排序方式: 共有85条查询结果,搜索用时 15 毫秒
1.
采用溶胶-凝胶法制备了系列多晶CMR材料La0.7Ca0.3Mn1-xCuxO3(x=0%,1%,5%,10%,15%,20%)。在77-350 K温度范围内测量了样品的电阻率及磁电阻大小。实验结果发现:系列样品TC随掺杂量增加而递减;系列样品的电阻率峰及磁电阻峰在整个测温范围内随掺杂量的增加均依次被展宽直至消失,当掺杂量为x≥10%时,电阻率随温度的变化在整个测温范围内呈现绝缘相行为;同时还发现,掺杂量为x≥10%时,样品的磁电阻在整个测温区内基本表现为隧穿磁电阻。基于我们采用蒙特卡罗模拟方法提出的逾渗模型及隧穿磁电阻模型,对样品的磁电阻行为进行了很好的解释。对系列样品的ρ-T曲线进行lnρ-T^-(1/4)系拟合,发现掺杂量为x=10%样品在整个温区内的lnρ-T^-(1/4)系基本呈线性。 相似文献
2.
Nano-crystalline FeOOH particles(5~10 nm) have been uniformly mixed with electric matrix of single-walled carbon nanotubes(SWNTs)for forming FeOOH/SWNT composite via a facile ultrasonication method. Directly using the FeOOH/SWNT composite(containing 15 wt%SWNTs) as anode material for lithium battery enhances kinetics of the Li+insertion/extraction processes, thereby effectively improving reversible capacity and cycle performance, which delivers a high reversible capacity of 758 mAh g-1under a current density of 400 mA g-1even after 180 cycles, being comparable with previous reports in terms of electrochemical performance for FeOOH anode. The good electrochemical performance should be ascribed to the small particle size and nano-crystalline of FeOOH, as well as the good electronic conductivity of SWNT matrix. 相似文献
3.
微波促进酸性离子液体催化水杨酸酯化 总被引:2,自引:0,他引:2
用自制的硫酸氢1-甲基-3-(3-磺酸基丙基)咪唑([MIMPS]HSO4)酸性离子液体作为水杨酸与醇的酯化反应催化剂,考察了温度、时间、物料配比和离子液体用量等因素对酯化反应的影响,优化的最佳反应条件为: 微波辐射时间20 min,反应温度95 ℃,醇与酸摩尔比3∶1(水杨酸的量为0.02 mol),[MIMPS]HSO4用量10 mmol,水杨酸甲酯的产率和选择性分别为91.9%和99.0%。 离子液体回收循环使用4次,催化效率不变。 与热催化酯化反应相比,微波辐射可缩短反应时间;水杨酸与不同碳链醇的酯化产率随着碳链的增加而降低,同碳链的伯醇酯化率比仲醇高。 相似文献
4.
5.
在平面问题中,如果已知边界某点处的应力函数值和偏导数值为零,吊边界上的外载荷来构造出Airy应力函数。章利用虚拟荷和坐标变换的办法,避免了在构造Airy应力函数时可能出现的问题。 相似文献
6.
Deyan Peng Xiangui Chen Yang Wang Zhigao Hu Ke Yu Ziqiang Zhu 《Applied Physics A: Materials Science & Processing》2011,105(2):463-468
The structural and optical properties of the needle-like ZnO nanostructure grown on the carbon nanotubes (ZnO/CNTs) have been
studied by scanning electron microscope (SEM), X-ray diffraction (XRD), and photoluminescence (PL) spectra. It can be seen
that there is about tens of nanometers in diameter of the single ZnO nanorod from the SEM picture. The XRD analysis shows
that the prepared film is of typical wurtzite hexagonal phase without impurity. Temperature dependence of electronic transitions
in the ZnO/CNTs has been investigated by PL in detail. The emission features in near band gap at 10 K reveal a redshift trend
compared to ZnO single crystal, which is associated with the strong interfacial connection between ZnO and CNTs. Moreover,
the intensities of all transitions in near band gap and visible regions decrease with increasing the temperature but increase
with the excitation power. It can be concluded that the combined effect from ZnO and CNTs plays an important role in the PL
response. The emission variations with the temperature for the ZnO/CNTs are the result of the electron–phonon interaction
and the lattice thermal expansion. 相似文献
7.
