激光二极管侧面抽运Nd:YAG锁模激光器的研究

利用谐振腔的稳定条件对激光二极管侧面抽运的Nd：YAG锁模直腔的稳区特性和谐振腔内的光斑分布进行了分析。根据对腔参量的分析，选取合适的腔参量设计了一个简单的侧面抽运直腔，该谐振腔腔形简单，没有像散，振荡光模式好，有利于激光器的锁模运转。实验中采用国内自行研制的半导体可饱和吸收镜，实现了激光二极管侧面抽运半导体可饱和吸收镜锁模Nd：YAG激光器的连续锁模运转，平均输出功率为2W，锁模脉冲宽度为10ps，重复频率为100MHz。结合实验结果进一步讨论了半导体可饱和吸收镜的一些参量如饱和恢复时间、调制深度等对实现稳定连续锁模的影响。     

Graphene oxide for diode-pumped Tm:YLF passively Q-switched laser at 2 μm

A diode-pumped Tm:YLF passively Q-switched laser at 2 μm was first demonstrated by using graphene oxide(GO) as a saturable absorber(SA).In this letter,continuous-wave(CW) laser and pulse laser performances were studied meticulously and systematically.It reasonably showed the dependence of the pulse duration,pulse energy,and pulse repetition rate on the absorbed power.A maximum repetition rate of 38.33 kHz and a single pulse energy of 9.89 μJ were obtained.     

连续锁模Nd∶YVO4激光器实现1 GHz高频输出

LD抽运全固体Nd∶YVO4激光器在连续锁模状态运转下获得了高达1 GHz的重复频率.实验中采用半导体可饱和吸收镜作为锁模元件.利用透过率只有0.8%的输出镜以及可获得较小抽运光斑的2 WLD作为抽运源来优化激光器设计,有效地抑制了调Q锁模状态的运转.低的激光器振荡阈值(35 mW)和连续锁模阈值(0.8 W)显示了饱和吸收体低的插入损耗和激光器合理的设计.在最大抽运1.6 W 时获得了210 mW的平均输出功率.     

A Bidirectional, Diode-Pumped, Passively Mode-Locked Nd：YVO4 Ring Laser with a Low-Temperature-Grown Semiconductor Saturable Absorber Mirror

We report the operation of a bidirectional picosecond pulsed ring Nd：YVO4 laser based on a low-temperaturegrown semiconductor saturable absorber mirror. Except for the laser crystal, the six-mirror ring laser cavity has no intra-cavity elements such as focusing lens or mirror. The bidirectional mode locked pluses are obtained at the repetition rate of 117.5 MHz, pulse duration of 81 ps, power of 2 × 200 mW.     

嵌岩桩桩端承载力探讨

以往嵌岩桩的试验资料表明,当上覆岩土层较薄、嵌岩桩的入岩深度较小时,嵌岩桩的极限端承力对桩的承载能力起主导作用。为求出桩端极限承载力的表达式,本文将嵌岩段以上岩土层自重视为作用在基岩半平面上的均布荷载,把桩端合力分解为相对简单的荷载作用于基岩平面上,利用滑移线理论并通过叠加的方法分析出桩端基岩破坏时的最危险点。然后根据Mindlin课题求出该点的应力,运用Griffith准则的Murrell推广导出桩端极限承载力的公式,并指出了此公式的适用范围。最后结合工程实际进行了对比分析,表明本文方法具有一定的实用性。     

激光驱动高压冲击波的实验观察

本文介绍能量约500J,脉宽约1.2ns的高功率激光脉冲聚焦辐照铝箔靶或铝台阶靶,用可见光超快速扫描相机观察靶背面冲击加热发光的情况。实验表明,采用特别的组合透镜聚焦,使激光冲击波的平面性得到明显的改善。实验测得铝台阶中的冲击波速度为17.6μm/ns,并推算出相应的冲击波压力达4.4Mbar。 关键词：     

Mode locked Er-doped fiber laser with single-wall carbon nanotube saturable absorber

A mode locked Er-doped fiber laser based on a single-wall carbon nanotube saturable absorber is demonstrated. A high quality single-wall carbon nanotubes （SWCNTs） absorber film is fabricated by a polymer composite. The pulse duration is 488 fs with 9.6-nm spectral width at the center of 1564 nm. The repetition rate is 30.4 MHz. The maximum output power is 3 mW. And the single pulse energy is 0.1 nJ.     

532-nm picosecond pulse generated in a passively mode-locked Nd:YVO_4 laser

A diode-pumped continuous-wave （CW） mode-locked Nd：YVO4/KTP green laser with semiconductor saturable absorber mirror （SESAM） is demonstrated. The maximum output power of CW mode-locked green laser is obtained to be 552 mW at the incident pump power of 7.25 W, corresponding to an opticai-optical conversion efficiency of about 7.6%. The 532-nm CW mode-locked pulse duration is estimated to be about 8.4 ps with the repetition rate of 87 MHz.     

半导体可饱和吸收镜被动锁模侧面抽运Nd:YAG激光器研究

利用半导体可饱和吸收镜(SESAM)锁模技术实现的超快脉冲激光器具有结构简单紧凑、脉冲序列稳定等优势,在许多领域有着重要用途,自问世以来受到国内外的广泛关注.分析了SESAM被动锁模侧面抽运固体激光器的具体要求,进行了不同条件下的SESAM被动锁模侧面抽运Nd:YAG激光器实验.获得了最高平均功率9.5 W,脉冲重复频率71 MHz,单脉冲能量约141 nJ的皮秒激光脉冲.对SESAM被动锁模侧面抽运Nd:YAG激光器进行了实验和理论分析,对实现高功率连续超短脉冲激光器进行了探讨.