Ce0.8Y0.2O1.9-Ca3(PO4)2-K3PO4复合电解质在中温区的质子导电性及在常压合成氨中的应用

A precursor of Ce_0.8Y_0.2O_1.9(YDC) solid electrolyte was synthesized by the gol-gel method. YDC and phosphates powders were prepared by mixing the YDC and phosphates according to different weight ratios. The mixtures of the YDC and binary phosphates were ground and sintered at 1 400 ℃. The proton conductivity in solid electrolyte of the sintered samples was examined using electrochemical methods at 400～800 ℃. Ammonia was synthesized from nitrogen and hydrogen at atmospheric pressure in the solid state proton conducting cell reactor. The optimal condition for the ammonia production was determined. The result indicated that composite electrolyte of 80wt% YDC: 20wt% binary phosphates as proton conductor could obtain the highest ionic conductivity and ammonia production rate among the four samples, the rate of evolution of ammonia was up to 9.5 × 10^-9 mol·s^-1·cm^-2.     

氧化锌薄膜的电化学沉积和表征

以透明导电玻璃(TCO)为衬底，用硝酸锌水溶液作为电解液，研究了阴极还原沉积ZnO薄膜的反应机理和电化学行为. 通过改变工艺条件来控制ZnO的生长速率， 得到了粒径为10～15 nm的纳米ZnO薄膜. XRD分析显示纳米ZnO薄膜纯度高， 呈纤锌矿结构. 光学测试结果表明，在可见光区其透光度高达90%，禁带宽度为3.37 eV.     

Polyacrylate/silica nanocomposite materials prepared by sol-gel process

Polyacrylate/silica nanocomposite was prepared by sol-gel process via in situ emulsion polymerization. The influence of the synthetic conditions, such as the ratio of different monomers and the contents of tetraethoxysilane (TEOS), γ-methacryloxypropyltrimethoxysilane (Z-6030), diethanolamine (DAM) and ammonium persulfate (APS) on the physical mechanical properties of polyacrylate/silica nanocomposite was investigated in details. Dynamics Laser Scattering (DLS) indicated that the average diameter of the polyacrylate/silica latex particles (177 nm) was bigger than that of the pure polyacrylate latex particles (105.3 nm), but the ζ potential of polyacrylate/silica was decreased respectively in contrast to that of the polyacrylate. Differential Scanning Calorimeters (DSC) analysis confirmed that the glass transition temperature of polyacrylate/nano-SiO₂ (T_g = −24 °C) was higher than that of polyacrylate (T_g = −36 °C). UV analysis showed that the UV absorbency of polyacrylate/silica was improved evidently in contrast to that of polyacrylate.     

Effect of Co substitution for Ni on the microstructure and electrochemical properties of La-R-Mg-Ni-based hydrogen storage alloys

Hydrogen storage alloys La_0.63Gd_0.2?Mg_0.17Ni_3.35?x Co _x Al_0.15 (x?=?0, 0.1, 0.3, 0.5, 1.0, 1.5, 2.0) were prepared by induction melting followed by annealing treatment in argon atmosphere. The electrochemical properties of La_0.63Gd_0.2?Mg_0.17Ni_3.35?x Co _x Al_0.15 (x?=?0, 0.1, 0.3, 0.5, 1.0, 1.5, 2.0) alloy electrodes depended on the alloy structure type. XRD patterns and EPMA showed that the alloys consisted of Ce₂Ni₇-type (Gd₂Co₇-type), CaCu₅-type, Pr₅Co₁₉-type, and PuNi₃-type phase structure. Pr₅Co₁₉-type and Ce₂Ni₇-type phase increased with the increase of Co content x. However, CaCu₅-type phase firstly decreased then increased as Co content increased. Rietveld analysis showed that the c-axis lattice parameters and cell volumes of the component phases increased with increasing Co content. The electrochemical measurements showed that as the Co content increased, the maximum discharge capacity and the cyclic stability of the annealed alloys both first increased and then decreased. The La_0.63Gd_0.2?Mg_0.17Ni_3.05Co_0.3Al_0.15 alloy electrode exhibited the maximum discharge capacity (392.92 mAh/g), and La_0.63Gd_0.2?Mg_0.17Ni_1.85Co_1.5Al_0.15 alloy electrode showed the best cyclic stability (S₁₀₀?=?96.1 %). The electrochemical kinetics studies indicate that La_0.63Gd_0.2?Mg_0.17Ni_1.85Co_1.5Al_0.15 exhibited a higher rate dischargeability (HRD₉₀₀?=?86.3 %). Electrochemical analyses showed that the control process of alloy electrode reaction is charge-transfer rate in surface film of alloy.     

