Multicyclic polyethers derived from 1,1,1‐tris(4‐hydroxyphenyl)ethane and 2,6‐dihalopyridines

Poly(pyridine ether)s were prepared in two ways: the polycondensation of silylated 1,1,1‐tris(4‐hydroxyphenyl)ethane (THPE) with 2,6‐difluoropyridine (method A) and the polycondensation of free THPE with 2,6‐dichloropyridine (method B). With method A, the THPE/difluoropyridine feed ratio was varied from 1.0:1.0 to 1.0:1.6. Cycles, bicycles, and multicycles were the main reaction products, and crosslinking was never observed. When ideal stoichiometry was used exclusively, multicycles free of functional groups were obtained. These multicycles were detectable in matrix‐assisted laser desorption/ionization time‐of‐flight (MALDI‐TOF) mass spectra up to B₃₈C₇₆ with a mass of approximately 32,000 Da. With method B, the reaction conditions were varied at a fixed feed ratio to achieve an optimum for the preparation of multicyclic polyethers, but because of the lower reactivity of 2,6‐dichloropyridine, a quantitative conversion was not achieved. The reaction products were characterized with MALDI‐TOF mass spectrometry, viscosity measurements, and size exclusion chromatography. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5725–5735, 2004     

Effect of humidity on the adsorption kinetics of lung surfactant at air-water interfaces

The in vitro adsorption kinetics of lung surfactant at air-water interfaces is affected by both the composition of the surfactant preparations and the conditions under which the assessment is conducted. Relevant experimental conditions are surfactant concentration, temperature, subphase pH, electrolyte concentration, humidity, and gas composition of the atmosphere exposed to the interface. The effect of humidity on the adsorption kinetics of a therapeutic lung surfactant preparation, bovine lipid extract surfactant (BLES), was studied by measuring the dynamic surface tension (DST). Axisymmetric drop shape analysis (ADSA) was used in conjunction with three different experimental methodologies, i.e., captive bubble (CB), pendant drop (PD), and constrained sessile drop (CSD), to measure the DST. The experimental results obtained from these three methodologies show that for 100% relative humidity (RH) at 37 degrees C the rate of adsorption of BLES at an air-water interface is substantially slower than for low humidity. It is also found that there is a difference in the rate of surface tension decrease measured from the PD and CB/CSD methods. These experimental results agree well with an adsorption model that considers the combined effects of entropic force, electrostatic interaction, and gravity. These findings have implications for the development and evaluation of new formulations for surfactant replacement therapy.     

Effects of final-state interaction and screening on strange- and heavy-quark production

Final-state interaction and screening have a great influence on $q\bar q$ production cross sections, which are important quantities in many problems in quark-gluon plasma physics. They lead to an enhancement of the cross section for a $q\bar q$ color-singlet state and a suppression for a color-octet state. The effects are large near the production threshold. The presence of screening gives rise to resonances for $q\bar q$ production just above the threshold at specific plasma temperatures. These resonances, especially $c\bar c$ and $b\bar b$ resonances, may be utilized to search for the quark-gluon plasma by studying the temperature dependence of heavy-quark pair production just above the threshold.     

Affinity chromatography of porcine pepsin A using quinolin-8-ol as ligand

Stationary phase containing quinolin-8-ol immobilized on macroporous methacrylate support for the affinity chromatography of porcine pepsin A is described. Optimized chromatographic conditions for separation of porcine pepsin A on this stationary phase were found investigating the influence of pH, concentration, ionic strength and chemical composition of the used mobile phases. The stationary phase shows a good reproducibility of chromatographic analyses (relative standard deviation, +/-2%), a high recovery (ca. 93%) and a satisfactory capacity (13 mg pepsin A/1 mL stationary phase) for porcine pepsin A. The obtained findings confirm the applicability of affinity chromatography on the stationary phase with immobilized quinolin-8-ol to the isolation and determination of porcine pepsin A.     

