Enhanced visualization methods for interpretation of wind tunnel data

Journal of Visualization -     

Carbon fiber cylindrical microelectrode-based detector for the determination of antithyroid drugs

An amperometric flow-injection method for the determination of antithyroid drugs such as 6-methyl-2-thiouracil (MTU) using a carbon fiber cylindrical microelectrode-based detector is reported. A home-made flow-cell specially adapted for working with cylindrical microelectrodes ranging between 4 and 10 mm in length was used for this purpose. Methanol containing 0.05 mol l(-1) tetrabutylammonium perchlorate as the supporting electrolyte was employed, and a potential of +1.6 V was selected for the amperometric detection of MTU. No cleaning or electrode surface regeneration of the fiber was necessary during the whole working day. A limit of detection of 2.6x10(-7) mol l(-1) (37 mug MTU l(-1)) was achieved. The method was applied to the determination of MTU in spiked feed samples (peas and corn flour), at the 142 mug g(-1) level. The procedure involved the extraction of the drug in methanol, a clean-up step using Florisil cartridges and the use of the standard additions method. Recoveries of 81+/-6 and 85+/-8% were obtained for peas and corn flour, respectively.     

Quantitative analysis of bilobalide and ginkgolides from Ginkgo biloba leaves and Ginkgo products using (1)H-NMR

1H-NMR spectrometry was applied to the quantitative analysis of the bilobalide, ginkgolides A, B, and C in Ginkgo biloba leaves and six kinds of commercial Ginkgo products without any chromatographic purification. The experiment was performed by the analysis of each singlet H-12, which were well separated in the range of delta 6.0-7.0 in the (1)H-NMR spectrum. However, the H-12 protons of bilobalide and ginkgolides may have overlapped with H-6 or H-8 protons of the Ginkgo flavonoids. Therefore, the optimum (1)H-NMR solvent for the analysis of the compound was selected through the evaluation of solvent effects on the resolution of these signals from the compounds. Acetone-d(6)-benzene-d(6) (50 : 50) was found to be the best one among the solvents evaluated. The quantity of the compounds was calculated by the relative ratio of the intensity of each compound to the known amount of internal standard (25 microgram), phloroglucinol. This method allows rapid and simple quantitation of underivatized bilobalide and ginkgolides in 5 min without any pre-purification steps.     

Stereoselective synthesis of trans-2,3-disubstituted pyrrolidines via addition to N-acyliminium ions

An efficient and stereoselective synthesis of trans-2,3-disubstituted pyrrolidines is described. The intermolecular alkylation of racemic N-acyliminium ions generated in situ from the corresponding 3-substituted lactams proceeds stereoselectively and in high yield.     

Correction: Click activated protodrugs against cancer increase the therapeutic potential of chemotherapy through local capture and activation

Correction for ‘Click activated protodrugs against cancer increase the therapeutic potential of chemotherapy through local capture and activation’ by Kui Wu et al., Chem. Sci., 2021, 12, 1259–1271, DOI: 10.1039/D0SC06099B.

The authors regret that the reference to the bond-breaking bioorthogonal chemistry, termed ‘click-to-release’ was omitted from the original article. In addition, we would like to include a reference describing the synthesis of compound 1, which is an intermediate to the protodrugs described in the original article. These references are listed below as ref. 1 and 2.The Royal Society of Chemistry apologizes for these errors and any consequent inconvenience to authors and readers.     

Synthese,Kristallstruktur und spektroskopische Charakterisierung von [Au12(PPh)2(P2Ph2)2(dppm)4Cl2]Cl2

Synthesis, Crystal Structure and Spectroscopic Characterization of [Au₁₂(PPh)₂(P₂Ph₂)₂(dppm)₄Cl₂]Cl₂ The reaction of [(AuCl)₂dppm] (dppm = Ph₂PCH₂PPh₂) with P(Ph)(SiMe₃)₂ in CHCl₃ results in the formation of [Au₁₂(PPh)₂(P₂Ph₂)₂(dppm)₄Cl₂]Cl₂ ( 1 ), the crystal structure of which was determined by single crystal X‐ray analysis (space group P2₁/c, a = 1425.3(3) pm, b = 2803.7(6) pm, c = 2255.0(5) pm, β = 95.00(3)°, V = 8977(3)·10⁶ pm³, Z = 2). The dication in 1 consists of two Au₆P₃ units built by highly distorted Au₃P and Au₂P₂ heterotetrahedra, connected via four bidentate phosphine ligands. Additionally, the compound was characterized by IR‐, UV‐ and NMR spectroscopy. The ³¹P{¹H} NMR spectrum is discussed in detail.     

Ethanol production from steam-explosion pretreated wheat straw

Bioconversion of cereal straw to bioethanol is becoming an attractive alternative to conventional fuel ethanol production from grains. In this work, the best operational conditions for steam-explosion pretreatment of wheat straw for ethanol production by a simultaneous saccharification and fermentation process were studied, using diluted acid [H₂SO₄ 0.9% (w/w)] and water as preimpregnation agents. Acid-or water-impregnated biomass was steam-exploded at different temperatures (160–200°C) and residence times (5, 10, and 20 min). Composition of solid and filtrate obtained after pretreatment, enzymatic digestibility and ethanol production of pretreated wheat straw at different experimental conditions was analyzed. The best pretreatment conditions to obtain high conversion yield to ethanol (approx 80% of theoretical) of cellulose-rich residue after steam-explosion were 190°C and 10 min or 200°C and 5 min, in acid-impregnated straw. However, 180°C for 10 min in acid-impregnated biomass provided the highest ethanol yield referred to raw material (140 L/t wheat straw), and sugars recovery yield in the filtrate (300 g/kg wheat straw).     

Cobalt Chalcogenide Clusters. Synthesis,Characterization and DFT Calculations of [Co4Se2(CO)10] and [Co4Te2(CO)11]. Crystal Structure of [Co8Se4(CO)16(μ‐dppa)2]

The reactions of [Co₂(CO)₈] with E(SiMe₃)₂ (E = Se, Te) in CH₂Cl₂ result in the formation of the compounds [Co₄Se₂(CO)₁₀]> ( 1 ) and [Co₄Te₂(CO)₁₁] ( 2 ), respectively. Both cluster complexes have similar molecular structures in which the cobalt atoms form four‐membered rings with μ₄‐bridging chalcogen atoms (Se and Te) above and below the plane of the metal atoms and the carbonyl ligands as either terminal or μ₂‐bridging ligands. DFT‐calculations for both compounds have been carried out in order to obtain some more information about their electronic distribution. In the presence of the phosphine Ph₂PC≡CPPh₂ (dppa), the reaction of [Co₂(CO)₈] with Se(SiMe₃)₂ leads to the formation of [Co₈Se₄(CO)₁₆(μ‐dppa)₂] ( 3 ). During the reaction two molecules of [Co₂(CO)₈] have been added to the acetylene groups of the dppa ligands, whilst the remaining cobalt atoms coordinate to the phosphorus atoms of the phosphine. In this compounds the selenium atoms act as μ₃‐ligands, bridging the metal atoms bonded to the phosphorus with those bonded to the acetylene groups.