Estimation of growth rate in unidirectionally solidified multicrystalline silicon by the growth-induced striation method

Multicrystalline silicon was grown by unidirectional solidification method using the accelerated crucible rotation technique. The application of the accelerated crucible rotation technique in unidirectional solidification method induced growth striations across the axial direction of the grown crystal. This striation pattern was observed from carbon concentration distribution, obtained by using Fourier transform infrared spectroscopy. The generated striation pattern was found to be weak and discontinuous. Some striations were absent, probably due to back melting, caused during each crucible rotation. From the growth striations and applied time period in crucible rotation, the growth rate was estimated by using Fourier transformation analysis.     

Integral Representations,Differentiability Properties and Limits at Infinity for Beppo Levi Functions

The first aim in the present paper is to give an integral representation for Beppo Levi functions on R ⁿ. Our integral representation is an extension of Sobolev's integral representation given for infinitely differentiable functions with compact support. As applications, continuity and differentiability properties of Beppo Levi functions are studied.Our second aim in this paper is to study the existence of limits at infinity for Beppo Levi functions. We also consider the existence of fine-type limits at infinity with respect to Bessel capacities, which yields the radial limit result at infinity.     

Complex impedance spectra of chip inductor using Li–Zn–Cu–Mn ferrite

A multi-layer chip inductor (MCI) was fabricated using polycrystalline Li–Zn–Cu–Mn ferrite and the green-sheet technique, and its complex impedance spectrum was evaluated with the help of numerical calculations. The complex impedance spectra of the MCI component using Ni–Zn–Cu ferrite, which have been widely used for this application, were very sensitive to the residual stress and deviated much from the calculated values; however, it was found that the complex impedance spectrum of the MCI component using Li–Zn–Cu–Mn ferrite is quite well reproduced by calculation, where the complex permittivity and permeability of the polycrystalline ferrite as well as the MCI dimensions, were used. It implied that the magneto-striction effect was negligible in case of MCI using Li–Zn–Cu–Mn ferrite, and that the difference was related to magneto-strictive coefficient of the polycrystalline ferrite. Consequently, utilization of Li–Zn–Cu–Mn ferrite enabled us to easily design the complex impedance of MCI component.     

Hydrolysis of acetals in water under hydrothermal conditions

A simple method for the hydrolysis of acetals and ketals was accomplished in neutral water or aqueous media by hydrothermal treatment without using acidic reagents. The deacetalization reaction was effectively accelerated in the presence of calcium chloride. Because no acidic catalysts were employed, neutralization of the reaction mixture was not necessary after the reaction. This sequence was successfully applied to the hydrolysis of chitosan, a biodegradable polyaminosaccharide.     

Intake of different chemical species of dietary arsenic by the japanese,and their blood and urinary arsenic levels

We calculated the intake of each chemical species of dietary arsenic by typical Japanese, and determined urinary and blood levels of each chemical species of arsenic. The mean total arsenic intake by 35 volunteers was 195±235 (15.8-1039) μg As day^?1, composed of 76% trimethylated arsenic (TMA), 17.3% inorganic arsenic (As_i), 5.8% dimethylated arsenic (DMA), and 0.8% monomethylated arsenic (MA): the intake of TMA was the largest of all the measured species. Intake of As_i characteristically and invariably occurred in each meal. Of the intake of As_i, 45-75% was methylated in vivo to form MA and DMA, and excreted in these forms into urine. The mean measured urinary total arsenic level in 56 healthy volunteers was 129±92.0 μg As dm^?3, composed of 64.6% TMA, 26.7% DMA, 6.7% As_i and 2.2% MA. The mean blood total arsenic level in the 56 volunteers was 0.73±0.57 μg dl^?1, composed of 73% TMA, 14% DMA and 9.6% As_i. The urinary TMA levels proved to be significantly correlated with the whole-blood TMA levels (r = 0.376; P<0.01).     

Fluorescent humic substances–arsenic complex in well water in areas where blackfoot disease is endemic in Taiwan

The relationship between the four components, (1) fluorescence intensity, (2) arsenic concentration, (3) pH and (4) total dissolved solids, (TDS) measured in well waters from areas in Taiwan where blackfoot disease (BFD) is endemic was studied, as well as the relationships between the four degrees of BFD and each of the above four symptomatic components, in order to evaluate the etiological factors of BFD more progressively. The following 95% confidence intervals were obtained in well water samples (n = 1189): fluorescence intensity, 26.837–32.570; arsenic concentration, 0.103–0.127 mg dm^?3; pH, 7.466–7.519; and TDS 733.063–801.647 mg dm^?3. Fluorescence intensities of the four degrees of BFD were not all the same (F = 64.54, P < 0.001), and nor were arsenic concentrations (F = 72.03, P < 0.001), pH values (F = 7.30, P < 0.001), nor TDS values (F = 10.76, P < 0.001). In addition, multiple comparisons indicate that the higher the epidemical degree, the higher the fluorescence intensities, arsenic concentrations and pH values become; however, such a relationship is not found for TDS values. Moreover, the fluorescence intensities have positive linear correlations with arsenic concentrations (r = 0.49, P < 0.001), pH (r = 0.25, P < 0.001), and TDS (r = 0.18, P < 0.001), as do the arsenic concentrations with pH (r = 0.22, P < 0.001). Of the four epidemical degree groups, pairs are not significantly different from one another in correlation coefficients between fluorescence intensity and arsenic concentration, which implies a steady relationship between fluorescent compounds and arsenic. We conclude that fluorescent compounds in well water, as possible etiological factors of BFD, are closely related to arsenic along with pH and TDS values in the areas where BFD is endemic. In addition, we infer that a complex is formed by fluorescent compounds, arsenic and other metals.     

Design of a widely tunable laser with a chirped ladder filter

We theoretically investigated a digitally tunable laser with a chirped ladder filter and a ring resonator to obtain a wide wavelength tuning range covering the whole C- or L- band. The clear relation between the tuning range and laser structure, especially the ladder filter, is described analytically. The introduction of a chirped structure into a ladder filter is effective in achieving both wide tunability and a stable lasing mode. A numerical simulation based on multimode rate equations shows that a tuning range of over 40 nm and a mode suppression ratio over 40 dB can be achieved by introducing a chirped ladder filter.     

A SAXS study of the nanometer scale hybrid structure of Si---Ti---C---O amorphous fibers

A small-angle X-ray scattering (SAXS) study was performed to reveal the nanometer scale hybrid structure of Si---Ti---C---O fibers prepared by the pyrolysis of polytitanocarbosilane. The SAXS profile for Si---Ti---C---O fibers is attributed to two different types of scattering entities: an anisotropic contribution from long filaments with diameters hundreds to thousands of Ångströms and an isotropic contribution from β-SiC fine clusters of about a nanometer in diameter. A drastic degradation in the tensile strength of the fibers is correlated to the characteristic variations in their long-and medium-range structure.     

Crystal structure of the clathrate of 5,12-dihydro-5,12-o-benzenonaphthacene-1,4-dione with benzene (2:1).

In the crystal of the title compound, the quinone fragment of the host (1) participates in weak D-A interactions with a neighboring naphthalene moiety of 1 and with the guest molecule via fairly short intermolecular face-to-face contacts. An intermolecular electrostatic interaction between a quinone-oxygen atom and a neighboring quinone ring is suggested by short O...C contacts. There exist several C-H...O hydrogen bonds, one of which seems to contribute to the formation of a centrosymmetric dimer of 1.