基于邻域贡献权值细化的圆心亚像素定位算法

针对传统的圆心算法过程复杂、定位精度受初始边缘提取效果影响较大等问题,提出了一种基于邻域贡献权值细化的圆心亚像素定位算法。首先引入邻域贡献权值系数,改进传统非极大值抑制法,细化边缘;然后在边缘点的梯度方向对灰度值进行高斯拟合,确定亚像素边缘位置;最后针对边缘突变点提出了基于随机抽样一致的最小二乘法来拟合圆心。实验结果表明,该算法具有较好的精度和稳定性,圆心的提取精度可以达到0.1个像素。     

Synthesis of an adhesion‐enhancing polysiloxane containing epoxy groups for addition‐cure silicone light emitting diodes encapsulant

Addition‐cure silicone resin is considered as a good choice for light emitting diodes (LEDs); however, it has very poor adhesion to the substrate, which limits its practical application. A novel polysiloxane with self‐adhesion ability and higher refractive index for the encapsulating of high‐power LEDs is prepared and characterized. This polysiloxane containing vinyl groups, phenyl groups, and epoxy groups was synthesized by a sol‐gel condensation process from methacryloxy propyl trimethoxyl silane, γ‐(2,3‐epoxypropoxy)propytrimethoxysilane, and diphenylsilanediol under the catalysis of an anion exchange resin. Then, the resin‐type encapsulation material was prepared by hydrosilylation of methylphenyl hydrogen‐containing silicone resin and the newly synthesized polysiloxane material. The novel polysiloxane was characterized by ¹H‐NMR and Fourier transform infrared spectroscopy. On the basis of higher refractive index, higher transparency, excellent thermal stability, and appropriate hardness, as well as good adhesive strength between the encapsulating material and the LED lead frame (polyphthalamide), the curable silicone resin‐type encapsulation material can be used as an encapsulant for LEDs. Copyright © 2014 John Wiley & Sons, Ltd.     

Enantioseparation of acetyltropic acid by countercurrent chromatography with sulfobutyl ether‐β‐cyclodextrin as chiral selector

Acetyltropic acid is an important synthetic intermediate for preparation of tropane alkaloid derivatives, which can be used as anticholinergic drugs, deliriants, and stimulants. In the present work, acetyltropic acid was successfully enantioseparated by countercurrent chromatography using sulfobutyl ether‐β‐cyclodextrin as chiral selector. A biphasic solvent system composed of n‐butyl acetate/n‐hexane/0.1 mol/L citrate buffer at pH = 2.2 containing 0.1 mol/L of sulfobutyl ether‐β‐cyclodextrin (7:3:10, v/v) was selected, which produced a suitable distribution ratio D_S = 1.14, D_R = 2.31 and a high enantioseparation factor α = 2.03. Baseline separation was achieved for preparative enantioseparation of 50 mg of racemic acetyltropic acid. A method for chiral analysis of acetyltropic acid by conventional reverse phase liquid chromatography with hydroxylpropyl‐β‐cyclodextrin as mobile phase additive was established, and formation constants of inclusion complex were determined. It was found that different substituted β‐cyclodextrin should be selected for enantioseparation of acetyltropic acid by countercurrent chromatography and reverse phase liquid chromatography.     

Durable antimicrobial cotton fabric fabricated by carboxymethyl chitosan and quaternary ammonium salts

Cellulose - In this article, carboxymethyl chitosan (CMC) and (3-carboxypropyl) trimethylammonium chloride (CPTC) were used as raw materials to prepare an antibacterial cotton fabric with excellent...     

Second-order hydroelastic analysis of a floating plate in multidirectional irregular waves

Based on an analysis of second-order hydrodynamic forces induced by coupling of first-order wave potentials, second-order hydroelastic equations are established and solved in the frequency domain. The responses of a very large floating structure in multidirectional irregular waves are studied. The characteristics of the difference and sum frequency coordinates are discussed in detail; peaks can be found at the difference and sum frequencies close to the wet resonant frequencies of each mode. We present and analyze the maximum vertical displacement of different points as well as the time history of the vertical displacements of selected points. The differences of the combined (the summation of the linear and non-linear responses) and linear displacements of the selected points are calculated. Our results demonstrate that non-linear fluid forces influence the total responses of the referenced floating structure.     

