Simultaneous Determination of Four Flavonoids in Pigeonpea [Cajanus cajan (L.) Millsp.] Leaves Using RP-LC-DAD

A simple and accurate RP-HPLC method using photodiode array detection (PAD) was developed for the simultaneous determination of four flavonoids, namely quercetin (QU),luteolin(LU),apigenin(AP) and isorhamnetin (IS) in pigeonpea leaves.Extract samples were separated on HIQ SIL C₁₈V column using methanol-acetonitrile-water(31:10:59, v/v/v) as mobile phase.The flavonoids were detected at 254.5 nm for QU and IS, and at 345 nm for LU and AP.Contents were determined with satisfactory repeatability (R. S. D. < 2.2%) and recovery (97.27 – 99.98%). The developed method was found to be simple and efficient.     

罗布麻纤维与丙烯酸酯类接枝共聚物结构和性能的研究

本文以氧化还原体系引发丙烯酸甲酯(MA)、丙烯酸乙酯(EA)、丙烯酸丁酯(BA)与罗布麻纤维的接枝共聚反应,用IR、SEM和X-射线衍射等手段表征了接枝纤维的结构。与纯罗布麻纤维相比较,接枝纤维具有较高的断裂伸长率和较低的杨氏模量,柔顺性增加;耐酸、碱能力随接枝率的增加而提高,但吸湿率不降。     

亲水性交联聚合物载体的合成表征及其固定化α-淀粉酶

选用丙烯酰胺(AM)、N-羟基琥珀酰亚胺为单体(NHS),以N,N/-亚甲基双丙烯酰胺(MBAA)为交联剂,以乙醇水溶液为制孔剂条件下进行反相悬浮聚合,得到珠状共聚物载体,该载体是一种新的酶载体形式,在国内外的相关文献中均未见报道.用红外光谱、扫描电子显微镜测定其结构和表观活性.结果表明,在固定单体配比[W(AM)/W(NHS)=10∶1]和致孔剂用量的情况下,测得交联剂用量为4%时,交联聚合物载体的溶胀性最好(287.5%);交联剂用量为5%时,交联聚合物载体固定化α-淀粉酶表现出高的表观活性(522.53U/g).测得固定化酶载体表现出良好的操作稳定性.比较固定化酶和游离态酶的最适反应温度发现,固定化酶的最适反应温度(70℃)比游离态酶高20℃;固定化酶的最适反应pH值范围较游离态酶广.     

Hydrogen-bonded 1D and 2D Assemblies of Tetraiso-butyl-resorcin[4]arene in the Crystalline State

1 INTRODUCTION There is continuing interest in the assembly of molecular capsules based on concomitant formation of multiple hydrogen bonds between smaller mole- cular components[1]. A particularly attractive buil- ding block is calix[4]resorcinarenes with eight pen- dant hydroxyl functional groups[2]. In a crystal engi- neering design strategy for molecular self-assembly, cocrystallization of C-methylcalix[4]resorcinarenes with nitrogen-donor molecules such as pyridines in the presence …     

攒尖四坡屋面风致雪漂移的数值模拟

为获得攒尖四坡屋面的风致雪漂移规律,基于欧拉-欧拉方法和风雪单向耦合假定,运用计算流体动力学软件,选取Mixture模型分别对立方体周边和高低屋面上的风致雪漂移运动进行数值模拟,将模拟结果与两者的实地观测数据对比,探讨分析数值风洞的关键技术和参数设置,验证数值模拟方法的合理性与可靠性。依据攒尖四坡房屋的使用功能要求,设计分析模型与分析工况,在试算的基础上对屋面进行分区。以风速5 m/s,7 m/s,9 m/s,11 m/s,13 m/s和15 m/s,风向角0°,15°,30°和45°以及屋面坡度25°,30°,34°,40°和45°为分析参数,对攒尖四坡房屋的120种工况进行数值模拟,得到屋面各分区侵蚀沉积的基本规律,提出可用于抗雪设计的屋面积雪分布系数。研究表明,风向角的改变会使屋面积雪分布状态发生较大程度的变化,风速和屋面坡度的变化对屋面整体积雪量有较大影响。     

