Collective Tunnelling of Strongly Interacting Cold Atoms in a Double-Well Potential

It is known that under resonance conditions, a group of strongly interacting bosonic atoms, trapped in a double-well potential, mimics a single particle, performing Rabi oscillations between the wells. By implication, all atoms need to tunnel at roughly the same time, even though the Bose–Hubbard Hamiltonian accounts only for one-atom-at-a-time transfers. The mechanism of this collective behavior is analyzed, the Rabi frequencies in the process are evaluated, and the limitation of this simple picture is discussed. In particular, it is shown that the small rapid oscillations superimposed on the slow Rabi cycle result from splitting the transferred cluster at the sudden onset of tunnelling, and disappear if tunnelling is turned on gradually.     

Structural manipulation of pyrochlores: Thermal evolution of metastable Gd2(Ti1−yZry)2O7 powders prepared by mechanical milling

The structural and microstructural characteristics of metastable Gd₂(Ti_1−yZr_y)₂O₇ powders prepared by mechanical milling have been studied by a combination of XRD and Raman spectroscopy. Irrespective of their Zr content, as-prepared powder phases present an anion-deficient fluorite-type of structure as opposed to the pyrochlore equilibrium configuration obtained for the same solid solution by other synthetic routes. These fluorites are stable versus thermal activation, at least up to temperatures of 800 °C. For the Ti-rich compositions, thermal treatments at higher temperatures facilitate the rearrangement of the cation and anion substructures and the relaxation of mechanochemically induced defects whereas for compositions with high Zr content, the fluorite crystal structure is retained even at temperatures as high as 1200 °C. Interestingly enough, transient pyrochlores showing a very unusual cation distribution were observed during the thermally induced defect-recovery process.     

Preparation and electrochemical behavior of ordered rh adlayers on Pt(100) electrodes

Rhodium adlayers on Pt(100) substrates have been prepared by electrodeposition from dilute Rh(III) acidic solutions. The initially disordered layer is electrochemically annealed by applying a polarization program consisting of high-sweep-rate multicycle sequences between 0.05 and 0.78 V(RHE) in 0.1 M H(2)SO(4). In this way, a pseudomorphic Rh monolayer can be prepared on Pt(100) substrates. The degree of order of the electrochemically annealed layer has been evidenced not only through voltammetric experiments but also by means of scanning tunneling microscopy with atomic resolution for iodine-protected adlayers, which show a c(2 x 2) structure. The electrochemically induced ordering of the Rh adlayer appears to be a consequence of the repeated cycles of adsorption/desorption of H and, especially, oxygenated species. Voltammetry in sulfuric acid solutions permits examination of the energetics of H/anions and OH/O adsorption as a function of the Rh coverage. The first monolayer adsorbs both hydrogen and oxygenated species more strongly than the second one. This can be explained through an electronic effect caused by the underlying Pt(100) substrate.     

Kinetics of the solution polymerization of dioxolane in the presence of water

Water acts as a cocatalyst in the polymerization of dioxolane initiated by the ion pair ～Si^⊕HSO₄^?. The dependence of the reaction rate on the water concentration exhibits a maximum, the width of which strongly depends on the concentration of dioxolane. The change of the coordinates of the maximum and its shape with the decrease of the monomer concentration causes the reaction rate to decrease with increasing conversion. The point at which the slope of the conversion curve changes is a function of initial concentration of water. There is a very fast decrease of the concentration of free water in the polymerizing system. The consumption of water is associated with some peculiarities. The amount of free water which remains in the system is a function of the concentration of the original initiator. The ratio [H₂O]_∞/[initiator] is constant over a rather broad range of initial concentration of water.     