Comparative Study of Tribological Properties of Polyphenylene Sulfide (PPS), Polyethersulfone (PES), and Polysulfone (PSU)

The tribological properties of polyphenylene sulfide (PPS), polyethersulfone (PES) and polysulfone (PSU), which have similar molecular structures, were investigated using an end-face contact tribometer and a reciprocating tribometer. The thermomechanical behavior of the polymers was analyzed using dynamic mechanical analysis (DMA). PPS exhibited a maximum friction coefficient with increasing load and sliding speed, while the friction coefficients of PES and PSU decreased only slightly. The wear rate of PPS was much lower than that of PES and PSU under high loads and speeds. It is suggested that the main factors influencing the friction and wear properties of the neat polymers are their condensed state and heat resistance. Amorphous PES and PSU showed liquid-like behavior and very low friction when the frictional surface was in the molten-flow state. The macromolecular crystals of crystallizable PPS give it some solid-like behavior and load-carrying capacity; hence PPS exhibited lower wear than PES and PSU.     

Effect of phosphorus (P) on the structure and reactivity of biochars produced from the pyrolysis of acid-washed biomass loaded with P of various forms

This paper investigates the effect of phosphorus (P) on char structure and reactivity of char prepared from the fast pyrolysis of purposely-prepared P-loaded biomass samples at 1000 °C in absence of other inorganic species. Biomass was first acid-washed then loaded with P of three different occurrence forms (one organic P i.e. phytic acid, and two inorganic P i.e. orthophosphoric acid and polyphosphoric acid) at the same P content of 0.8 wt%. Experimental results show that both organic and inorganic P substantially increase char yields during pyrolysis from 6.2% for the biomass sample without P to 23.0–26.0% for P-loaded samples due to the enhanced crosslinking by P-containing structures in char, leading to increases in the char C and H contents and decrease in O content. The presence of P in biochars from fast pyrolysis of various P-loaded biomass samples plays important role in the evolution of char structure and intrinsic reactivity measured during low-temperature oxidation at 500 °C in air under chemical-reaction-controlled regime. After pyrolysis and subsequent char oxidation, all P in biomass either as organic or inorganic P are found to be present in forms of acid-insoluble organic structures. For char prepared from acid-washed wood, char reactivity increases with char conversion due to the increasing pore surface area at higher conversion. Comparatively, for char prepared from acid-washed wood loaded with various P at char conversion below 60%, the presence of P increases char intrinsic reactivity due to the enhanced crosslinking of reactive carbon structures and reduced condensation of char structures. However, at conversions above 60%, P-containing species in char lead to a significant decrease in char reactivity, due to the formation of abundant CO-P bonds, that is highly resistant to the oxidation in air, in the reacting chars.     

任意温度密度下的原子结构计算

本文用含有电子自作用修正的TF势求解了任意温度物质密度下的Schrodinger波动方程。为了能够处理相对论效应,波动方程中又引入了质速修正项和Darwin项以及自旋-轨道耦合修正项。本文着重计算了Fe、Rb在几种温度密度下的情况,并在表中给出了计算结果与更准确结果的比较。用现行方法获得的数据与HFS方法的结果也是可以媲美的。     

Research Progress and Application of Single-Atom Catalysts: A Review

Due to excellent performance properties such as strong activity and high selectivity, single-atom catalysts have been widely used in various catalytic reactions. Exploring the application of single-atom catalysts and elucidating their reaction mechanism has become a hot area of research. This article first introduces the structure and characteristics of single-atom catalysts, and then reviews recent preparation methods, characterization techniques, and applications of single-atom catalysts, including their application potential in electrochemistry and photocatalytic reactions. Finally, application prospects and future development directions of single-atom catalysts are outlined.