全文获取类型
收费全文 | 878篇 |
免费 | 182篇 |
国内免费 | 260篇 |
专业分类
化学 | 587篇 |
晶体学 | 37篇 |
力学 | 63篇 |
综合类 | 28篇 |
数学 | 135篇 |
物理学 | 470篇 |
出版年
2023年 | 9篇 |
2022年 | 22篇 |
2021年 | 24篇 |
2020年 | 35篇 |
2019年 | 32篇 |
2018年 | 35篇 |
2017年 | 41篇 |
2016年 | 17篇 |
2015年 | 45篇 |
2014年 | 62篇 |
2013年 | 74篇 |
2012年 | 55篇 |
2011年 | 64篇 |
2010年 | 64篇 |
2009年 | 84篇 |
2008年 | 80篇 |
2007年 | 79篇 |
2006年 | 77篇 |
2005年 | 75篇 |
2004年 | 54篇 |
2003年 | 29篇 |
2002年 | 33篇 |
2001年 | 54篇 |
2000年 | 46篇 |
1999年 | 20篇 |
1998年 | 13篇 |
1997年 | 6篇 |
1996年 | 10篇 |
1995年 | 5篇 |
1994年 | 14篇 |
1993年 | 8篇 |
1992年 | 10篇 |
1991年 | 6篇 |
1990年 | 5篇 |
1989年 | 4篇 |
1988年 | 1篇 |
1987年 | 3篇 |
1986年 | 2篇 |
1985年 | 3篇 |
1984年 | 4篇 |
1983年 | 4篇 |
1982年 | 3篇 |
1981年 | 3篇 |
1980年 | 2篇 |
1976年 | 1篇 |
1974年 | 2篇 |
1973年 | 1篇 |
排序方式: 共有1320条查询结果,搜索用时 15 毫秒
1.
静止轨道卫星差分吸收光谱仪采用摆扫成像方式对大气进行探测,针对其工作时CCD成像系统信噪比大于1 000、高速探测模式下探测周期小于10min、高分辨率模式下探测周期小于1h的要求,进行CCD成像系统设计.选取CCD47-20作为探测器,设计成像电路实现光谱图像信号的采集和上传.分析了帧叠加和像元合并对时间、空间分辨率的影响.结合帧转移CCD的特点设计了每个位置最后一帧读出时摆镜转动的成像方式,并合理设置了帧叠加数和像元合并数,达到优化成像周期的目的.1s曝光时间条件下,该CCD成像系统的高速、高分辨率模式探测周期分别为515s和3 315s,图像信噪比均大于1 000,污染物观测实验中未出现失帧或重复的现象.该CCD成像系统方案满足静止轨道星载差分吸收光谱仪的探测需求,为静止轨道环境监测仪器设计提供参考. 相似文献
2.
3.
1引言大粘度(大r)和大系数(ss和sc)法是处理流动区域中障碍物的常用方法山。但当流动区域中障碍物数量较多时,宜采用空隙率来模拟障碍物,如模拟反应堆流动传热的商用程序COMMIX[’]。我们根据空隙率模拟的基本概念,针对采用交错网格的压力校正法,自行编制了多障碍物流动传热三维计算的全部源程序代码,应用于某核反应堆钠池流动传热的数值模拟,获得了比较合理的结果。2数学模型和数值方法2.1控制方程空隙率修整的质量、动量、能量及湍流动能与耗散率的守恒方程通式的三维柱坐标形式为其中中一1,。,。,。,T,k,。分别表… 相似文献
4.
Outline imaging by THz time domain spectroscopy is proposed. Spectroscopic splitting at interface is reported, The principle of outline imaging is put forward. Experimental results demonstrate the feasibility of outline imaging by spectroscopic splitting, It is shown that clear out:line image of sample interface could be achieved easily by this technique. The spatial resolution is about 0.6mm. The THz-beam focus, the scanning step and the THz pulse width are the critical foctors affecting the imaging resolution. The signal-to-noise ratio of this technique could be improved greatly compared to the conventional transsion imaging. 相似文献
5.