热声波数值模拟的虚假振荡研究

采用可压缩流动的SIMPLE算法对一维封闭空腔内由边界突然加热所引起的非稳态热声波进行了数值模拟,对流-扩散项采用了中心差分、一阶迎风差分、QUICK、及MIJSCL等不同格式。计算表明各种格式均存在不同程度的虚假振荡现象,其大小与热声波的强度及离散格式的形式等多种因素有关。这些结果对热声波的进一步研究及高效可靠的对流差分格式的开发具有重要意义。     

氯参与的化学气相淀积金刚石的热力学分析

用非平衡热力学耦合模型研究了金刚石在CHCl体系中的生长,计算所得CHCl体系的金刚石生长的相图与大量实验结果符合良好.通过热力学分析讨论了氯的添加对提高金刚石薄膜生长速率及其质量的影响以及降低淀积温度的作用.     

制备2，2′，4，4′-联苯四甲酸的新方法

氨基甲基苯甲酸;联苯四甲酸;合成;偶联;重氮盐     

由藜芦醛合成娃儿藤碱

以藜芦醛(1)、3,4-二甲氧基苯乙酸(2)、(S)-L-脯氨酸(6)等为原料,经8步反应,合成了一种抗肿瘤活性(s)-( )-娃儿藤碱。先由化合物1和2在乙酸酐/三乙胺催化下反应得到3,4-二甲氧基一反式-α-(3′, 4′-二甲氧基苯基)．肉桂酸(3),在0℃、三氟乙酸存在下用VOF_3对其关环成2,3,6,7-四甲氧基-9-羧基菲(4),然后用喹啉作介质,在230℃、无水CuSO_4催化下脱去羧基,得到2,3,6,7-四甲氧基菲(5),再和(S)-N- (三氟乙酰)-L-脯氨酰氯(6b)傅-克反应得到(S)-N-(三氟乙酰基)-2,3,6,7-四甲氧基-9-L-脯氨酰基菲(7),并对产物进行了柱纯化,所得产物在三氟化硼乙醚存在下用三乙基硅烷还原羰基,然后脱去三氟乙酰保护基,最后在盐酸存在下用甲醛闭环得到目标产物(10)。用NMR和MS表征了中间体和目标产物的结构。该合成反应条件温和,总收率为3．5％,产品纯度98．5％(HPLC)。     

钪与氧空位共掺杂锐钛矿相TiO2的形成能与电子结构的第一性原理研究

采用基于密度泛函理论的第一性原理研究了钪(Sc)、氧空位(O_V)单/共掺杂锐钛矿相TiO₂,对晶体结构、形成能以及电子结构进行了对比分析.研究结果表明,Sc-TiO₂在富氧环境下缺陷形成能为负值,富钛环境下缺陷形成能为正值,表明Sc-TiO₂只能在富氧环境下制备;O_V-TiO₂、Sc-O_V-TiO₂在富氧或富钛环境下缺陷形成能均为负值,但富氧环境下形成能更低;O_V-TiO₂的0/1-缺陷电荷转变能级为深能级,而Sc-TiO₂的0/1-缺陷电荷转变能级则属于相对较浅能级;与纯锐钛矿相TiO₂相比,Sc-TiO₂的禁带宽度略有减小,但O_V-TiO₂、Sc-O_V-TiO₂禁带宽度变宽.