPR spectra of complex (3) at room temperature as well as at 77 K are of axial type with g_⊥ = 2.065 and g_|| = 2.235 and exhibit unresolved parallel hyperfine splitting. EPR spectra of (2) and (3) are consistent with the X-ray structure.     

A systematic study of the hydration and drying process of silica xerogels using Cu(II) EPR spectroscopy

Journal of Sol-Gel Science and Technology - The influence of the hydration and drying process on the line shape and signal intensity of the electron paramagnetic resonance spectra recorded from...     

Valuation of the Extraocular Effective Elastance on the Base of Dynamical Model

This paper makes an attempt to answer the question for the effective (functional) value of extraocular elastance. Here, this question is connected with the problem of rhythmicity mechanism of nystagmus phenomena. A likely dynamical model of the nystagmus horizontal motion is proposed by application of the energy and moment of momentum conservation laws to the extraocular muscle. The model is investigated qualitatively and numerically on the base of existing experimental data in the literature. On the base of analysis of obtained results a hypothesis is formulated that the nystagmus horizontal motions present self-oscillations of the considered system.     

Principal component analysis of kinetic models

An eigenvalue–eigenvector analysis is used to extract meaningful kinetic information from linear sensitivity coefficients computed for several species of a reacting system at several time points. The main advantage of this method lies in its ability to reveal those parts of the mechanism which consist of strongly interacting reactions, and to indicate their importance within the mechanism. Results can be used to solve three general kinetic problems. Firstly, an objective condition for constructing a minimal reaction set is presented. Secondly, the uncovered dependencies among the parameters are shown to confirm or deny validity of quasi-steady-state assumptions under the considered experimental conditions. Thirdly, taking into account only sensitivities of observed species, the analysis is used to yield error estimates on unknown parameters determined from the experimental observations, and to suggest the parameters that should be kept fixed in the estimation procedure. To illustrate we chose the well-known hydrogen–bromine reaction and the kinetics of formaldehyde oxidation in the presence of CO.     

Kinetic study of dissolution of poly(vinyl chloride) in cyclohexanone

The kinetics of dissolution of five fractions of commercial poly(vinyl chloride) in cyclohexanone was studied at temperatures from 20 to 70°C. Good agreement was observed between the experimental results and equations expressing the dependence of the induction periods and the rates of dissolution on temperature and molecular weight. It was found that the apparent activation energy for the swelling process lies in the range 9–14 kcal/mole and the apparent activation energy for the dissolution diffusion process in the range 8–12 kcal/mole. The apparent dependence of activation energies on number-average molecular weight indicates that the chain ends are more important in determining the dissolution rate than the centers of the polymer chains.     

Structure and properties of Co-Ni-Fe coatings deposited electrolytically in the X-Ray irradiation

The main processes governing the formation of Co-Ni-Fe alloys electrolytically deposited in the X-ray irradiation have been discussed. It has been found that the electrical and magnetic properties depend on the deposition and irradiation regimes. The factors responsible for the variation in the electrical resistivity and specific magnetization of the films prepared by electrolytic deposition, which are caused by variations in the surface morphology, elemental composition, decrease in the porosity, and increase in the electrolytical deposition rate under X-ray irradiation, have been considered.     

Structural study and magnetic properties of copper(II) thiophene-2-carboxylate with 4-pyridinemethanol and isonicotinamide

The synthesis and characterization of [Cu(5-Me-2-tpc)₂(4-pyme)₂] (I), [Cu(3-Me-2-tpc)₂(4-pyme)₂] (II), [Cu(2-tpc)₂(4-pyme)₂] (III), [Cu(2-tpc)₂(isonia)₂(2-tpcH)] (IV), [Cu(5-Me-2-tpc)₂(isonia)₂(5-Me-2-tpcH)] (V), [Cu₂(2-tpc)₄(4-pyme)₂] (VI), [Cu₂(3-Me-2-tpc)₄(isonia)₂] (VII) (where 2-tpc is 2-thiophenecarboxylate, 3-Me-2-tpc is 3-methyl-2-thiophenecarboxylate, 5-Me-2-tpc is 5-methyl-2-thiophenecarboxylate and 4-pyme is 4-pyridinemethanol and isonia is isonicotinamide) are reported. The complexes under study were characterized by electronic, IR and EPR spectroscopy, magnetic susceptibility over the temperature range and X-ray structure analysis. Structural studies revealed a distorted tetragonal-bipyramidal environment around the copper ion for monomeric complexes I–V. The structure of dimeric complexes VI and VII consists of units of the known paddle-wheel dicopper(II) tetracarboxylates, which are made up of four thiophene-2-carboxylate ions thus bridging the two copper atoms. The complex molecules of all compounds are connected through H-bonds into supramolecular chains or frameworks. The spectral and magnetic properties are discussed with regard to X-ray data.     

Synthesis,structural characterization,EPR spectroscopy and Hirshfeld surface analysis of a novel Cu2+‐doped 3,14‐diethyl‐2,13‐diaza‐6,17‐diazoniatricyclo[16.4.0.07,12]docosane bis(perchlorate)

Cyclam derivatives and their metal complexes have been found to exhibit an anti‐HIV effect and stimulate the activity of stem cells from bone marrow. The strength of their binding to the CXCR4 receptor correlates with anti‐HIV and stem‐cell activities. Knowledge of the conformation and crystal packing of various macrocyclic metal complexes has become important in developing new effective anti‐HIV drugs. The synthesis and preparation of single crystals of a new Cu²⁺‐doped macrocyclic compound, (3,14‐diethyl‐2,6,13,17‐tetraazatricyclo[16.4.0.0^7,12]docosane)copper(II) bis(perchlorate)–3,14‐diethyl‐2,13‐diaza‐6,17‐diazoniatricyclo[16.4.0.0^7,12]docosane bis(perchlorate) (0.69/0.31), {[Cu(C₂₂H₄₄N₄)](ClO₄)₂}_0.69·(C₂₂H₄₆N₄²⁺·2ClO₄^?)_0.31, is reported. Characterization by X‐ray diffraction analysis shows that the asymmetric unit contains half of a centrosymmetric molecule. The macrocyclic ligand in the compound adopts the most stable trans‐III conformation. The Cu—N distances of 2.015 (3) and 2.047 (3) Å are normal, but the long axial Cu—O bond of 2.795 (3) Å may be due to a combination of the Jahn–Teller effect and the strong in‐plane ligand field. The crystal structure is stabilized by hydrogen bonding between secondary N—H groups, the N atoms of the macrocycle and the O atoms of the perchlorate anions. Hirshfeld surface analysis with 2D (two‐dimensional) fingerprint plots indicates that the main contributions to the crystal packing are from H…H (58.0%) and H…O/O…H (41.9%) interactions. Electron paramagnetic resonance (EPR) properties are also described.