Enhanced performance of expanded bed chromatography on rigid superporous adsorbent matrix

Rigid spherical macroporous adsorbent beads with surface hydroxyl groups were prepared by cross-linking of cellulose. These beads had diameter in the range 100-200 microm and a mean pore size of about 3 microm with about 60% pore volume. The matrix (bulk density approximately 1600 kg m(-3)) could be expanded into a stable bed and used for protein chromatography. Chromatographic runs were performed on a 10 mm diameter column under non-retaining and retaining conditions on the prepared matrix (called Celbeads) and performance of the runs was measured in terms of the height equivalent to a theoretical plate (HETP). The HETP curves in both packed and expanded bed modes followed profiles typical of macroporous adsorbents, i.e. increasing and levelling with velocity. Unimpaired performance of the matrix at increasing flow-rates permitted expanded bed elution of adsorbed solutes without loss of efficiency in terms of purification factor and product concentration. As a model system, Celbeads was used to purify lactate dehydrogenase from porcine muscle homogenate by dye-affinity chromatography. The prepared matrix provided about 100 theoretical plates per meter for the enzyme system at a linear flow velocity of 1.27 cm x min(-1) in an expanded bed elution mode, and gave enzyme yields of 100% with a purification factor of 31 using an optimized procedure. The adsorbent could be cleaned in place with 5 M urea and used repeatedly without loss of performance.     

Advanced Sensing of Antibiotics with Magnetic Gold Nanocomposite: Electrochemical Detection of Chloramphenicol

The sensing and accurate determination of antibiotics in various environments represents a big challenge, mainly owing to their widespread use in medicine, veterinary practice, and other fields. Therefore, a new, simple electrochemical sensor for the detection of antibiotic chloramphenicol (CAP) has been developed in this work. The amplification strategy of the sensor is based on the application of magnetite nanostructures stabilized with carboxymethyl cellulose (Fe₃O₄‐CMC) and decorated with nanometer‐sized Au nanoparticles (NPs) (Fe₃O₄‐CMC@Au). In this case, CMC serves as a stabilizing agent, preventing the aggregation of Fe₃O₄ NPs, and hence, enabling the kinetic barrier for electron transport to be overcome, and the Au NPs serve as an electron‐conducting tunnel for better electron transport. As a proof of concept, the developed nanosensor is used for the detection of CAP in human urine samples, giving a recovery value of around 97 %, which indicates the high accuracy of the as‐prepared nanosensor.     

Antimicrobial properties of viscose yarns ring-spun with integrated amino-functionalized nanocellulose

Cellulose - Bio-based, renewable and biodegradable products with multifunctional properties are also becoming basic trends in the textile sector. In this frame, cellulose nanofibrils (CNFs) have...     

Separation of terbutaline enantiomers in capillary electrophoresis with neutral cyclodextrin-type chiral selectors and investigation of the structure of selector-selectand complexes using nuclear magnetic resonance spectroscopy

The major goal of this study was to determine the affinity pattern of the terbutaline (TB) enantiomers toward α-, β-, γ-, and heptakis(2,3-di-O-acetyl)-β-cyclodextrins and using NMR spectroscopy for the understanding of the fine mechanisms of interaction between the cyclodextrins (CD) and TB enantiomers. It was shown once again that CE in combination with NMR spectroscopy represents a sensitive tool to study the affinity patterns and structure of CD complexes with chiral guests. Opposite affinity patterns of TB enantiomers toward native α- and β-CDs were associated with significant differences between the structure of the related complexes in solution. In particular, the complex between TB enantiomers and α-CD was of the external type, whereas an inclusion complex was formed between TB enantiomers and β-CD. One of the possible structures of the complex between TB and heptakis(2,3-di-O-acetyl)-β-CD (HDA-β-CD) was quite similar to that of TB and β-CD, although the chiral recognition pattern and enantioselectivity of TB complexation with these two CDs were very different.     

Enhancement of temozolomide stability by loading in chitosan-carboxylated polylactide-based nanoparticles

In the presented work, amphiphilic nanoparticles based on chitosan and carboxy-enriched polylactic acid have been prepared to improve the stability of the pro-drug temozolomide in physiological media by encapsulation. The carrier, with a diameter in the range of 150–180 nm, was able to accommodate up to 800 μg of temozolomide per mg of polymer. The obtained formulation showed good stability in physiological condition and preparation media up to 1 month. Temozolomide loaded inside the carrier exhibited greater stability than the free drug, in particular in simulated physiological solution at pH 7.4 where the hydrolysis in the inactive metabolite was clearly delayed. CS-SPLA nanoparticles demonstrated a pH-dependent TMZ release kinetics with the opportunity to increase or decrease the rate. Mass spectroscopy, UV-Vis analysis, and in vitro cell tests confirmed the improvement in temozolomide stability and effectiveness when loaded into the polymeric carrier, in comparison with the free drug.