Interfacial adsorption state of protonated lipophilic porphyrins in a liquid-liquid system by using reflection spectrometry.

Analysis by reflection spectrometry was performed to clarify the interfacial adsorption of protonated lipophilic tetraphenylporphyrin derivatives in a dodecane-aqueous sulfuric acid system, and to confirm the utility of partial reflection spectroscopy. Interfacial adsorption was not observed for porphyrins substituted at the 2,6 positions of meso-phenyl groups, suggesting that the substituents prevent porphyrins from forming aggregates by steric hindrance. Polymorphous J-aggregates of acid dications were produced by tetra-p-tolylporphyrin with a saturated interfacial molecular density of 1.0 x 10(-10) mol cm(-2), which could yield 48 degrees as a mean tilting angle of the pyrrole ring plane from the interface normal. Partial-reflection spectrometry can provide sensitive detection and molecular orientation analysis of interfacial adsorbates.     

Peroxyoxalate chemiluminescence detection of condensates of malondialdehyde with thiobarbituric acids using a flow system.

The peroxyoxalate chemiluminescence(CL) detection method for the evaluation of the CL intensity of malondialdehyde(MDA) condensates with seven 2-thiobarbituric acid derivatives is described. The method consists of a flow injection technique together with a CL detection system using bis(2,4,6-trichlorophenyl) oxalate(TCPO) and hydrogen peroxide as chemiluminogenic reagents. Linear correlations between CL intensity and concentration are obtained for pmol levels of condensates. Among the condensates, 1,3-diethyl-2-thiobarbituric acid(DETBA)-MDA shows the largest CL intensity. High performance liquid chromatography (HPLC)/CL detection of DETBA-MDA and 1,3-diphenyl-2-thiobarbituric acid(DPTBA)-MDA using a mixture of TCPO and hydrogen peroxide in acetonitrile as a postcolumn reagent solution is also described. The detection limits for DETBA-MDA and DPTBA-MDA are 20 and 200 fmol, respectively, per 20 microL injection at a signal-to-noise ratio of 2. This HPLC/CL detection system was applied to the determination of MDA in rat brains by using DETBA as a fluorescent derivatizing reagent.     

Synthesis of enantiopure 1,2-diamine attached to cross-linked polystyrene and its application to an insoluble catalyst for asymmetric hydrogenation

A novel enantiopure 1,2-diamine (5) having two phenolic hydroxy groups was attached into chloromethylated polystyrene through benzyl ether linkage, which was used as a chiral ligand of the catalyst in asymmetric hydrogenation of acetophenone.     

Direct observation of adduct formation of alkyl and aromatic iodides with cl atoms using cavity ring-down spectroscopy

The reactions of Cl atoms with RI (R = n-C3H7, n-C4H9, cyclo-C6H11, C6H5, C6F5, and p-CH3C6H4) have been studied using cavity ring-down spectroscopy at a temperature range of 233-313 K and at 100 Torr total pressure of N2 diluent. Visible absorption spectra of the RI-Cl adducts were recorded at 440-520 nm at 263 K. The yields of the adducts were temperature-dependent. There was no discernible reaction of the adducts in the presence of 100 Torr of O2 at 263 K. Theoretical calculations were performed for C4H9I-Cl and C6H5I-Cl for quantitative explanation of the absorption spectra and the strength of the I-Cl bonds in the charge-transfer complexes. Evidence for the adduct formation following the reaction of Cl with C6H5Br was sought but not found at 440 and 520 nm.     

Effect of solvent on the cation-sensitive fluorescence of polyanions bearing 4′-acryloylbenzo-18-crown-6 Units

Changes in the fluorescence intensity of polyanions bearing 4-acryloylbenzo-18-crown-6 units on the addition of cations were studied in a mixed solvent of methanol and water at 30°C. The sensitivity of the change in fluorescence intensities of the polymers toward cations was strongly enhanced compared to that of the corresponding model compound. When alkali metal cations were added, the fluorescence intensity of the polymers decreased in the orders Li⁺>Na⁺>Cs⁺>Rb⁺>K⁺ in a methanol-water (19) mixture and Li⁺>Na⁺>Rb⁺>K⁺Cs⁺ in a methanol-water (91) mixture. Alkaline earth metal cations and alkylamine hydrochlorides decreased the fluorescence intensity of the polymers in a methanol-water (19) mixture. The cation-dependent decrease in the fluorescence intensity of the polymers was affected by the water fraction in a mixed solvent of methanol and water.     

