Simultaneous determination of hypoxanthine,inosine, inosine-5′-phosphate and adenosine-5′-phosphate with a multielectrode enzyme sensor

A multielectrode enzyme sensor for the simultaneous determination of adenosine-5′-phosphate (AMP), inosine-5′-phosphate (IMP), inosine (HXR) and hypoxanthine (HX)in fish meat was developed by assembling four enzyme sensors for AMP, IMP, HXR and HX in a flow cell. These compounds were determined from oxygen consumption according to the following reactions: AMP $\text{AD}$ IMP $\text{NT}$ HXR $\text{NP, PO}{}^{\mathrm{3?}}{}_4$ HX $\text{XO, O}{}_2$ Uric acid where AD is AMP deaminase, NT is 5′-nucleotidase, NP is nucleoside phosphorylase and XO is xanthine oxidase. Enzymes were covalently bound to a membrane prepared from cellulose triacetate, 1,8-diamino-4-aminomethyloctane and glutaraldehyde. Sensors for HX, HXR, IMP and AMP were prepared by attaching membranes of XO, XONP, XO NPNT, and of XONPNT and AD, respectively, to four oxygen electrodes. Samples extracted from sea bass, bream, flounder, abalone and arkshell were analyzed within 5 min, from the simultaneous response curves of the four electrodes. Results obtained by the multisensor system were in good agreement with those determined by each single electrode.     

A potentiometric microbial sensor based on immobilized escherichia coli for glutamic acid

The sensor consists of immobilized E. coli (which contains glutamate decarboxylase) and a carbon dioxide gas-sensor. Continuous introduction of sample solution into a flow system incorporating the sensor gives a potential which increases until a steady state is reached after 5 min. Measurements can also be made with only a 1- or 3-min introduction period with little loss of sensitivity. Calibration plots of mV measurements vs. logarithmic glutamic acid concentration are linear in the range 100–800 mg l^-1. The sensor is highly selective, stable and reproducible. It has been applied to the determination of glutamic acid in fermentation broths.     

A mediator-type biosensor as a new approach to biochemical oxygen demand estimation

A novel biosensor for the determination of biochemical oxygen demand (BOD) was developed using potassium hexacyanoferrate(III) [HCF(III)] as a mediator. The sensor element consists of a three-electrode system, with both working and counter electrodes compactly integrated as a disposable using etching and electroplating processes. Pseudomonas fluorescens biovar V (isolated from a wastewater treatment plant) was immobilized on the surface of the working electrode using poly(vinyl alcohol)-quaternized stilbazol (PVA-SbQ) photopolymer gel. Synthetic wastewater described by the Organization for Economic Cooperation and Development (OECD) was used as a standard solution instead of glucose-glutamic acid synthetic wastewater. The conditions of amperometric measurement were optimized at +600 mV (vs. Ag/AgCl) operating potential, namely 40 mM HCF(III) in a 0.1 M phosphate buffer (pH 7.0) at 20 degrees C. The sensor response was linear from 15 up to 200 mg O l-1 BOD. The response time was 15 min at 200 mg O l-1 BOD. To demonstrate the wide metabolic range of activity of the sensor, the sensor response to 14 substances in four categories of organic compounds was investigated. Further, it was shown that the response of this BOD sensor was not influenced in samples with low concentrations of dissolved oxygen under the measuring conditions used. For real wastewaters, the BOD values were determined using the sensor and compared favorably with those determined by the conventional BOD5 method.     

Selective flow-injection determination of methanol in the presence of ethanol based on a multi-enzyme system with chemiluminescence detection

A highly selective flow-injection system was developed for the determination of methanol. The system consisted of three immobilized enzymes with luminol chemiluminescence detection. First, methanol was oxidized in the presence of alcohol oxidase to yield formaldehyde and hydrogen peroxide. The hydrogen peroxide produced was then destroyed by catalase. The formaldehyde formed in the first stage was further oxidized by NAD⁺-formaldehyde dehydrogenase. The NADH formed was oxidized by 1-methoxy-5-methylphenazinium methylsulphate (1-MPMS), and finally the reduced 1-MPMS was spontaneously oxidized and hydrogen peroxide was produced. The concentration of the hydrogen peroxide produced, which was proportional to the initial concentration of methanol, was determined by luminol chemiluminescence. The determination range was from 0.1 to 100 mg l⁻¹ and the response time was less than 2 min per sample with a relative standard deviation of less than 3%. The system showed good selectivity for methanol; the response was ca. 50 times higher than for ethanol.     

