Mechanism of BPh3-Catalyzed N-Methylation of Amines with CO2 and Phenylsilane: Cooperative Activation of Hydrosilane

BPh₃ catalyzes the N-methylation of secondary amines and the C-methylenation (methylene-bridge formation between aromatic rings) of N,N-dimethylanilines or 1-methylindoles in the presence of CO₂ and PhSiH₃; these reactions proceed at 30–40 °C under solvent-free conditions. In contrast, B(C₆F₅)₃ shows little or no activity. ¹¹B NMR spectra suggested the generation of [HBPh₃]⁻. The detailed mechanism of the BPh₃-catalyzed N-methylation of N-methylaniline ( 1 ) with CO₂ and PhSiH₃ was studied by using DFT calculations. BPh₃ promotes the conversion of two substrates (N-methylaniline and CO₂) into a zwitterionic carbamate to give three-component species [Ph(Me)(H)N⁺CO₂⁻⋅⋅⋅BPh₃]. The carbamate and BPh₃ act as the nucleophile and Lewis acid, respectively, for the activation of PhSiH₃ to generate [HBPh₃]⁻, which is used to produce key CO₂-derived species, such as silyl formate and bis(silyl)acetal, essential for the N-methylation of 1 . DFT calculations also suggested other mechanisms involving water for the generation of [HBPh₃]⁻ species.     

Roles of SiH4 and SiF4 in growth and structural changes of poly-Si films

The structural properties of polycrystalline silicon films, prepared by plasma enhanced chemical vapor deposition system, with different flow rates of SiH₄/SiF₄ mixtures at 300 °C were investigated. This study indicates that the low hydrogen coverage on the growing surface, under optimum fluorine radicals, will be leaded to an improvement of crystallized area as compared with case of high hydrogen coverage surface. Moreover, the studies of the role of SiH₄ and SiF₄ radicals show that the SiH₄ radicals are important in the nucleation and growth of grains. However, SiF₄ radicals are effective in the structural change of grain boundaries regions and by this way, in the present system, establish the growth of grains under the dominant 〈1 1 0〉 direction. The stress investigation indicates that addition of high flow rate of SiF₄ in amorphous film, results in the nearly stress free films. Finally, we found that the changes in g-value reflect the changes in the intrinsic compressive and tensile stress in the both polycrystalline and amorphous silicon films.     

Estimation of growth rate in unidirectionally solidified multicrystalline silicon by the growth-induced striation method

Multicrystalline silicon was grown by unidirectional solidification method using the accelerated crucible rotation technique. The application of the accelerated crucible rotation technique in unidirectional solidification method induced growth striations across the axial direction of the grown crystal. This striation pattern was observed from carbon concentration distribution, obtained by using Fourier transform infrared spectroscopy. The generated striation pattern was found to be weak and discontinuous. Some striations were absent, probably due to back melting, caused during each crucible rotation. From the growth striations and applied time period in crucible rotation, the growth rate was estimated by using Fourier transformation analysis.     

Classification for dimethylarsenate-decomposing bacteria using a restrict fragment length polymorphism analysis of 16S rRNA genes.

A new monitoring system for bacterial communities involving dimethylarsinic acid (DMAA) decomposition was provided by combining the MPN (Most Probable Number) method and RFLP (restriction-fragment-length polymorphism analysis). The abundance of DMAA decomposing bacteria was estimated by the MPN method using a bacterial culture medium, which included DMAA as the sole carbon source, indicating bacterial cell densities of 1700 cells/ml in Lake Kahokugata and 330 cells/ml in Lake Kibagata. After isolating the dominant bacteria using agar plates, the isolates were classified into some genotype groups by RFLP analysis using 16S rDNA sequences. Classification of the RFLP analysis indicated that 14 isolates of Lake Kahokugata were classified into 6 types, which included 2 dominant types related to genus Pseudomonas, while 8 isolates of Lake Kibagata displayed 6 types including one or two isolates. Moreover, the RFLP types were unique for each lake, suggesting that DMAA decomposing bacteria were specific for the aquatic environment related to the arsenic cycle. The activities of DMAA decomposition mostly matched with the RFLP type category of the isolates. Accordingly, combining the MPN method with the RFLP analysis will play an important role in elucidating the distributions and dynamics of the DMAA-decomposing bacterial community.     

Integral Representations,Differentiability Properties and Limits at Infinity for Beppo Levi Functions

The first aim in the present paper is to give an integral representation for Beppo Levi functions on R ⁿ. Our integral representation is an extension of Sobolev's integral representation given for infinitely differentiable functions with compact support. As applications, continuity and differentiability properties of Beppo Levi functions are studied.Our second aim in this paper is to study the existence of limits at infinity for Beppo Levi functions. We also consider the existence of fine-type limits at infinity with respect to Bessel capacities, which yields the radial limit result at infinity.     