Molybdenum(VI) and molybdenum(V) mononuclear and dinuclear complexes with 1,3-diphenyl-1,3-propanedione

Summary The synthesis and the dinuclear or mononuclear nature of several molybdenum(VI) and molybdenum(V) oxocomplexes derived from 1,3-diphenyl-1,3-propanedione (HLL) are described. These complexes were identified by i.r. and electronic spectra, magnetic susceptibility and analytical data, and are assigned the following formulae: [MoO₂(LL)₂], [Mo₂O₅(LL)₂], [Mo₂O₄(LL)₂], [MoOCl(LL)₂], [MoCl₂(LL)] and [MoO(OH)(LL)₂)]. The low magnetic moments of the dinuclear complexes are due, in part, to intramolecular interactions. The i.r. data show that the dionate is bound by two oxygen atoms forming a chelate six-membered ring.     

Simulation of aerated lagoon using artificial neural networks and multivariate regression techniques

The aim of this study was to develop an empirical model that provides accurate predictions of the biochemical oxygen demand of the output stream from the aerated lagoon at International Paper of Brazil, one of the major pulp and paper plants in Brazil. Predictive models were calculated from functional link neural networks (FLNNs), multiple linear regression, principal components regression, and partial least-squares regression (PLSR). Improvement in FLNN modeling capability was observed when the data were preprocessed using the PLSR technique. PLSR also proved to be a powerful linear regression technique for this problem, which presents operational data limitations.     

Inorganic-metalorganic hybrids based on copper(II)-monosubstituted Keggin polyanions and dinuclear copper(II)-oxalate complexes. Synthesis, X-ray structural characterization, and magnetic properties

Reaction of in situ generated copper(II)-monosubstituted Keggin polyoxometalates and copper(II)-bipyridine-oxalate complexes in the corresponding alkaline acetate buffer led to the formation of hybrid metal organic-inorganic compounds K(2)[{SiW(11)O(39)Cu(H(2)O)}{Cu(2)(bpy)(2)(H(2)O)(2)(mu-ox)}(2)].14H(2)O (1), K(14)[{SiW(11)O(39)Cu(H(2)O)}{Cu(2)(bpy)(2)(mu-ox)}](2)[SiW(11)O(39)Cu(H(2)O)].55H(2)O (2), (NH(4))(4)[{SiW(11)O(39)Cu(H(2)O)}{Cu(2)(bpy)(2)(mu-ox)}].10H(2)O (3), and Rb(4)[{SiW(11)O(39)Cu(H(2)O)}{Cu(2)(bpy)(2)(mu-ox)}].10H(2)O (4). Their structures have been established by single-crystal X-ray diffraction. The main structural feature of these compounds is the presence of copper(II)-monosubstituted alpha-Keggin polyoxoanions as inorganic building blocks, on which the mu-oxalatodicopper metalorganic blocks are supported. Compound 1contains the discrete hybrid polyanion [{SiW(11)O(39)Cu(H(2)O)}{Cu(2)(bpy)(2)(H(2)O)(2)(mu-ox)}(2)](2)(-), whereas the polymeric hybrid polyanion [{SiW(11)O(39)Cu(H(2)O)}{Cu(2)(bpy)(2)(mu-ox)}(2)](n)(4)(n)(-) gives a monodimensional character to compounds 2-4. Magnetic and EPR results are discussed with respect to the crystal structure of the compounds. DFT calculations on both the [Cu(2)(bpy)(2)(H(2)O)(4)(mu-ox)](2+) cationic complex and the metalorganic blocks have been performed in order to determine the optimized geometry and the magnetic coupling constants, respectively.     

Capillary zone electrophoresis of cationic and anionic drugs in methanol

The actual mobilities and dissociation constants of acidic and basic pharmaceuticals were determined in methanol. Actual mobilities were derived from the dependence of the effective mobilities of the analytes on the pH of the methanolic background electrolyte solution (pH(MeOH)). The pKa values of the pharmaceuticals in methanol (pK(a,MeOH)) were calculated by non-linear curve fitting to the measured mobility values. It was found that the shift in pKa value (when compounds were transferred from water to methanol) increased with the acidity of the analyte. The average pKa shift for compounds exhibiting acidic properties in water was ca. 5.5 units, and the shift for basic compounds about 2 units. As was shown for a mixture of beta-blockers, the calculated actual mobilities and pKa values can be utilised in the optimisation of pH conditions for separation. The practical value of the method was illustrated by the analysis of urine samples.