Control of self‐organized low‐dimensional morphology in poly(styrene‐b‐4vinylpyridine)/polystyrene blend thin films

The surface morphologies of poly(styrene‐b‐4vinylpyridine) (PS‐b‐P4VP) diblock copolymer and homopolystyrene (hPS) binary blend thin films were investigated by atomic force microscopy as a function of total volume fraction of PS (?_PS) in the mixture. It was found that when hPS was added into symmetric PS‐b‐P4VP diblock copolymers, the surface morphology of this diblock copolymer was changed to a certain degree. With ?_PS increasing at first, hPS was solubilized into the corresponding domains of block copolymer and formed cylinders. Moreover, the more solubilized the hPS, the more cylinders exist. However, when the limit was reached, excessive hPS tended to separate from the domains independently instead of solubilizing into the corresponding domains any longer, that is, a macrophase separation occurred. A model describing transitions of these morphologies with an increase in ?_PS is proposed. The effect of composition on the phase morphology of blend films when graphite is used as a substrate is also investigated. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3496–3504, 2004     

二氧化钛光催化体系中的羟基自由基的测定

通过ESR光谱测定表明TiO2悬浮液在紫外光照射下产生羟基自由基氧化物种.羟基自由基氧化酸性桃红(sulforhodamine B,SRB)使其褪色,在565 nm处用分光光度法测定其吸光度值的变化,可间接测定羟基自由基的生成量.确定了体系的最佳实验条件pH为2.5;SRB浓度为2.0×10-5mol/L;TiO2浓度为0.1 g/L;光照时间为12 min.采用抗坏血酸为羟基自由基清除剂,测定了其自由基清除率,表明拟定该体系可作为筛选抗氧化剂的方法之一.     

Shape-controlled synthesis of copper colloids with a simple chemical route

The new electrical and optical properties of nanomaterials depend sensitively on both size and shape, which are of both fundamental and technological interest. This paper introduces a simple chemical method to produce copper particles, which has the ability to shape the particle without using any capping agent or template. In our synthetic procedure, the reactant concentration and temperature exerted a strong influence on the shape of the copper particles. At low reactant concentrations, the particles were cubic; at high reactant concentrations, obtained particles were spherical. The number of hollow particles greatly increased when the synthesis was performed at low temperature. We also synthesized a copper cubic ring at lower temperature, and it has been rarely reported. The absorption spectrum of hollow particles showed obvious red shifts, which suggests the possible assembly of novel optical materials.     

Synthesis and utilization of monodisperse hollow polymeric particles in photonic crystals

We developed a process to fabricate 150-700 nm monodisperse polymer particles with 100-500 nm hollow cores. These hollow particles were fabricated via dispersion polymerization to synthesize a polymer shell around monodisperse SiO(2) particles. The SiO(2) cores were then removed by HF etching to produce monodisperse hollow polymeric particle shells. The hollow core size and the polymer shell thickness, can be easily varied over significant size ranges. These hollow polymeric particles are sufficiently monodisperse that upon centrifugation from ethanol they form well-ordered close-packed colloidal crystals that diffract light. After the surfaces are functionalized with sulfonates, these particles self-assemble into crystalline colloidal arrays in deionized water. This synthetic method can also be used to create monodisperse particles with complex and unusual morphologies. For example, we synthesized hollow particles containing two concentric-independent, spherical polymer shells, and hollow silica particles which contain a central spherical silica core. In addition, these hollow spheres can be used as template microreactors. For example, we were able to fabricate monodisperse polymer spheres containing high concentrations of magnetic nanospheres formed by direct precipitation within the hollow cores.     

