Diffusion Structural Analysis Study of Titania Films Deposited by Sol-Gel Technique on Silica Glass

The diffusion structural analysis (DSA) was used to characterize microstructure changes of hydrous titania gel films under in situ conditions of heating. TG and DTA were used in order to elucidate the processes controlling the formation of anatase film during heating of hydrous titania gel film. The annealing of porosity and near surface structure defects of the dehydrated titania films was indicated by DSA in the temperature range 255–700°C as the decrease of radon release rate. It was demonstrated that the annealing was enhanced on heating in oxygen in comparison with heating in argon. The DSA experimental results were compared with model curves describing the radon diffusion mobility and the annealing of radon diffusion paths.     

On the evaluation of the nonisothermal kinetic parameters of (GeS2)0.3(Sb2S3)0.7 crystallization using the IKP method

The isoconversional method suggested by Friedman and the invariant kinetic parameters method (IKP) were used in order to examine the kinetics of the nonisothermal crystallization of (GeS₂)_0.3(Sb₂S₃)_0.7. The objective of the paper is to show the usefulness of the IKP method both for determining the activation parameters as well as the model of the investigated process. It was shown that the kinetic triplet [(E, A, f(α), where E is the activation energy, A is the preexponential factor, and f(α) is the differential function of conversion], which results through the application of the IKP method, depends on the set of kinetic models considered. For different sets of kinetic models, proportional values of f(α) are obtained. A criterion for the selection of this set, the use of which lead to the true kinetic triplet corresponding to the analyzed process (E = 163.2 kJ mol^?1; A = 2.47 × 10¹² min^?1 and the Avrami‐Erofeev model, A_m, for m = 2.5–2.6 was suggested. © 2004 Wiley Periodicals, Inc. Int J Chem Kinet 36: 309–315, 2004     

Mass spectra of bile acid methyl ester acetate derivatives

Deuterium labeling in the acetate derivatives of cholic acid demonstrates that electron impact induced consecutive loss of HOAc from the molecular ion occurs in the following order of decreasing preference: 12α-OAc > 7α-OAc > 3α-OAc. Numerous examples are presented showing that consecutive loss of HOAc from a common ion generally increases progressively with relative intensity. In the acetate pregnan-20-one derivatives of cholic acid, loss of 43 mass units from the molecular ion comes from the 12α-OAc and not the 17β-acetyl sidechain. Ketene is ejected from an acetoxy group located in an α position to a carbonyl on which an ion-radical charge is localized.     

Simultaneous Spectrophotometric Determination of Group B Vitamins Using Parallel Factor Analysis: PARAFAC

In this work, a simple and rapid analytical procedure was applied for simultaneous determination of folic acid (vitamin B₀), thiamin (vitamin B₁), riboflavin (vitamin B₂) and pyridoxal (vitamin B₆) based on the absorbance data in the pH range 2.0‐12.0 at 25 °C using parallel factor analysis (PARAFAC). The effect of the pH as the most important factor on the sensitivity of the determination was studied. The spectral data were recorded in 400‐650 nm intervals and a 2‐12 pH range for all four vitamins. The calibration set was constructed in the concentration ranges of 4‐22, 1‐20, 6‐26, and 4‐20 μg mL^?;1 for B₆,B₂,B₁ and B₀, respectively. The root mean squares errors of prediction for the prediction set, (RMSEP), are 0.65, 0.63, 1.13 and 0.34 for B₀,B₁,B₂ and B₆, respectively. The recovery percent for the validation set are in the range of 90.6 to 107.0%. The effect of the experimental conditions and diverse species were discussed. The optimum values of these factors were searched according to the relative standard deviation of the prediction set of mixtures solutions.     

A novel direct method for preparation of aromatic polyimides via microwave-assisted polycondensation of aromatic dianhydrides and diisocyanates

Possibility of imide structure formation under microwave irradiation of molecules containing anhydride and isocyanate functional groups was investigated. The microwave-assisted polycondensation of aromatic diisocyanates and dianhydrides for preparation of polyimides was studied. The effect of microwave irradiation time and power, solvent nature, solid content of monomers, effect of catalyst, effect of polymerization reactor material and possibility of pressure development during polymerization, on the inherent viscosity of prepared polyimides were discussed. Experimental results showed that polymers obtained via this method had superior inherent viscosity and yield in comparison to the polymers obtained via conventional solution method.     

Studies directed toward synthesis of quassinoids. VI—mass spectral fragmentation of D-ring seco esters and δ-lactone derivatives of cholic acid

Analogy and deuterium labeling demonstrate that considerable remote group interaction occurs between functional groups at positions 7 and 16 in 16, 17-secosteroids. It is proposed that ion-dipole interact?ions separations of distances of 10 to 2 Å will involve energies of 1–30 kcal mol^?1 and can play a significant role in fragmentation processes. Successive loss of one, two and three HOAc molecules from a milecular or daughter ion increase progressively in relative intensity; irregularity in this pattern indicates the operation of special factors or multiple genesis of daughter ions having the same m/e. Evidence is presented which suggests that facile ketene ejection from the acetate functional group only occurs from a radical ion and must be preceded by transfer of a hydrogen radical from the acetate group to the site of charge localization.     

Synthesis and characterization of maleimide polymers with pendant pyrazole groups. IV. Copolymerization of pyrazole-modified maleimides with vinyl ethers

The synthesis of maleimides that have pyrazolic or bipyrazolic pendant groups is described. Their homopolymerization and their copolymerization with 2-chloroethyl vinyl ether (CEVE) is reported. The homopolymerizations of such maleimides were performed under various conditions and led to low molecular-weight polymers. However, alternating copolymers were obtained from CEVE as comonomers whatever the monomers feed compositions. A similar behavior was also observed for maleimides that do not exhibit any spacer, whereas for bulky vinyl ethers, random copolymers were produced. A comparison of the thermal behavior between these copolymers (glass transition temperatures, T_g, and decomposition temperatures) and other copolymers having different spacers between the nitrogenated cycles and the chain are related. Thus, an important decrease of T_g, was observed when C₃H₆CO₂CH₂ groups were used as the spacer instead of methylene groups. Moreover, the thermal weakness of these copolymers may come from the substituents of the vinyl ether and is discussed. © 1994 John Wiley & Sons, Inc.