The absorption of pulsed CO2-laser radiation by ethylene at total pressures from 25 to 3000 Torr

The absorption of pulsed CO₂-laser radiation by ethylene has been measured at total pressures from 25 to 3000 Torr, using the P(12) and P(14) lines in the 10.6 m band, with incident fluences from 0.1 to 0.7 J/cm². Marked deviations from the Beer-Lambert absorption law were observed, with the effective absorption coefficient varying with pressure, fluence, absorption path-length and the addition of non-absorbing gas. Pressure broadening of the rotational lines of the ethylene absorption spectrum was shown to be the major cause of these deviations, together with lesser effects which can be attributed to the rise in temperature of the absorbing gas during the laser pulse.     

Kinetic studies of nickel speciation in model solutions of a well-characterized humic acid using the competing ligand exchange method

Publications on the binding characteristics of metals with humic acid (HA) are sparse. Here we investigated the release of nickel from Ni(II)-HA complexes using model solutions of three different [Ni(II)]/[HA] mole ratios at three different pH values; we also compared the results with those of [Ni(II)]/[FA] complexes from previous work in this laboratory. Ligand exchange kinetics using the competing ligand exchange method (CLEM) were studied using two different techniques: graphite furnace atomic absorption spectrometry (GFAAS) with Chelex 100 resin as the competing ligand, and adsorptive cathodic stripping voltammetry (AdCSV) with dimethylglyoxime as the competing ligand to measure the rate of dissociation of Ni(II)-HA complexes. The results of the kinetic studies showed that as the [Ni(II)]/[HA] mole ratio was decreased, the rate of dissociation of Ni(II)-HA complexes decreased, and the proportion of free Ni²⁺ ions plus very labile nickel complexes decreased while the proportion of the less labile kinetically distinguishable components increased. Generally, the rate of dissociation of Ni(II)-HA complexes was slower than that of Ni(II)-FA complexes. Studies on the validity of the kinetic model showed that the concentrations of chemical species varied in a reasonable way with pH and the [Ni(II)]/[HA] mole ratios, indicating that the kinetically distinguishable components have chemical significance and the kinetic model is valid.     

Stereospecific rearrangements during the synthesis of pyrrolidines and related heterocycles from cyclizations of amino alcohols with vinyl Sulfones

Conjugate additions of amino alcohols derived from alpha-amino acids to vinyl sulfones, followed by N-benzylation, chlorination, and intramolecular alkylation, provide a convenient route to substituted pyrrolidines. The process is accompanied by the stereospecific rearrangement of substituents from the alpha-position of the amine to the beta-position of the product and takes place via the corresponding aziridinium ion intermediates. Another type of rearrangement was observed during the reaction of (2-piperidine)methanol or 2-(2-piperidine)ethanol with phenyl trans-1-propenyl sulfone, in which the methyl group appears to migrate from the beta- to the alpha-position of the sulfone moiety. This process involves the isomerization of phenyl trans-1-propenyl sulfone to phenyl 2-propenyl sulfone by the addition-elimination of catalytic benzenesulfinate anion to the former vinyl sulfone, followed by conjugate addition of the amino group to the latter sulfone. Chlorination and intramolecular alkylation then afford the corresponding rearranged indolizidine and quinolizidine derivatives, respectively.     

Determination of trace elements in marine plankton by inductively coupled plasma mass spectrometry (ICP-MS)

A method has been developed for the determination of 23 elements in marine plankton in which inductively coupled plasma (ICP) source mass spectrometry (MS) was used to quantify the elements in the solution after digestion in a mixture of hydrofluoric and nitric acids in sealed PTFE vessels in a microwave field. The procedure was validated by the analysis of a standard reference soil (SRM 2709 San Joaquin Soil) and a standard reference fresh water plankton (CRM 414). The method was applied to the analysis of several marine plankton samples grown under controlled conditions including several whose growth media had been enriched with selenium. Matrix induced signal suppressions and instrumental drift were corrected by internal standardization. The suitabilities of germanium, indium, rhodium, scandium and yttrium as internal standard elements were evaluated. Neither scandium nor yttrium could be used due to the presence of these elements in the samples, germanium was used for the determination of As, Co, Cu, Fe, Ni, Se, Si and Zn, indium was used for Al, Ba, Ca, Eu, Sr, and Tl, and rhodium was used for Cd, Cr, Hg, Mg, Pb, Sb, Sn, and V. For Al, Ca, Cr, Cu, Fe, Mg, Mn, Ni, Si, Sr, V, and Zn internal standardization did not completely compensate for the suppressive effect of the heavier elements and the solutions were diluted. However, for As, Ba, Cd, Co, Eu, Hg, Pb, Sb, Se, Sn and T1, it was possible to obtain accurate results despite the 35-40% suppression in the signals. Isobaric overlap was only a problem in the cases of 42Ca and 78Se; 44Ca and 77Se, respectively, were used. Memory effects were only observed with Hg for which a nitric acid-sodium chloride solution was the most effective wash-out solution. The marine plankton samples were able to tolerate a higher concentration of Hg as the selenium concentration increased.     

Determination of silicon by an indirect atomic-absorption method using carbon-rod electrothermal atomization

An indirect procedure has been developed for the determination of trace amounts of silicon by atomic-absorption with carbon-rod electrothermal atomization. After dissolution, the silicon is extracted as silicomolybdic acid into a mixture of diethyl ether and pentan-1-ol (5 + 1). The co-extraction of excess of molybdate reagent is prevented by the addition of citrate, which also destroys phosphomolybdic and arsenomolybdic acids. The organic layer is washed with hydrochloric acid, mul quantities are transferred to the electrothermal atomizer and the molybdenum is measured. The method has been applied to analysis of several steels.     

Selective detection and identification of Se containing compounds--review and recent developments

The complexity of selenium (Se) chemistry in the environment and in living organisms presents broad analytical challenges. The selective qualitative and quantitative determination of particular species of this element is vital in order to understand selenium's metabolism and significance in biology, toxicology, clinical chemistry and nutrition. This calls for state-of-the-art analytical techniques such as hyphenated methods that are reviewed with particular emphasis on interfaced separation with element-selective detection and identification of the detected selenium compounds. Atomic spectral element specific detection for monitoring chromatographic eluent enabled quantitative determination of selenium species in selenized yeast and qualitative measurement for breath samples. Gas chromatography with atomic emission detection (AED) of ethylated species and fluoroacid ion pair HPLC applied to the analysis of currently produced or archived selenized yeast and Brassica juncea have revealed the presence of a previously unrecognised Se-S amino acid, S-(methylseleno)cysteine.     

Flow injection reagent introduction by supported liquid and nafion membranes: determination of phosphate

The use of membrane tubing for the introduction of reagents for the determination of phosphate in waters by flow injection analysis was studied. The use of membranes eliminates the need for confluence points in the design of flow injection manifolds. This increases the sensitivity of the manifold by providing a sufficient reagent excess for the reaction without diluting the sample. Methods for the introduction of acid, molybdate and hydrazine were devised for the determination of phosphate by the Molybdenum Blue method. Several membranes were examined and Nafion and Accurel (microporous polypropylene) were found to be most useful. Molybdate introduction was achieved using a supported liquid membrane (SLM). Calibration was linear and a detection limit of 12 ppb phosphate (4 ppb phosphorus) was obtained.