On pointwise decay rates of time‐periodic solutions to the Navier–Stokes equation

We study the existence of a time‐periodic solution with pointwise decay properties to the Navier–Stokes equation in the whole space. We show that if the time‐periodic external force is sufficiently small in an appropriate sense, then there exists a time‐periodic solution $\{u,p\}$ of the Navier–Stokes equation such that $|{?}^j{u(t,x)|=O(|x|}^{1?n?j})$ and $|{?}^j{p(t,x)|=O(|x|}^{?n?j})(j=0,1,\dots )$ uniformly in $t\in \mathbb{R}$ as $|x|\to \infty$. Our solution decays faster than the time‐periodic Stokes fundamental solution and the faster decay of its spatial derivatives of higher order is also described.     

Reaction of C3 and C4 ketoses with alkenals and alkenones in water

Treatment of 1,3-dihydroxyacetone and acrolein with aqueous KOH gave a tetrahydrofuran derivative, 1,4-dihydroxy-3,7-dioxabicyclo[3.3.0]octane, in 80% yield. Similarly, 6-alkyl substituted 1,4-dihydroxy-3,7-dioxabicyclo[3.3.0]octanes were obtained by reaction of 1,3-dihydroxyacetone with various α,β-unsaturated aldehydes. In the cases of long chain alkenals, the reaction was effectively accelerated in the presence of organic co-solvent. On the other hand, the corresponding tricyclic products were synthesized by reaction of 1,3-dihydroxyacetone with cyclic enones, such as 2-cyclopentenone and 2-cyclohexenone. This method was successfully applied to the reaction of a tetrulose in the absence of any protecting groups.     

Facilitated sulfate transfer across the nitrobenzene-water interface as mediated by hydrogen-bonding ionophores.

Facilitated SO4(2-) transfers by hydrogen bond-forming ionophores are investigated across the nitrobenzene (NB)-water interface by using polarography with a dropping electrolyte electrode. Bis-thiourea 1, alpha,alpha'-bis(N'-p-nitrophenylthioureylene)-m-xylene, is found to significantly facilitate the transfer of the highly hydrophilic SO4(2-) whereas its counterpart, N-(p-nitrophenyl)-N'-propylthiourea (ionophore 2), cannot. In contrast to the predominant formation of a 1:1 complex with SO4(2-) in the bulk NB phase, the SO4(2-) transfer assisted by 1 is indeed based on the formation of a 1:2 complex between SO4(2-) and ionophore, even under the condition of [SO4(2-)]aq > [1]org. Such an exclusive formation of the 1:2 (SO4(2-) to ionophore) complex at the NB-water interface is not observed with structurally similar bis-thiourea 3, alpha,alpha'-bis(N'-phenylthioureylene)-m-xylene, where p-nitrophenyl moietes of bis-thiourea 1 are simply replaced by phenyl groups. The facilitated transfer of SO4(2-) with bis-thiourea 1 is further compared to that of HPO4(2-) and H2PO4- across the NB-water interface, which was previously shown to be assisted by 1 through the formation of the 1:1 and 2:1 (anion to ionophore) complexes, respectively. On the basis of these examinations, unique binding behaviors of hydrogen bond-forming ionophores at the NB-water interface are discussed, with a view towards development of ionophore-based anion-selective chemical sensors.     

Development of Non-Halogen Flame Retardant Optical Fiber and Optical Fiber Cord

A non-halogen highly flame-retardant 0.9mm optical fiber and 2.0mm simplex optical cord, which are harmonized with the ecosystem, have been developed. The characteristics of them are presented in this paper.     

Development and features of hydro-membrane gas chromatography.

Hydro-membrane gas chromatography (HMGC) is achieved by the annular condensation of water in a capillary column at less than 70 degrees C. The annular membrane of water is formed as a result of the wettability of the stationary phase, which is induced at a water contact angle ranging from 75 degrees to 79 degrees, as derived from a solubility parameter (delta) range of 15.7 +/- 0.3 MPa(1/2) of the coated resin. The range of the liquid to gas volume ratio (beta) required to support the annular membrane should be kept between 0.00005 and 0.0003. In the case of a 0.25-mm i.d. column, the ratio can be set by the combination of a 0.1 to 0.2 microl min(-1) water supply rate and helium gas flow rate. Separation by HMGC develops not only a gas-solid partition but also a focusing effect on the water membrane. One feature of HMGC is that it gives a non-adsorption chromatogram based on the blocking effect of pre-adsorbed water; furthermore, despite the presence of a relatively large quantity of water, the electron impact ionization efficiency is kept the same as in the usual GC/MS condition. The detection limit with the injection of 1 microl of aquatic solution was estimated to be less than 0.1 ppb of low-molecular-weight fatty acids with s/n = 5 on a mass chromatogram at m/z 45. The HMGC/EI-MS system can be applied to the trace analysis of C1 to C3 volatile acids, volatile inorganic acids, and halogenated organic acids in water.     

Hetergeneous-nucleation synthesis of monodisperse ε-cobalt nanoparticles using palladium seeds

Monodisperse bimetallic Pd–Co nanoparticles were prepared via a thermal decomposition of cobalt carbonyl using palladium seeds at the Pd/Co molar ratios 0.5%, 1%, and 5%. The heterogeneously nucleated nanoparticles without any size-selective precipitation are sufficiently uniform to self-assemble into ordered arrays. The as-synthesized nanoparticles are each a single crystal with a complex cubic structure called ε-Co. The presence of Pd seeds seems to improve the stability of Co nanoparticles against oxidation based on the results from time-dependent magnetization measurement.     

Pfaffian systems and Radon transforms on affine Grassmann manifolds

Mathematische Annalen -     

Electronic effect on the regioselectivity in the ring opening of para-substituted phenyloxiranes by acetylides

The electronic effect on the regioselectivity in the alkynylation of phenyloxiranes was investigated using three kinds of metal acetylides. BF₃ mediated lithium acetylide provided either the α- or β-alkynylated products by controlling the effect of the para-substituents of the phenyloxiranes. LiClO₄ mediated lithium acetylide and titanium acetylide, on the other hand, afforded predominantly the β- and α-products, respectively.     

In Situ Processing of Nano Crystalline Oxide Particles/Polymer Hybrid

Nano sized crystalline particles/polymer hybrids were synthesized form designed metal-organic precursors. The newly developed method is composed of the synthesis of organic matrix by polymerization and the in situ nucleation and growth of crystalline oxide particles in the organic matrix below 100°C. The design of metal-organic precursor modified with polymerizable ligand and the selection of reaction conditions does influence the size and crystallinity of ceramic particles in organic matrix. The nano-sized magnetic particle/polymer hybrid exhibits the interesting feature of superparamagnetism and quantum size effect. The crystalline particles of BaTiO₃/, PbTiO₃/, and KNbO₃/polymer hybrids behave to be dielectric and show the typical electro-rheological behavior.