Litharge, the red tetragonal form of lead oxide α-PbO and massicot, the yellow orthorhombic form β-PbO, are synthesized from
lead(II) salts in aqueous media at elevated temperatures. Scanning electron microscopy (SEM) and X-ray diffraction (XRD) were
used to characterize the size, morphology, and crystallographic structural forms of the products. The role of impurities in
the experimental synthesis of the materials and microstructural variations in the final products are described. The implications
of these observations regarding the synthesis of different conducting lead oxides and other related materials are discussed.
PACS 71.20.Ps; 72.80.Jc; 74.62.Bf; 74.62.Dh; 75.50.Tt 相似文献
Tobacco has long been considered as a host to produce large quantity of high-valued recombinant proteins. However, dealing with large quantities of biomass is a challenge for downstream processing. Aqueous two-phase extraction (ATPE) has been widely used in purifying proteins from various sources. It is a protein-friendly process and can be scaled up easily. In this paper, ATPE was studied for its applicability to recombinant protein purification from tobacco with egg white lysozyme as the model protein. Separate experiments with poly(ethylene glycol) (PEG)-salt-tobacco extract and PEG-salt-lysozyme were carried out to determine the partition behavior of tobacco protein and lysozyme, respectively. Two-level fractional factorial designs were used to study the effects of factors such as, PEG molecular mass, PEG concentration, the concentration of phase forming salt, sodium chloride concentration and pH, on protein partitioning. The results showed that, among the studied systems, PEG-sodium sulfate system was most suitable for lysozyme purification. Detailed experiments were conducted by spiking lysozyme into the tobacco extract. The conditions with highest selectivity of lysozyme over native tobacco protein were determined using a response surface design. The purification factor was further improved by decreasing the phase ratio along the tie line corresponding to the phase compositions with the highest selectivity. Under selected conditions the lysozyme yield was predicted to be 87% with a purification factor of 4 and concentration factor of 14. From this study, ATPE was shown to be suitable for initial protein recovery and partial purification from transgenic tobacco. 相似文献
The protocol and various matrices were examined for quantification of biomolecules in both the low ca. 1200 amu and mid mass 6000-12000 amu ranges using an internal standard. Comparative studies of different matrices of MALDI quantitative analysis showed that the best accuracy and standard curve linearity were obtained for two matrices: (a) 2,5-dihydroxybenzoic acid (DHB) combined with a comatrix of fucose and 5-methoxysalicylic acid (MSA) and (b) ferulic acid/fucose. In the low mass range, the quantitative limit was in the 30 fmol range and in the mid mass range the quantitative limit was in the 250 fmol range. Linear response was observed over 2-3 decades of analyte concentration. The relative error of the standard curve slope was 1.3-1.8% with correlation coefficients of 0.996-0.998.The main problem for quantitative measurement was suppression of the signal of the less concentrated component (analyte or internal standard) by the more concentrated component. The effect was identified with saturation of the matrix by the analyte. The threshold of matrix saturation was found to be in the range of 1/(3000-5000) analyte/matrix molar ratio. To avoid matrix saturation the (analyte+internal standard) to matrix molar ratio should be below this threshold. Thus the internal standard concentration should be as low as possible.DHB/MSA/fucose and ferulic acid/fucose matrices demonstrated good accuracy and linearity for standard curves even when the internal standard had chemical properties different from the analyte. However, use of an internal standard with different chemical properties requires highly stable instrumental parameters as well as constant (analyte+internal standard)/matrix molar ratio for all samples. 相似文献
The enthalpy, ΔH = ?64.7 ± 4 kJ mol?1, for the reaction Pt(PPh3)2(η-C2H4)(s) + pcbd(g) → Pt(PPh3)2(η-pcbd)(s) + C2H4(g) where pcbd is 3-phenylcyclobutene-1,2-dione, , has been measured calorimetrically. The Ptolefin bond in this complex is slightly stronger than that in Pt(PPh3)2(η-PhCHCH2). 相似文献
The unseeded non-hydrolytic sol-gel synthesis of ZrW2O8 and ZrMo2O8 produces trigonal ZrM2O8 (M = W, Mo) at 740 and 300–400°C, respectively. Cubic ZrW2O8 can be prepared using non-hydrolytic sol-gel methods by seeding with small amounts of preprepared cubic material, and the formation of the trigonal polymorph can be suppressed completely. Seeds with a small particle size are necessary for the preparation of cubic ZrW2O8. In contrast, seeding of ZrMo2O8 gels with either cubic ZrMo2O8 or cubic ZrW2O8 only lowers the temperature at which the trigonal phase crystallizes. 相似文献