Site-selective RNA cleavage by DNA bearing a base pair-mimic nucleoside

We have synthesized the deoxyadenosine derivative tethering a phenyl group (X), which mimics the Watson-Crick A/T base pair. The RNA/DNA hybrid duplexes containing X in the middle of the DNA sequence showed a similar thermal stability regardless of the ribonucleotide species (A, G, C, or U) opposite to X, probably because of the phenyl group stacking inside of the duplex accompanied by the opposite ribonucleotide base flipped in an extrahelical position. The RNA strand hybridized with the DNA strand bearing X was cleaved on the 3'-side of the ribonucleotide opposite to X in the presence of MgCl2, and the RNA sequence to be cleaved was not restricted. The site-specific RNA hydrolysis suggests that the DNA strand bearing X has the advantage of the site-selective base flipping in the target sequence and the development of a "universal deoxyribozyme" to exclusively cleave a target RNA sequence.     

Continuous Photoreduction of Methyl Viologen Using Disubstituted Terthiophenes and EDTA in Aqueous Solution

The continuous photoreduction of methyl viologen by 5,5″-bis(aminomethyl)-2,2′:5′,2″-terthiophene (AT) and 2,2′:5′,2″-terthiophene-5,5″-dicarboxylic acid (CT), using EDTA as a sacrificial electron donor, has been investigated in aqueous solution at various pH. Apparent rates and efficiencies of production of the methyl viologen radical cation (MV⁺) were found to be dependent on the pH, the concentrations of all three components and the intensity of the incident light. The highest conversion efficiency (77%) was shown by the bis(aminoniethyI (-substituted terthiophene AT at pH 7.7. The quantum yield for the formation of MV⁺ under these conditions was 0.24, which is comparable with other common systems     

Micromachined Enzyme Reactor for FIA System

An enzyme reactor consisting of a 2.6-m-long silicon capillary with glucose oxidase immobilized on the inner surface was fabricated using micromachining techniques. A V-shaped groove of 100 μm width, formed by anisotropic etching, was anodically bonded to a glass plate to create the capillary. Glucose oxidase was covalently immobilized with 3-aminopropyltriethoxysilane and glutaraldehyde. The reactor was evaluated by connecting it to a Flow injection analysis system for glucose detection. Glucose concentrations were in the range of 10⁻³ to 5 × 10⁻²M with a volume of 0.2 μl of glucose solution.     

Development of a chemical vapor sensor using piezoelectric quartz crystals with coated unusual lipids

Piezoelectric quartz crystal sensors were developed using lipids with various properties for highly sensitive detection of chemical vapors. Lipids with varying lengths of alkyl chains were coated onto 10 MHz AT-cut quartz crystal resonators and the response of these modified crystals to chemical vapors were measured. It was shown that hydrophilic compounds, such as ethanol and methanol, could be recognized efficiently by lipids having shorter alkyl chains, whereas lipids with longer alkyl chains showed affinity to more hydrophobic vapors, such as toluene, hexane and cyclohexane. Frequency changes caused by adsorption of alcohols could be enhanced when cholesterol was co-immobilized in the lipid layer. To confirm the assumption that the sensor-response might be affected by the properties of lipids derived from acyl chains, we have examined the effects of two types of newly synthesized unusual lipids on sensor response. When lipids having one triple bond each at different positions on their alkyl chains were coated onto quartz crystals separately, lower responses were observed compared to responses obtained for a sensor with immobilized, saturated phosphatidylcholine. Lipids containing -branched acyl chains, however, showed good affinity for organic vapors, and sensor responses improved 4–5-fold. Moreover, these sensors were shown to have sensitivity of the same order as the humans' sense of smell (10⁻⁵–10⁻⁶ w/w in liquid paraffin) when measured using standard odorants (isovaleric acid, skatole, etc.) for an olfactometry established in Japan.     

Application of plasma-polymerized films for isoelectric focusing of proteins in a capillary electrophoresis chip

The first use of plasma polymerization technique to modify the surface of a glass chip for capillary isoelectric focusing (cIEF) of different proteins is reported. The electrophoresis separation channel was machined in Tempax glass chips with length 70 mm, 300 microm width and 100 microm depth. Acetonitrile and hexamethyldisiloxane monomers were used for plasma polymerization. In each case 100 nm plasma polymer films were coated onto the chip surface to reduce protein wall adsorption and minimize the electroosmotic flow. Applied voltages of 1000 V, 2000 V and 3000 V were used to separate mixtures of cytochrome c (pI 9.6), hemoglobin (pI 7.0) and phycocyanin (pI 4.65). Reproducible isoelectric focusing of each pI marker protein was observed in different coated capillaries at increasing concentration 2.22-5 microg microL(-1). Modification of the glass capillary with hydrophobic HMDS plasma polymerized films enabled rapid cIEF within 3 min. The separation efficiency of cytochrome c and phycocyanin in both acrylamide and HMDS coated capillaries corresponded to a plate number of 19600 which compares favourably with capillary electrophoresis of neurotransmitters with amperometric detection.