Investigation of electrical properties of PANI/chalcogenide junctions

Pure Polyaniline (EB) and Polyaniline doped with different protonic acids (ESs) were chemically synthesized using ammonium peroxydisulphate (APS) as an oxidant. Junctions have been prepared by evaporating chalcogenide materials (ZnSe, CdSe) on conducting polyaniline (EB & ESs) pellets using a vacuum evaporation technique. I–V characteristics of junctions have been studied at room temperature using the Keithley electrometer 6517A. I–V measurements show the rectification effect. A junction of ES[PO₄ ^3?] may be preferred over the other junctions due to its low ideality factor and maximum rectification ratio.      

Thermomechanical investigation of a thick film of aniline-formaldehyde copolymer and poly(methyl methacrylate)

A thick film of aniline-formaldehyde copolymer and PMMA is synthesized via dispersion of aniline-formaldehyde copolymer powder as filler particles in PMMA with two different concentrations. Variation of the complex elastic modulus and mechanical loss factor (tanδ) with temperature is studied. It is observed that the complex elastic modulus decreases with temperature owing to thermal expansion of films. On the other hand, tanδ increases up to a characteristic temperature beyond which it shows a decreasing trend toward melting. Transition temperature T _g of sample S₁ (pure PMMA) is found to be 80°C. In sample S₂ (1 wt % aniline formaldehyde copolymer), the peak of tanδ at a lower temperature (66°C) corresponds to glass transition temperature T _g of the PMMA matrix, while the peak of tanδ at a higher temperature (107.8°C) corresponds to T _g of a polymer chain restricted by filler particles of aniline-formaldehyde copolymer. A further increase (10 wt % aniline-formaldehyde copolymer) in the concentration of filler particles of aniline-formaldehyde copolymer results in a more compact structure and a shift of T _g to a higher temperature, 122.2°C. This shift in the glass transition temperature of thick films of aniline-formaldehyde copolymer and PMMA is dependent upon the concentration of filler particles in the sample.     

Comparison of hexane and petroleum ether to measure surface oil content

Many studies have measured surface oil on potato chips and spray dried powders using either petroleum ether or hexane. This study compared the effectiveness of the 2 solvents using aluminum squares to ensure oil stays on the surface of the sample during the measurement. Aluminum squares were sprayed with soybean oil, and surface oil was measured immediately and after 1 day. Each of the 8 aluminum samples were individually dipped for 1-2 s in either hexane or petroleum ether. For immediately extracted samples, there was no significant difference in the amount of oil extracted using either hexane or petroleum ether. For 1-day-old samples, hexane extracted more oil than petroleum ether. Neither method extracted all of the surface oil.     

Development and Validation of a Planar Chromatographic Method with Reflectance Scanning Densitometry for Quantitative Analysis of Anastrozole in the Bulk Material and in Tablet Formulations

JPC – Journal of Planar Chromatography – Modern TLC - A new quantitative densitometric HPTLC method has been developed for analysis and determination of the stability of anastrozole,...