排序方式: 共有14条查询结果,搜索用时 62 毫秒
1.
Europium (Eu+) ions were confined in a Paul trap and detected by non-destructive method. Storage time of Eu+ ions achieved in vacuum was improved by orders of magnitude employing buffer gas cooling. The experimentally detected signal
was fitted to the ion response signal and the total number of ions trapped was estimated. It is found that the peak signal
amplitude as well as the product of FWHM and the peak signal amplitude is proportional to the total number of trapped ions.
The trapped ion secular frequency was swept at different rates and its effect on the absorption line profile was studied both
experimentally and theoretically. 相似文献
2.
3.
Booth BD Vilt SG Lewis JB Rivera JL Buehler EA McCabe C Jennings GK 《Langmuir : the ACS journal of surfaces and colloids》2011,27(10):5909-5917
We report the frictional performance and long-term tribological stability of various alkyl silane monolayer films on silicon by using pin-on-disk tribometry at ambient conditions. We show that the durability of monolayers derived from n-alkyltrichlorosilanes on silicon increases exponentially with the chain length of the silane precursor, which we relate to the cohesive energy of these monolayers through molecular dynamics simulations. X-ray photoelectron spectroscopy (XPS) was used to show that tribological damage consisted of the loss of molecular components that could be partially replaced upon exposure to a solution containing perfluorinated silane precursors. For monolayers derived from n-octadecyltrichlorosilane, a critical load was identified to be approximately 250 mN (200 MPa), above which failure of films occurred within 100 cycles of testing. Monolayers with hydroxyl surfaces exhibited reduced stabilities due to stronger tip-surface interactions. Monolayers with the capability for cross-linking exhibited much greater stabilities than monolayers where cross-linking was limited or prevented. Collectively, these results demonstrate that the mechanical durability of monolayers when subjected to a tribological load is greatly enhanced by maximizing dispersional interactions and cross-linking and minimizing tip-surface interactions. 相似文献
4.
Eliene O Kozlowski Paula C Lima Cristina P Vicente Tito Lotufo Xingfeng Bao Kazuyuki Sugahara Mauro SG Pavão 《BMC biochemistry》2011,12(1):1-2
After the publication of the work entitled "Dermatan sulfate in tunicate phylogeny: Order-specific sulfation pattern and the effect of [→4IdoA(2-Sulfate)β-1→3GalNAc(4-Sulfate)β-1→] motifs in dermatan sulfate on heparin cofactor II activity", by Kozlowski et al., BMC Biochemistry 2011, 12:29, we found that the legends to Figures 2 to 5 contain serious mistakes that compromise the comprehension of the work. This correction article contains the correct text of the legends to Figures 2 to 5. 相似文献
5.
6.
7.
Three sharp absorption features in the energy range 2.36–2.55 eV have been detected in the transmission spectrum of Co-diffused ZnSe, and a number of luminescence transitions originating from the lowest of these states at 2.361 eV have been observed. Photoluminescence excitation spectra prove that these are high energy excited states of the Co2+Zn impurity, a conclusion confirmed by comparison of measured and predicted luminescence energies. This represents the first identification of luminescence branching from a higher excited state of a transition metal ion in any semiconductor. The sharp, weakly phonon-coupled transitions involve either intra-impurity excitation or transitions from the impurity to localised states split off from a minimum in the conduction band. The implications of these observations for the mechanism of host-impurity energy transfer and for the nature of the excited state wavefunctions are discussed. 相似文献
8.
9.
10.