用HFR方法对CaⅨ-KrⅩⅩⅤ离子3s2,3s3p,3s3d,3p2组态能级结构进行了理论计算.在已有实验研究的基础上,通过分析离子能级沿等电子序列的变化规律,运用最小二乘拟合方法预言计算了GeⅩⅪ-SeⅩⅩⅢ离子3s2,3s3p,3s3d,3p2组态14条精细结构能级值.在此基础上,进一步计算了GeⅩⅪ-SeⅩⅩⅢ离子3s2-3s3p,3s3p-3s3d和3s3p-3p2跃迁的23条谱线波长和相应的振子强度.计算结果与已有的实验值十分吻合,波长的最大不确定度为0.008 nm. 相似文献
6.
聚异丁烯高活性端基含量及相对分子质量测定方法的研究 总被引:2,自引:0,他引:2
综合使用核磁,VPO和近红外光谱分析技术对聚异丁烯活性端基含量以及相对分子质量的测定进行了详细研究,分别建立核测定聚异丁烯活性端基含量以及其他烯键含量和近红外光谱快速测量聚异聚丁烯活性端基含量。其他烯键含量和相对分子质量的分析方法。成对t检验结果表明,近红外光谱分析方法测定结果与核磁和VPO方法测定结果之间无显著性差异。 相似文献
7.
Pinning effect of lead lanthanum titanate (PLT) ferroelectric thin films with excess PbO of 20 mol% has been studied for deposition on diffe rent substrates. Silicon, sapphire and quartz were used as substrates on which P t/Ti or LaNiO3 thin films were deposited as bottom electrodes. Electron probe analysis results showed that there was still a certain amount of excess Pb in PLT films after annealing at 550 ℃ for 1 h, and the amount of it was dependent on the substrate used. The distribution of excess Pb in the films was investig ated by Auger electron spectroscopy depth profile. It was shown that the substrates and the bottom electrodes had significant effects on the content and distrib ution of excess Pb in PLT films. The excess Pb and its accumulation at the inter face between the film and bottom electrode may act as pinning centers and have a pinning effect on domains, which can be observed by abnormal P-E hysteresis loops and abnormal C-V curves. The excess Pb content in the films and the accumulation of Pb at the interface were high in PLT films deposited on Pt/Ti/S i, and considerable pinning effect was observed. As LaNiO3 would absorb most part of the excess Pb in PLT films, the content of excess Pb in the films deposited on LaNiO3/Si was very low and the pinning effect was hardly observed. 相似文献
8.
采用纳米化学技术制备了新型的纳米复合固体超强酸催化剂SO42-/ZrO2-Fe2O3,并用XRD、TEM进行了表征.结果表明:所研制的SO42-/ZrO2-Fe2O3催化剂为晶态纳米粒子,平均粒径为30 nm,分散性较好;当活化温度为580℃,反应温度为75℃,n(硝酸)/n(苯)=2,m(苯)/m(催化剂)=20,催化反应时间5 h时,硝基苯收率可达89.6%. 相似文献
9.
XI Jingyu QIU Xinping ZHU Wentao & CHEN Liquan Department of Chemistry Tsinghua University Beijing China 《中国科学B辑(英文版)》2005,48(6)
All solid-state lithium polymer batteries may be one of the best choices for the future electrochemical power source, characterized by high energy densities, good cyclability, reliability and safety[1,2]. Owing to its potential capability to replace the t… 相似文献
10.
The effect of polystyrene sulfonic acid (PSSA) macromolecules on the polymerization of acrylamide (AM) has been studied. It was found that the rates of polymerization of AM were greatly increased in the presence of PSSA in the polymerization system.The maximum value of the rate of polymerization of AM was obtained when the ratio of [—SO_3H]: [AM] reached 3:1. When the insoluble crosslinked PSSA was used instead of the soluble one, this effect decreased considerably. The interaction between molecules of PSSA and AM was determined by infrared spectroscopy, elementary analysis and X-ray photoelectron spectroscopy. The combination form, —SO_3-NH_3~ CO—, formed between sulfonic group and amide group was found to be existed since the infrared absorption band of —NH_2 shifted from 3400cm~(-1) to 3150 cm~(-1), the binding energy of electron N_(18) changed from 399.7 eV to 401.3 eV, and the atomic ratio of N to S of the products was similar to the ratio of reagents. Based on these experimental results, the mechanism of AM polymerization in the presence of PSSA is proposed. The initial step is the combination of AM with sulfonic group to form —CONH_3~ , then followed by polymerization on the PSSA macromolecule. The role of PSSA on the polymerization of AM is discussed. 相似文献