Zhang J Chen X Jiang K Shen Y Li Y Hu Z Chu J 《Dalton transactions (Cambridge, England : 2003)》2011,40(31):7967-7975
Ferroelectric lanthanum (La)-substituted bismuth titanate (Bi(4-x)La(x)Ti(3)O(12), BLT) nanocrystalline films with the composition range of 0 ≤x≤ 1 have been directly deposited on n-type Si?(100) substrates by chemical solution deposition. The La substitution effects on the preferred orientation, surface morphology, phonon modes, emission bands and electronic band structures of the BLT films have been investigated by microscopy, Raman scattering, photoluminescence and spectroscopic ellipsometry at room temperature. X-Ray diffraction analysis shows that the films are polycrystalline and exhibit the pure perovskite phase structure. With increasing La composition, the (100)-orientation degree can be enhanced and the root-mean-square roughnesses slightly increase from 6.5 to 8.3 nm. It was found that the Raman-active mode A(1g)[Bi] at about 59 cm(-1) is unchanged while the B(1g) and A(1g)[Ti] phonon modes at about 648 and 853 cm(-1) are shifted towards higher frequency by about 36.6 and 8.4 cm(-1), respectively. Photoluminescence spectra show that the intensity of the peak located at about 2.3 eV increases with the La composition, except for the Bi(3)LaTi(3)O(12) film, due to the smallest grain size and oxygen vacancy defects. The optical constants of the BLT films have been uniquely extracted by fitting the measured ellipsometric spectra with a four-phase layered model (air/surface rough layer/BLT/Si) in the photon energy range of 0.73-4.77 eV. The Adachi dielectric function model has been successfully applied and reasonably describes the optical response behavior of the ferroelectric BLT films. Moreover, the film packing density decreases while the optical band gap linearly increases from 3.610 ± 0.066 to 3.758 ± 0.068 eV with increasing La composition. It is surmised that the phenomena are mainly ascribed to the variations of the electronic structure, especially for the conduction band, which is perturbed by the La doping. 相似文献
8.
A new dual-frequency laser displacement measurement interferometer with nanometer precision has been developed. An eight-pass optical subdivision technology is proposed to improve resolution based on commercial interferometers. A static positioning error measuring method has been used to examine the precision and repeatability of the laser interferometer. An optical resolution of 1.24 nm and an accuracy of nanometer scale have been achieved. 相似文献
9.
Zhigao Shi Jinshan College Fujian Agriculture Forestry University Fuzhou 《Annals of Differential Equations》2010,(1):53-58
In this paper, a class of simplified Type-IV predator-prey system with linear state feedback is investigated. We prove the boundedness of the positive solutions to this system, and analyze the quality of the equilibria and the existence of limit cycles of the system surrounding the positive equilibra. By Hopf bifurcation theory, the result of having two limit cycles to the system is obtained. 相似文献
10.
Total Synthesis of (6R,10R,13R,14R,16R,17R,19S,20R,21R,24S, 25S,28S,30S,32R,33R,34R,36S,37S,39R)‐Azaspiracid‐3 Reveals Non‐Identity with the Natural Product
下载免费PDF全文
![点击此处可从《Angewandte Chemie (International ed. in English)》网站下载免费的PDF全文](/ch/ext_images/free.gif)
Nathaniel T. Kenton Dr. Daniel Adu‐Ampratwum Dr. Antony A. Okumu Dr. Zhigao Zhang Dr. Yong Chen Dr. Son Nguyen Dr. Jianyan Xu Dr. Yue Ding Dr. Pearse McCarron Dr. Jane Kilcoyne Prof. Dr. Frode Rise Prof. Dr. Alistair L. Wilkins Dr. Christopher O. Miles Prof. Dr. Craig J. Forsyth 《Angewandte Chemie (International ed. in English)》2018,57(3):805-809
A convergent and stereoselective total synthesis of the previously assigned structure of azaspiracid‐3 has been achieved by a late‐stage Nozaki–Hiyama–Kishi coupling to form the C21?C22 bond with the C20 configuration unambiguously established from l ‐(+)‐tartaric acid. Postcoupling steps involved oxidation to an ynone, modified Stryker reduction of the alkyne, global deprotection, and oxidation of the resulting C1 primary alcohol to the carboxylic acid. The synthetic product matched naturally occurring azaspiracid‐3 by mass spectrometry, but differed both chromatographically and spectroscopically. 相似文献