(Ni0.8Zn0.2Fe2O4)epoxy-PZT双层膜中的磁电效应

讨论了Ni_0.8Zn_0.2Fe₂O₄ (NZFO)与锆钛酸铅(PZT)的双层膜结构样品的磁电(ME)效应.NZFO粉料由溶胶-凝胶法制成，再经900℃热压，并高温烧结.在该双层膜中测量到了很强的磁电相互作用.发现横向的磁电效应比纵向效应大一个数量级，并且随NZFO烧结温度的提高而增加.当烧结温度从950℃上升到1380℃时，横向ME电压系数(α_E)的最大值变化范围为25.6 mV Am^-2≤α_E≤199.6 mV Am^-2.理论分析显示NZFO-PZT双层膜样品中ME效应源于NZFO与PZT之间相对良好的磁电耦合. 关键词： 镍铁氧体 PZT 热压法 ME效应     

Synthesis of aromatic aldehydes via NiCl2 reduction and hydrolysis of oxazolines

Reduction of 2-aryl-oxazolines with NiCl₂/NaBH₄ followed by hydrolysis gives the corresponding aldehydes in good yields.     

Membrane introduction mass spectrometry

An overview of membrane introduction mass spectrometry (MIMS) is presented and comparisons are made with other direct sample introduction techniques. Special attention is given to the unique advantages and the limitations of newer variants on the MIMS technique, including affinity MIMS, reverse-phase and trap MIMS. The salient features of the interfaces used in MIMS are summarized and the various membrane materials commonly used are delineated. The applicability of MIMS is illustrated via discussion of

1. (i) bioreactor monitoring (represented by yeast fermentation),

2. (ii) environmental monitoring (illustrated by analysis of contaminated ground water samples) and

3. (iii) on-line chemical reaction monitoring (exemplified by the photolysis of aryl esters).

The applicability of MIMS to the analysis of environmental samples, including complex mixtures in water, air and soil, is noted.     

The treatment of nonhomogeneous Dirichlet boundary conditions by thep-version of the finite element method

Summary The paper addresses the problem of the implementation of nonhomogeneous essential Dirichlet type boundary conditions in thep-version of the finite element method.Partially supported by the Office of Naval Research under Grant N-00014-85-K-0169Research partially supported by the Air Force Office of Scientific Research, Air Force Systems Command, USAF, under Grant Number AFOSR 85-0322     

Anomalous elastic behaviour of Bi-Pb-Ag composites

Bi-Pb and Bi-Pb-Ag superconducting composites have been prepared by the solid state reaction method. After the usual characterization, ultrasonic longitudinal velocity and attenuation studies have been undertaken over a temperature range 80–300 K by the pulse transmission technique. In contrast to normal solids, the ultrasonic velocities of both the samples in the temperature range 200-100 K are found to decrease with decreasing temperature (softening), followed by a velocity maximum. The samples are also found to exhibit longitudinal attenuation peaks at TEMPERATURES = 260, 160 and 120 K. An attempt has also been made to verify whether the Wachtman's equations can theoretically explain the low-temperature behaviour of the Young's modulus of these materials. A qualitative explanation for both the phenomena of softening of velocity as well as the occurrence of attenuation peaks is given.