WIDE RANGE DETECTOR USING PARABOLIC CYLINDRICAL MIRROR FOR THz APPLICATIONS

A new, wide-band, high-speed and high-sensitivity THz detector has been developed. The prototype detector consists of a parabolic cylindrical mirror, a long wire antenna and a Schottky barrier diode. Direct detection measurements have shown a stable sensitivity of 150 ± 50 V/W for 1–2 THz without any adjustments. The long wire antenna was fixed at the focus of parabolic cylindrical mirror then it has been realized less operation steps, easy coupling to the external THz signals and a dramatic enhancement in the practicality of this system. The optically polished mirror and frosted surface one showed comparable sensitivities, thus easy polishing and less cost mirror fabrication can be applied for this system. The radiation pattern showed a maximum radiation angle of approximately 23° with its dominant main lobe, which was attributed to the wire antenna character and confirmed good agreements with classical antenna theory.     

Effect of the pore surface modification of an inorganic substrate on the plasma‐grafting behavior of pore‐filling‐type organic/inorganic composite membranes

We have investigated the effect of the surface state and surface treatment of the pores of an inorganic substrate on the plasma‐grafting behavior of pore‐filling‐type organic/inorganic composite membranes. Shirasu porous glass (SPG) was used as the inorganic substrate, and methyl acrylate was used as the grafting monomer. The grafting rate increased as the density of silanol on the SPG substrate increased. This result suggests that radicals are generated mainly at the silanol groups on the pore surface by plasma irradiation. The SPG substrates were treated with silane coupling agents used to control the mass of organic material bonded to the pore surface. The thickness of the grafted layer became thinner as the mass of organic material bonded to the pore surface of SPG increased. This decrease in the thickness of the grafted layer could be explained by the decrease in the penetration depth of vacuum ultraviolet rays contained in plasma having a wavelength of less than 160 nm that generated radicals in the pores of the substrate. The thickness of the grafted layer inside the SPG substrates could be controlled through the control of the mass of organic material bonded to the pore surface of the SPG substrate. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 846–856, 2006     

Lewis acid promoted reactions of γ,γ-dialkoxyallylic zirconium species with various carbonyl compounds

The reactions of γ,γ-dialkoxyallylic zirconium species with carbonyl compounds in the presence of Lewis acid are reported. The reactivity of γ,γ-dialkoxyallylic zirconium species and reaction pathway were strongly dependent on the structure and electrostatic nature of the carbonyl compounds.     

Excess molar heat capacities of ((<Emphasis Type="Italic">R</Emphasis>)-(+)-α-pinene+(<Emphasis Type="Italic">S</Emphasis>)-(-)- α-pinene) at temperatures between 293.15-308.15 K

Summary {\rtf1\ansi\ansicpg1250\deff0\deflang1038\deflangfe1038\deftab708{\fonttbl{\f0\froman\fprq2\fcharset238{\*\fname Times New Roman;}Times New Roman CE;}} \viewkind4\uc1\pard\f0\fs20 New explanations are given for two types of irregular thermogravimetric (TG) data. A TG relationship between mass and temperature is derived on the basis of migration behavior of bubbles generated in bulk of sample system, and superposed on that derived on the basis of kinetics of the 4\super th\nosupersub order event, which is superposed on the experimental TG data obtained from three reference papers. This suggests that these TG data are reflecting migration of bubbles. A dependence of TG behavior on heating rate, which is contrary to usual that, is shown and is explained in terms of event-rate determination by boiling. \par }     

Synthesis and photochemical properties of photoactivated antitumor prodrugs releasing 5-fluorouracil

A new family of antitumor prodrugs (1-3) of 5-fluorouracil (5-FU) possessing photolabile 2-nitrobenzyl chromophores have been designed and synthesized to investigate the efficiency and mechanism of photoactivated 5-FU release upon UV-irradiation at lambda(ex)= 365 nm. The photoactivated prodrug 3 derived from conjugation of 2 with a tumor-homing cyclic peptide Cys-Asn-Gly-Arg-Cys (CNGRC) was so designed as to manifest a tumor-targeting function.     

Simultaneous polymerization and formation of polyacetylene film on the surface of concentrated soluble Ziegler-type catalyst solution

A direct method of simultaneously polymerizing and forming acetylene monomer to produce uniformly thin films of polyacetylene was investigated in terms of catalyst system, catalyst concentration, and polymerization temperature. The best catalyst was a Ti(OC₄H₉)₄–Al(C₂H₅)₃ system (Al/Ti = 3–4) and the critical concentration was 3 mmole/l. of Ti(OC₄H₉)₄. Below the critical concentration, only a solid or a powder was obtained. The configuration of the polymers obtained depends strongly upon the polymerization temperature. Thus an all-cis polymer was obtained at temperatures lower than ?78°C, whereas an all-trans polymer resulted at temperatures higher than 150°C. Observations either in an electron microscope by direct transmission or in a scanning electron microscope showed that the film is composed of an accumulation of fibrils about 200–300 Å in width and of indefinite length.     

Improved separation of alpha chains of collagen type I, type III, and type V by noninterrupted electrophoresis using thioglycolic acid as a negatively charged reducer

Improved separation of alpha chains of collagen type I (alpha 1 [I]2 alpha 2[I]), type III(alpha 1[III]3), and type V (alpha 1[V]alpha 3[V])was achieved by noninterrupted sodium dodecyl sulfate-polyacrylamide gel electrophoresis with a negatively charged reducer, thioglycolic acid. The thioglycolic acid, added to the running buffer of the cathodic reservoir, in the middle of electrophoresis quickly migrated in the gel anode, reducing interchain disulfide linkages in collagen type III and dissociating it into its alpha chain monomer, alpha 1[III], without an interruption of electrophoresis. The alpha chain, alpha 1[III], migrated more slowly than the alpha 1 [I] and alpha 2[I] chains of collagen type I, resulting in an excellent separation of alpha 1[III] from alpha 1[I]. The mobility of alpha 1[III] could be controlled by varying the time of thioglycolic acid addition to the running buffer. This enabled us not only to separate alpha 1[III] from alpha 1[I] and alpha 1[V], but also to precisely quantitate these alpha chains, even at low protein loading of mixed samples.     

Electron spin resonance study of polymerization of butadiene with tris(acetylacetonato)titanium and triethylaluminum

ESR spectra of homogeneous catalyst derived from tris(acetylacetonato)titanium(III) and triethylaluminum were observed at several temperatures from ?78°C, to +25°C, at molar ratios of aluminum to titanium of 1–108. At ?78°C, this catalyst yields a violet complex which shows an ESR signal with a g value of 1.959 and is associated with the first intermediate. At ?40°C to ?30°C, this signal decreases, and two signals with g values of 1.947 and 1.960 are observed. The latter two signals diminish at ?5°C to +10°C, while two kinds of new signals with g values of 1.965 and 1.969 appear overlapping each other. The structures of the species corresponding to these five signals are discussed on the basis of the ESR spectra, the intensity change, and the unpaired spin distribution. A new signal with a g value of 1.978 is found in the presence of butadiene at 25°C at Al/Ti > 8 and is assigned to a growing end of polybutadiene with this catalyst. The polymer yield increases remarkedly at Al/Ti molar ratios greater than 10. The microstructure of the resulting polymer consists almost completely of 1,2 units. The structure of the growing end is proposed to be a titanium (III) species containing two 1-substituted allyl groups, by comparison with the structure ascribed to the growing end of polybutadiene with n-butyl titanate-triethylaluminum catalyst.