Low Cost, High Efficiency, Gain Flattened L Band EDFA Using FBGs as C Band Seed Generators

A low cost, coolerless 980nm diode pumped, gain flattened L band EDFA with fast transient control, high pump efficiency and gain clamping effect was realized by using FBGs as C band seed generators.     

FDTD Method in the Analysis of Lithium Niobate Modulator

The Mach-Zehnder traveling-wave lithium niobate modulator is simulated by time domain finite difference (FDTD)method for different device geometry. The result is comparable to the reported value by finite element method.     

Nitroxide‐mediated radical polymerization of 2‐(dimethylamino)ethyl acrylate and its sequential block copolymerization with styrene and N‐butyl acrylate

Nitroxide‐mediated radical polymerization (NMRP) of 2‐(dimethylamino)ethyl acrylate (DMAEA) was carried out at 100–120 °C, initiated by MONAMS, an alkoxyamine based on N‐tert‐butyl‐N‐(1‐diethyl phosphono‐2,2‐dimethylpropyl)nitroxide, SG1. Controlled polymerization can be achieved by the addition of free SG1 (the initial molar ratio of SG1 to MONAMS ranged from 0.06 to 0.12), giving a linear first‐order kinetic plot up to 55–70% conversion depending on the reaction conditions. The molecular weights show a near linear increase with conversion; however, they deviate to some extent with theoretical values. SG1‐mediated polymerization of DMAEA at 112 °C is also controlled in organic solvents (N,N‐dimethylformide, anisole, xylene). Polymerization rate increases with increasing solvent polarity. Chain transfer to polymer produces ～1 mol % branches in bulk and 1.2–1.9 mol % in organic solvents, typical of those for acrylates. From poly(styrene) (pS) and poly(n‐butyl acrylate) (pBA) macroinitiators, amphiphilic di‐ and triblock copolymers p(S‐b‐DMAEA), p(DMAEA‐b‐S‐b‐DMAEA), p(BA‐b‐DMAEA), and p(DMAEA‐b‐BA‐b‐DMAEA) were synthesized via NMRP at 110 °C. Polymers were characterized by GPC, NMR, surface tension measurements, and DSC. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 414–426, 2006     

单个波长到多个波长的变换实验

报道一种波长变换的新方法.采用此方法不需要任何泵浦光便能够直接将信号光变换成在特定谱宽内的任意多个任意波长的变换光,这对于将来的波分复用光网络提供了较大的方便.此波长变换的原理是利用色散位移光纤的非线性效应产生超连续光谱(SC)信号,由于这种SC信号携带有变换光信号,对这种连续谱进行滤波便能够得到所需要的任意频率的变换信号.此变换方式具有变换频带宽,偏振不敏感的优点。     

聚甲醛自然老化的SEM研究

对户外曝晒3～36个月的聚甲醛(POM)老化形态进行了研究,讨论了老化层厚度,裂纹宽度、裂纹深度及断口形态与老化时间的关系。结果表明:POM的老化导致了材料内部结构由韧性变成脆性而几乎完全丧失物理机械性能。     

酚醛树脂固化过程的红外光谱分析

利用红外光谱(IR)及其变温样品池、定量分析程序对酚醛树脂固化过程中的结构变化进行了研究,它对于酚醛树脂固化过程的质量控制具有重要意义。     

Coaxial electrospinning core-shell fibers for self-healing scratch on coatings

Polystyrene (PS) fibers with core-shell structure were prepared by coaxial electrostatic spinning using liquid epoxy or curing agent as the core and PS solution as the shell. Scratch self-healing coatings were realized by using the healant-loaded core-shell fibers in the matrix.     

N,N,N,′N′-四丁基丁二酰胺的合成及其萃取稀土离子Pr(Ⅲ)的研究

合成了四取代双酰胺萃取剂N,N,N,′N′-四丁基丁二酰胺(TBSA),并对萃取剂的结构进行了表征。研究了其萃取Pr(Ⅲ)的性能,考察了硝酸浓度、萃取剂浓度、硝酸锂浓度以及温度等对萃取分配比的影响。萃取反应在298K时,TBSA以甲苯为稀释剂时的热力学焓变为-12.83 kJ/mol。萃合物的组成结构为Pr(NO3)3.3TBSA。     

Two-dimensional tellurium saturable absorber for ultrafast solid-state laser

Two-dimensional(2 D) Te nanosheets were successfully fabricated through the liquid-phase exfoliation(LPE) method. The nonlinear optical properties of 2 D Te nanosheets were studied by the open-aperture Z-scan technique. Furthermore, the continuous wave mode-locked Nd:YVO_4 laser was successfully realized by using 2 D Te as a saturable absorber(SA) for the first time, to the best of our knowledge. Ultrashort pulses as short as 5.8 ps were obtained at 1064.3 nm with an output power of 851 m W. This primary investigation indicates that the 2 D Te SA is a promising photonic device in the fields of ultrafast solid-state lasers.