Complex impedance spectra of chip inductor using Li–Zn–Cu–Mn ferrite

A multi-layer chip inductor (MCI) was fabricated using polycrystalline Li–Zn–Cu–Mn ferrite and the green-sheet technique, and its complex impedance spectrum was evaluated with the help of numerical calculations. The complex impedance spectra of the MCI component using Ni–Zn–Cu ferrite, which have been widely used for this application, were very sensitive to the residual stress and deviated much from the calculated values; however, it was found that the complex impedance spectrum of the MCI component using Li–Zn–Cu–Mn ferrite is quite well reproduced by calculation, where the complex permittivity and permeability of the polycrystalline ferrite as well as the MCI dimensions, were used. It implied that the magneto-striction effect was negligible in case of MCI using Li–Zn–Cu–Mn ferrite, and that the difference was related to magneto-strictive coefficient of the polycrystalline ferrite. Consequently, utilization of Li–Zn–Cu–Mn ferrite enabled us to easily design the complex impedance of MCI component.     

High-throughput characterization of local conductivity of Nd0.9Ca0.1Ba2Cu3O7−δ thin film by the low-temperature scanning microwave microscope

We developed a scanning microwave microscope (SμM) designed for high-throughput electric-property screening as well as for rapid construction of electronic phase diagrams at low temperatures. As a sensor probe, we used a high-Qλ/4 coaxial cavity resonator to which a thin needle with ball-tip end was attached. The sensor module was mounted on the low-temperature XYZ stage, which allowed us to map out the change of resonance frequency and quality factor due to the local tip-sample interaction at low temperatures. From the measurements of combinatorial thin films, such as Ti_1−xCo_xO_2−δ and Nd_0.9Ca_0.1Ba₂Cu₃O_7−δ (NCBCO), it was demonstrated that this SμM system has enough performance for the high-throughput characterization of sample conductance under variable temperature conditions.     

Hydrolysis of acetals in water under hydrothermal conditions

A simple method for the hydrolysis of acetals and ketals was accomplished in neutral water or aqueous media by hydrothermal treatment without using acidic reagents. The deacetalization reaction was effectively accelerated in the presence of calcium chloride. Because no acidic catalysts were employed, neutralization of the reaction mixture was not necessary after the reaction. This sequence was successfully applied to the hydrolysis of chitosan, a biodegradable polyaminosaccharide.     

Collection of iron(III) from homogeneous aqueous solutions on membrane filters using Chromazurol B with Triton X-100.

A membrane filtration method was examined concerning the effective collection of iron(III) from a homogeneous aqueous solution with Chromazurol B (CAB), one of the triphenylmethane dyes, as a precipitating reagent in the presence of a non-ionic surfactant, polyethylene glycol mono[4-(1,1,3,3-tetramethylbutyl)phenyl]ether (Triton X-100). A formed blue Fe(III)-CAB complex was collected as a precipitate on a membrane filter by filtration under suction from a homogeneous aqueous solution in the pH range over about 2. The original solution was prepared at a concentration ratio of CAB to Fe(III) of to 10, and that of Triton X-100 to CAB of 10 to 100. It was then adjusted to a pH value of between 1.0 and 6.5. A linear relationship (r = 0.999) was obtained between the initial concentration and the found one of Fe(III) in the range of 2.0 x 10(-5) to 4.0 x 10(-4) mol dm(-3) at a fixed concentration ratio of CAB to Fe(III) of 3 and that of Triton X-100 to CAB of 20. This membrane filtration with CAB and Triton X-100 may be utilized for the separation of Fe(III) as a background species.     

An experiment to measure collisionless radial transport ofenergetic electrons confined by a dipole magnetic field

A new laboratory terrella has been constructed in order to study collisionless radial diffusion of particles trapped within a dipole magnetic field. Columbia's collisionless terrella experiment (CTX) aims to reproduce the process of wave-induced radial transport and does not try to simulate magnetospheric structure. The first experiment planned for CTX is the direct measurement of stochastic radial diffusion induced from wave-particle drift resonances. The motivation for the CTX experiment is described, and the procedures to be used to measure the intensity and spectrum of fluctuations generating chaos, the rate of radial transport, and the evolution of the density and pressure profiles are illustrated. Because of the success of similar experiments conducted earlier in a long thin magnetic mirror, these dipole experiments can be performed with a high degree of confidence. An example from these earlier experiments is presented