Room-Temperature,Metal-Free,and One-Pot Preparation of 2H-Indazoles through a Mills Reaction and Cyclization Sequence

The Mills reaction and cyclization of readily available 2-aminobenzyl alcohols and nitrosobenzenes using thionyl bromide provided 2H-indazoles in up to 88 % yields. In the metal-free process, acetic acid played a crucial role for the both Mills reaction and cyclization. A brominated 2H-indazole could also be obtained through the one-pot sequence.     

Novel UV‐induced photografting process for preparing poly(tetrafluoroethylene)‐based proton‐conducting membranes

A novel process comprising the UV‐induced photografting of styrene into poly(tetrafluoroethylene) (PTFE) films and subsequent sulfonation has been developed for preparing proton‐conducting membranes. Although under UV irradiation the initial radicals were mainly generated on the surface of the PTFE films by the action of photosensitizers such as xanthone and benzoyl peroxide, the graft chains were readily propagated into the PTFE films. The sulfonation of the grafted films was performed in a chlorosulfonic acid solution. Fourier transform infrared and scanning electron microscopy were used to characterize the grafted and sulfonated membranes. With a view to use in fuel cells, the proton conductivity, water uptake, and mechanical properties of the prepared membranes were measured. Even through the degree of grafting was lower than 10%, the proton conductivity in the thickness direction of the newly prepared membranes could reach a value similar to that of a Nafion membrane. In comparison with γ‐ray radiation grafting, UV‐induced photografting is very simple and safe and is less damaging to the membranes because significant degradation of the PTFE main chains can be avoided. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2624–2637, 2007     

Wavelength-Dependent Transient Characteristics Caused by Gain Saturation in Highly Nonlinear Fiber-Based Raman Amplifiers

We have investigated the transient characteristics of discrete Raman Amplifiers and found that the response time caused by gain saturation is dependent upon the wavelength, which corresponds to the effective length of the pump light.     

Analysis of (π K<Superscript>+</Superscript>) and (K<Superscript>-</Superscript>, K<Superscript>+</Superscript>) hypernuclear production spectra in distorted-wave impulse approximation

We study the hyperon-nucleus potential with distorted-wave impulse wave approximation (DWIA) using the Green's function method. In order to include the nucleon and hyperon potential effects in Fermi averaging, we introduce the local optimal momentum approximation of target nucleons. We can describe the quasi-free Λ , Σ and Ξ production spectra in a better way than in the standard Fermi-averaged t -matrix treatments.     

Spin-relaxation and magnetoresistance in FM/SC/FM tunnel junctions

The effect of spin relaxation on tunnel magnetoresistance (TMR) in a ferromagnet/superconductor/ferromagnet (FM/SC/FM) double tunnel junction is theoretically studied. The spin accumulation in SC is determined by balancing of the spin-injection rate and the spin-relaxation rate. In the superconducting state, the spin-relaxation time τ_s becomes longer with decreasing temperature, resulting in a rapid increase of TMR. The TMR of FM/SC/FM junctions provides a useful probe to extract information about spin-relaxation in superconductors.     

Preparation and Properties of Anti-Reflection/Anti-Static Thin Films for Cathode Ray Tubes Prepared by Sol-Gel Method Using Photoirradiation

A new technique for preparing anti-reflection/anti-static thin films for CRTs at low temperature has been developed. Double-layered films of SiO₂/SnO₂ were formed on a CRT panel surface by the sol-gel method using photoirradiation. The new method makes it possible to reduce heat treatment temperature (°C) by almost 50% and treatment time to approximately 33% of the conventional levels.     

Superhydrophobic perpendicular nanopin film by the bottom-up process

We first fabricated the superhydrophobic film with a water contact angle of 178 degrees based on a perpendicular nanopin fractal structure by a bottom-up process. Until now, only materials with an original water contact angle larger than 90 degrees , which is classified as hydrophobicity, could be used to fabricate the superhydrophobic film (>170 degrees ) according to the possible fractal structure by a top-down process. Now, in this work, a water contact angle of about 178 degrees can be achieved using a lauric acid-coated film with an original contact angle of 75 degrees , which is classified as hydrophilicity, based on an ideal fractal structure for the superhydrophobic surface which is fabricated by the nanosize pin with 6.5 nm diameter.     

Addition reactions of cyclooctatetraene with 1,3-diphenylisobenzofuran the benzene ring as dienophile in a [4+2] cycloaddition reaction

Addition reactions of cyclooctatetraene with 1,3-diphenylisobenzofuran resulted in the formation of three 1:1 cycloadducts, 1, 2, and 3, and a 1:2 cycloadduct, 4. Single crystal x-ray analysis established 3 to be a cage compound formed by an unprecedented [4+2] cycloaddition reaction of 1 in which the double bond of the benzene moiety acted as the dienophile.     

Massenspektren der von Aminosäuren bzw. Peptiden abgeleiteten Triazin-Derivate

A mass spectrometric study of about 30 triazine derivatives from amino acids and peptides is reported. These derivatives incorporated the C-terminal of amino acids and peptides in the ring. In contrast to the mass spectra of amino acids and peptide esters reported previously, they always showed characteristic fragments, denoting the presence of the terminal triazine ring. By using this peak as a marker, it is easy to estimate the C-terminal of peptides. In dipeptides, the N-terminal and C-terminal are determined simultaneously.