贵金属纳米材料的液相合成及其表面等离子体共振性质应用

金属中的表面等离子体共振是描述其导带电子在电磁场作用下集体振荡的一个物理概念。金属纳米颗粒由于其表面等离子体共振性质表现出独特的光学应用。本文在相关研究的基础上,综述了具备表面等离子体共振性质的不同形貌及多种复合结构的贵金属纳米材料的制备和应用,并对其发展及应用前景进行了展望。     

Nanoscopic surface patterns of diblock copolymer thin films

The surface topography of thin diblock copolymer films is studied by atomic force microscopy (AFM). With AFM an island-to-ribbon transition is observed for symmetric polystyrene-b-poly (4-vinylpyridine) (PS-b-P4VP) on mica with increasing solution concentration. Our study also demonstrates how the formation of the pattern strongly depends on the copolymer composition based on the volume fraction. The substrate and solvent used both have great effects on the morphology of the thin films. Only by using highly polar substrate (mica), can we gain regular pattern. The reason why the regular islands cannot be obtained with symmetric PS-b-P4VP on graphite is also explained. On mica using nonselective and selective solvents, a rather regular pattern can be obtained. The difference is only in the solution concentration for forming regular patterns.     

An investigation of meterial properties of non-homogeneous cylindrically orthotropic circular plates

It has been been reported that the reduced stiffness of non-homogeneous cylindricallyorthotrpic circular plate varing exponentially with radius r is obtained by using thebending theory of a simple beamThe aim of this paper is to verify the effect of radius on the materal properties According to the flat stress-strain relation the values of material properties E_r E_a and v_θr which are the functions of radius r are obtained.Compared with the experimentalvalues the analytical values of the material properties are in essential agreement withtem.     

Phase behavior of poly(sulfobetaine methacrylate)-grafted silica nanoparticles and their stability in protein solutions

Biocompatible and zwitterionic poly(sulfobetaine methacrylate) (PSBMA) was grafted onto the surface of initiator-modified silica nanoparticles via surface-initiated atom transfer radical polymerization. The resultant samples were characterized via nuclear magnetic resonance, Fourier transform infrared spectroscopy, transmission electron microscopy, and thermogravimetric analysis. Their molecular weights and molecular weight distributions were determined via gel permeation chromatography after the removal of silica by etching. Moreover, the phase behavior of these polyzwitterionic-grafted silica nanoparticles in aqueous solutions and stability in protein/PBS solutions were systematically investigated. Dynamic light scattering and UV-visible spectroscopy results indicate that the silica-g-PSBMA nanoparticles exhibit an upper critical solution temperature (UCST) in aqueous solutions, which can be controlled by varying the PSBMA molecular weight, ionic strength, silica-g-PSBMA nanoparticle concentration, and solvent polarity. The UCSTs shift toward high temperatures with increasing PSBMA molecular weight and silica-g-PSBMA nanoparticle concentration. However, increasing the ionic strength and solvent polarity leads to a lowering of the UCSTs. The silica-g-PSBMA nanoparticles are stable for at least 72 h in both negative and positive protein/PBS solutions at 37 °C. The current study is crucial for the translation of polyzwitterionic solution behavior to surfaces to exploit their diverse properties in the development of new, smart, and responsive coatings.     

一类二阶积分型发展方程反周期解问题

本文中,我们研究一类带有非单调扰动算子的二阶非线性发展方程的反周期问题,证明方程中的非单调扰动算子为极大单调的,并用极大单调算子的微单调扰动理论来证明此类方程的反周期解的存在性。     

Responsive DNA‐Based Hydrogels and Their Applications

The term hydrogel describes a type of soft and wet material formed by cross‐linked hydrophilic polymers. The distinct feature of hydrogels is their ability to absorb a large amount of water and swell. The properties of a hydrogel are usually determined by the chemical properties of their constituent polymer(s). However, a group of hydrogels, called “smart hydrogels,” changes properties in response to environmental changes or external stimuli. Recently, DNA or DNA‐inspired responsive hydrogels have attracted considerable attention in construction of smart hydrogels because of the intrinsic advantages of DNA. As a biological polymer, DNA is hydrophilic, biocompatible, and highly programmable by Watson‐Crick base pairing. DNA can form a hydrogel by itself under certain conditions, and it can also be incorporated into synthetic polymers to form DNA‐hybrid hydrogels. Functional DNAs, such as aptamers and DNAzymes, provide additional molecular recognition capabilities and versatility. In this Review, DNA‐based hydrogels are discussed in terms of their stimulus response, as well as their applications.