Radical polymerization of methyl methacrylate in the presence of stereoregular poly(methyl methacrylate). V. Kinetics of initial template polymerization

The influence of stereoregular poly(methyl methacrylate) (PMMA) as a polymer matrix on the initial rate of radical polymerization of methyl methacrylate (MMA) has been measured between ?11 and +60°C using a dilatometric technique. Under proper conditions an increase in the relative initial rate of template polymerization with respect to a blank polymerization was observed. Viscometric studies showed that the observed effect could be related to the extent of complex formation between the polymer matrix and the growing chain radical. The initial rate was dependent on tacticity and molecular weight of the matrix polymer, solvent type and polymerization temperature. The accelerating effect was most pronounced (a fivefold increase in rate) at the lowest polymerization temperature with the highest molecular weight isotactic PMMA as a matrix in a solvent like dimethylformamide (DMF), which is known to be a good medium for complex formation between isotactic and syndiotactic PMMA. The acceleration of the polymerization below 25°C appeared to be accompanied by a large decrease in the overall energy and entropy of activation. It is suggested that the observed template effects are mainly due to the stereoselection in the propagation step (lower activation entropy Δ S_p^?) and the hindrance of segmental diffusion in the termination step (higher activation energy Δ E_t^?) of complexed growing chain radicals.     

Rheological behavior of precursor PPV monolayers

The rheological behavior of different precursor poly(p-phenylene vinylene) (prec-PPV) monolayers at the air-water interface was investigated using an interfacial stress rheometer (ISR). This device nicely reveals a transition of the precursor poly(2,5-dimethoxy-1,4 phenylene vinylene) (prec-DMePPV) monolayer from Newtonian to elastic behavior with increasing surface pressure. The transition is accompanied by an increase in the modulus. This behavior coincides with the coagulation of different 2D condensed domains as revealed by Brewster angle microscopy (BAM). However, partly converted prec-DMePPV monolayers show elastic behavior even at low surface pressures, although a sudden increase of the moduli does occur. This phenomenon is attributed to enhanced hydrophobic interactions between the conjugated moieties in the partly converted polymers. The latter also explains the stretching behavior of the partly converted prec-DMePPV upon transfer in Langmuir-Blodgett-type vertical dipping. The increase of the moduli which is observed is much more gradual in the precursor poly(2,5-dibutoxy-1,4-phenylene vinylene), prec-DBuPPV, a monolayer which is in agreement with the expected expanded state of the latter monolayer.     

Cross-linking-induced permanently perpendicular helix orientation in surface-grafted polyglutamate films

Using a chemical cross-linking procedure, surface-grafted polyglutamate films with a permanently perpendicular helix orientation were prepared. A surface-grafted alpha-helical polyglutamate film containing polymerizable side groups was synthesized by ring-opening terpolymerization of 50 molar% gamma-methyl-L-glutamate N-carboxyanhydride (NCA), 30% gamma-stearyl-L-glutamate NCA and 20% gamma-4-vinylbenzyl-L-glutamate NCA initiated from a silicon substrate functionalized with primary amino groups. The average tilt angle of the end-grafted helices in this film is approximately 66 degrees , indicating a nearly parallel helix orientation with respect to the substrate surface. After swelling of the grafted terpolyglutamate film in stearyl methacrylate and subsequent radical cross-linking, the average helix tilt angle decreases to about 11 degrees, indicating an almost perpendicular helix orientation. The film thickness increases accordingly from 151 A before to approximately 390 A after cross-linking. Extensive solvent treatment of the cross-linked film shows that the perpendicular helix orientation is permanent.