明胶-海藻酸钙复合膜胶囊萃取Cr2O72-的传质动力学研究

采用胶囊化技术制备三辛胺(TOA)的明胶-海藻酸钙复合膜胶囊,考察其在硫酸介质中萃取Cr2O72-的传质动力学．通过对渗透系数的测定,得出了适于微胶囊萃取的最佳条件:海藻酸钠质量浓度为0.7％,明胶质量浓度为5％-6％,V水／V油=3 :2。     

Imaging Photodissociation Dynamics of MgO at 193 nm

In this work, we used time-sliced ion velocity imaging to study the photodissociation dynamics of MgO at \mbox{193 nm}. Three dissociation pathways are found through the speed and angular distributions of magnesium. One pathway is the one-photon excitation of MgO(X\begin{document}$^1\Sigma^+$\end{document}) to MgO(G\begin{document}$^1\Pi$\end{document}) followed by spin-orbit coupling between the G\begin{document}$^1\Pi$\end{document}, 3\begin{document}$^3\Pi$\end{document} and 1\begin{document}$^5\Pi$\end{document} states, and finally dissociated to the Mg(\begin{document}$^3$\end{document}P\begin{document}$_\textrm{u}$\end{document})+O(\begin{document}$^3$\end{document}P\begin{document}$_\textrm{g}$\end{document}) along the 1\begin{document}$^5\Pi$\end{document} surface. The other two pathways are one-photon absorption of MgO(A\begin{document}$^1\Pi$\end{document}) state to MgO(G\begin{document}$^1\Pi$\end{document}) and MgO(4\begin{document}$^1\Pi$\end{document}) state to dissociate into Mg(\begin{document}$^3$\end{document}P\begin{document}$_\textrm{u}$\end{document})+O(\begin{document}$^3$\end{document}P\begin{document}$_\textrm{g}$\end{document}) and Mg(\begin{document}$^1$\end{document}S\begin{document}$_\textrm{g}$\end{document})+O(\begin{document}$^1$\end{document}S\begin{document}$_\textrm{g}$\end{document}), respectively. The anisotropy parameters of the dissociation pathways are related to the lifetime of the vibrational energy levels and the coupling of rotational and vibronic spin-orbit states. The total kinetic energy analysis gives \begin{document}$D_0$\end{document}(Mg\begin{document}$-$\end{document}O)=21645\begin{document}$\pm$\end{document}50 cm\begin{document}$^{-1}$\end{document}.     

基于波动模态耦合的铝电解槽磁流体稳定性傅立叶级数法分析

铝电解槽内磁流体稳定性对铝电解生产有重要影响。本文结合铝电解槽实体仿真的电磁场计算结果,应用傅立叶级数法对槽内磁流体波动稳定性进行数值计算,并对波动的模态耦合问题进行了重点分析。在此基础上,本文以某320kA铝电解槽为研究载体分析了槽长宽比设计对磁流体稳定性的影响,结果表明:波动的不稳定分量集中分布在频谱图中重力波模态密集的低频区域;不考虑母线对体系的影响,增大槽的长宽比,有利于提高磁流体的稳定性。     

����ѹ��Ƶ�����ŵ����Ե���ֵģ���о�

Based on diffuse and drift assumption, a 1-D fluid model of atmospheric pressure oxygen RF discharge was developed. The model includes continuity equations for electrons, positive and negative ions, and energy equation, and Poisson equation for eclectic potential. The finite difference method was adopted to solve the model by numerical simulation. The simulation results show that the electron density and electron temperature were 10¹²cm^-3 and 1.23eV, respectively, and the main negative ion was O^- . As the peak of voltage increased, the electron density and electron temperature increased, however, the ratio of O^-/n_e had a maximum value at 700V.     

胶束电动毛细管色谱间接紫外光检测法分离胆汁酸

利用间接紫外光检测法在254 nm进行胆汁酸胶束电动毛细管色谱分离的研究.在对氨基苯磺酸为背景电解质和十二烷基硫酸钠作胶束的体系中,加入高浓度的尿素,有效地改善了两类胆汁酸5组份的分离度,在优化分离缓冲体系10 mmol/L对氨基苯磺酸-5 mmol/L硼砂-30 mmol/LSDS-7 mol/L尿素-10%乙醇(pH 7.5)中,13 min内获得基线分离,分离效率为8.4×104～1.1×105.所建立的方法无需衍生化处理,为胆汁酸的分离提供了新的通用的方法.