High pressure study on the superconducting transition temperature and Hall coefficient of Ba1−xKxBiO3 up to 8 GPa

The superconducting transition temperature (T_c) of Ba_0.62K_0.38Bio₃ (T_c=30 K) has been measured under high pressure up to 8 GPa. It is observed that T_c increases initially with pressure, as reported by Uwe et al., Shirber et al. and Huang et al., but decreases above 4 GPa. The Hall coefficient of Ba_0.62K_0.38BiO₃ has been measured up to 1.2 GPa. The absolute value of the Hall coefficient decreases with pressure by 10% GPa, the value of which is almost the same as that obtained in most CuO-based high-temperature superconductors.     

Performance improvement of a high-temperature superconducting coil by separating and grading the coil edge

In this paper, we establish a model to analyze the transport current performance of a high-temperature superconducting (HTS) coil, considering the dependencies of critical current and n-value of an HTS tape on magnetic field and magnetic field angles. This analysis shows that relatively large electric fields appear at the coil’s edges, preventing improvement in the transport current performance of the coil. To solve this problem, in this paper, we propose a graded coil in which several coil edges of different heights are separated and graded. Analysis of its performance shows that the coil’s critical current increases, thus confirming that there exists an optimum coil cross section at which the stored energy and central magnetic field improve 2.1 times and 45%, respectively, compared with a typical rectangular coil that employs the same total length of the HTS tape. It is recommended that these results of the coil should be applied to SMES.     

Tissue velocity imaging of coronary artery by rotating-type intravascular ultrasound

Intravascular ultrasound (IVUS) provides not only the dimensions of coronary artery but the information of tissue components. In catheterization laboratory, soft and hard plaques are classified by visual inspection of echo intensity. So-called soft plaque contains lipid core or thrombus and it is believed to be more vulnerable than a hard plaque. However, it is not simple to analyze the echo signals quantitatively. When we look at a reflection signal, the intensity is affected by the distance of the object, the medium between transducer and objects and the fluctuation caused by rotation of IVUS probe. The time of flight is also affected by the sound speed of the medium and Doppler shift caused by tissue motion but usually those can be neglected. Thus, the analysis of RF signal in time domain can be more quantitative than intensity of RF signal. In the present study, a novel imaging technique called "intravascular tissue velocity imaging" was developed for searching a vulnerable plaque. Radio-frequency (RF) signal from a clinically used IVUS apparatus was digitized at 500 MSa/s and stored in a workstation. First, non-uniform rotation was corrected by maximizing the correlation coefficient of circumferential RF signal distribution in two consecutive frames. Then, the correlation and displacement were calculated by analyzing the radial difference of RF signal. Tissue velocity was determined by the displacement and the frame rate. The correlation image of normal and atherosclerotic coronary arteries clearly showed the internal and external borders of arterial wall. Soft plaque with low echo area in the intima showed high velocity while the calcified lesion showed the very low tissue velocity. This technique provides important information on tissue character of coronary artery.     

Interaction of water vapor with gamma-radiation-induced defects in proton conductive polymers

The correlation between protonic conduction and the amount of radiation-induced defects in gamma-ray-irradiated perfluorosulfonic acid (PFSA) polymers (Aciplex-SF-1004^®) has been investigated using a direct-current resistance method, transmission spectroscopy for the ultraviolet (UV) and visible (Vis) wavelength ranges and Fourier transform infrared (FTIR) spectroscopy with the attenuated total refraction (ATR) technique. The proton conductivity of the polymers, which are irradiated with a dose of up to 532 kGy under vacuum at room temperature and subsequently exposure to air, is enhanced by approximately three orders of magnitude as compared to that of the unirradiated polymer. The UV–Vis spectra of the irradiated polymers reveal the presence of fluorocarbon radicals, which increase with the irradiation dose. It is also observed in the UV–Vis and FTIR spectra that peroxy free radicals, unsaturated species (COF), and a carboxyl group (COOH) containing a carbon-oxygen double bond are formed by reactions of the fluorocarbon radicals with oxygen or water vapor in air. In addition, an increase in the hydrogen concentration is observed in the near-surface regions of the irradiated polymers by using an elastic recoil detection (ERD) technique. The production of charge carriers such as protons and oxonium ions (H₃O⁺) by the interaction of water vapor with the activating-radiation-induced defects leads to the enhancement of the proton conductivity.