DNA-conjugated polymers for self-assembled DNA chip fabrication.

We developed two DNA-conjugated polymers, one based on polyallylamine and the other on polyacrylic acid, for use in DNA chips. A 30-mer single-stranded DNA probe and thioctic acid were covalently attached to polyallylamine as sidechains. The same single-stranded DNA and 3-(pyridyldithio)propionyl hydrazide were covalently attached to polyacrylic acid as sidechains. Both DNA-conjugated polymers could be specifically immobilized onto a gold sensor substrate by a self-assembly technique. The interactions between fully matched DNA and each DNA-conjugated polymer were investigated by surface plasmon resonance. A gold surface modified with either DNA-conjugated polymer recognized fully matched DNA much better than unmatched DNA. The hybridization selectivity and efficiency of DNA-conjugated polyallylamine was optimized by adjusting the pH so as to reduce the effects of cationic polymer sidechains. The hybridization selectivity and efficiency of DNA-conjugated polymers were higher than those of a conventional immobilized thiol-based DNA. The coating of DNA-conjugated polymers reduced nonspecific adsorption of DNA by the gold substrate. DNA-conjugated polyacrylic acid was more selective toward fully matched DNA than was DNA-conjugated polyallylamine. Therefore, DNA-conjugated polymers show promise for application in novel DNA chips.     

Novel UV‐induced photografting process for preparing poly(tetrafluoroethylene)‐based proton‐conducting membranes

A novel process comprising the UV‐induced photografting of styrene into poly(tetrafluoroethylene) (PTFE) films and subsequent sulfonation has been developed for preparing proton‐conducting membranes. Although under UV irradiation the initial radicals were mainly generated on the surface of the PTFE films by the action of photosensitizers such as xanthone and benzoyl peroxide, the graft chains were readily propagated into the PTFE films. The sulfonation of the grafted films was performed in a chlorosulfonic acid solution. Fourier transform infrared and scanning electron microscopy were used to characterize the grafted and sulfonated membranes. With a view to use in fuel cells, the proton conductivity, water uptake, and mechanical properties of the prepared membranes were measured. Even through the degree of grafting was lower than 10%, the proton conductivity in the thickness direction of the newly prepared membranes could reach a value similar to that of a Nafion membrane. In comparison with γ‐ray radiation grafting, UV‐induced photografting is very simple and safe and is less damaging to the membranes because significant degradation of the PTFE main chains can be avoided. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2624–2637, 2007     

Analysis of (π K<Superscript>+</Superscript>) and (K<Superscript>-</Superscript>, K<Superscript>+</Superscript>) hypernuclear production spectra in distorted-wave impulse approximation

We study the hyperon-nucleus potential with distorted-wave impulse wave approximation (DWIA) using the Green's function method. In order to include the nucleon and hyperon potential effects in Fermi averaging, we introduce the local optimal momentum approximation of target nucleons. We can describe the quasi-free Λ , Σ and Ξ production spectra in a better way than in the standard Fermi-averaged t -matrix treatments.     

Spin-relaxation and magnetoresistance in FM/SC/FM tunnel junctions

The effect of spin relaxation on tunnel magnetoresistance (TMR) in a ferromagnet/superconductor/ferromagnet (FM/SC/FM) double tunnel junction is theoretically studied. The spin accumulation in SC is determined by balancing of the spin-injection rate and the spin-relaxation rate. In the superconducting state, the spin-relaxation time τ_s becomes longer with decreasing temperature, resulting in a rapid increase of TMR. The TMR of FM/SC/FM junctions provides a useful probe to extract information about spin-relaxation in superconductors.     

Self-assembled DNA-conjugated polymer for novel DNA chip.

We developed DNA-conjugated polymer for DNA chip fabrication. A 30 mer probe DNA and disulfide bridges were covalently attached to the polymer side chain. The DNA-conjugated polymer can be specifically adsorbed on a gold substrate surface by a self-assembly technique. The interaction between fully matched DNA and DNA-conjugated polymer was investigated by surface plasmon resonance (SPR) technique. The DNA-conjugated polymer-modified gold surface highly recognized fully matched DNA, rather than unmatched DNA. Therefore, DNA-conjugated polymer can be used for novel DNA chip fabrication.     

Preparation and Properties of Anti-Reflection/Anti-Static Thin Films for Cathode Ray Tubes Prepared by Sol-Gel Method Using Photoirradiation

A new technique for preparing anti-reflection/anti-static thin films for CRTs at low temperature has been developed. Double-layered films of SiO₂/SnO₂ were formed on a CRT panel surface by the sol-gel method using photoirradiation. The new method makes it possible to reduce heat treatment temperature (°C) by almost 50% and treatment time to approximately 33% of the conventional levels.     

Addition reactions of cyclooctatetraene with 1,3-diphenylisobenzofuran the benzene ring as dienophile in a [4+2] cycloaddition reaction

Addition reactions of cyclooctatetraene with 1,3-diphenylisobenzofuran resulted in the formation of three 1:1 cycloadducts, 1, 2, and 3, and a 1:2 cycloadduct, 4. Single crystal x-ray analysis established 3 to be a cage compound formed by an unprecedented [4+2] cycloaddition reaction of 1 in which the double bond of the benzene moiety acted as the dienophile.     

Massenspektren der von Aminosäuren bzw. Peptiden abgeleiteten Triazin-Derivate

A mass spectrometric study of about 30 triazine derivatives from amino acids and peptides is reported. These derivatives incorporated the C-terminal of amino acids and peptides in the ring. In contrast to the mass spectra of amino acids and peptide esters reported previously, they always showed characteristic fragments, denoting the presence of the terminal triazine ring. By using this peak as a marker, it is easy to estimate the C-terminal of peptides. In dipeptides, the N-terminal and C-terminal are determined simultaneously.     

Effects of type of adsorption isotherms on parallel diffusion of sulfonated dyes into porous cellulose membrane

Transport phenomenon of three sulfonated azo dyes, C.I. Acid Red 88, C.I. Direct Yellow 12, and C.I. Direct Blue 15 into water-swollen cellulose membranes has been analyzed on the basis of parallel transport theory by surface and pore diffusion. Langmuir equation was applied into the mass balance equation to estimate dye concentration in the pores. The results were compared with the results obtained by applying Freundlich equation in our previous papers. The surface diffusivity (D _s) and the pore diffusivity (D _p) for the parallel diffusion model obtained by applying Langmuir equation agreed with those obtained by applying Freudlich equation. The theoretical concentration profiles for parallel diffusion calculated usingD _s andD _p coincided accurately with the experimental data when we applied either Langmuir or Freundlich equations.