A PULSED LASER AND PULSE RADIOLYSIS STUDY OF AMPHIPHILIC CHLOROPHYLL DERIVATIVES WITH PDT ACTIVITY TOWARD MALIGNANT MELANOMA

Two amphiphilic derivatives of chlorophyll, which have high potential as photodynamic therapy sensitizers for malignant melanoma have been investigated by a combination of laser flash photolysis and pulse radiolysis. It is shown that direct excitation of monomeric forms of these molecules in both hydrophilic and hydrophobic environments produces significant yields of the corresponding triplet states, which have been characterized in terms of spectral and kinetic parameters. In both environments, scavenging of the triplets by oxygen produces singlet oxygen, O₂(^lΔ₈), with essentially unit efficiency as evidenced by time-resolved IR luminescence measurements.     

Kinetic and thermodynamic considerations of the bracketing method: Entropy-driven proton-transfer reactions in a Fourier transform mass spectrometer

Several reports of experimentally derived proton affinity values and gas-phase basicity values for amino acids and peptides have recently appeared in the literature. Here, we show that the thermodynamic quantity that is measured by the Fourier transform mass spectrometry proton transfer bracketing of amino acids and peptides is gas-phase basicity and not proton affinity. Both experimental and theoretical evidence supports this conclusion. The difference between the values determined by proton transfer bracketing measurements for lysine versus leucine is consistent with a difference in gas-phase basicity rather than proton affinity. The rate of proton transfer from protonated lysine to a series of reference compounds have been measured. Entropy-driven, endothermic proton transfer is found to occur at the collision rate. Recent ab initio and semi-empirical calculations of the proton affinity of lysine are found to agree with the value that is derived from bracketing studies when one assumes that gas-phase basicity is measured. While entropy-driven reactions have been observed previously in high-pressure mass spectrometers, this is the first evidence for such reactions at low pressure in a Fourier transform mass spectrometer.     

Matrix-assisted laser desorption/ionization mass spectrometry of collected bioaerosol particles

A method was developed for collection and analysis of bioaerosols by matrix-assisted laser desorption/ionization (MALDI) time-of-flight mass spectrometry using a modified Andersen N6 bioaerosol collector. The overall goal of the study was to develop methods for obtaining mass spectra with minimal reagents and treatment steps for potential use in remote collection and analysis systems. Test bioaerosol particles were generated from a nebulized E. coli bacterial suspension and collected on MALDI targets placed in an Andersen N6 single-stage aerosol impactor. The bioaerosols were mixed with matrix either by deposition on a bare target with the matrix solution added later, or by deposition on a target pre-coated with matrix. The matrix compounds alpha-cyano-4-hydroxycinnamic acid (CHCA) and sinapic acid (SA) were tested and the SA matrix was found to give the best results in number of peaks, resolution, and signal-to-noise ratio. Deposition of bioaerosol particles onto the matrix pre-coated target did not produce signal in the m/z region above 1000, but the signal could be recovered with the addition of a 1:1 (v/v) acetonitrile/water solvent. Addition of solvent by pipette to the pre-coated targets after particle deposition recovered signal comparable to the dried-droplet sample preparations, whereas solvent sprayed into the impactor recovered fewer peaks. Deposition on pre-coated targets with post-collection solvent addition was superior to deposition on bare target followed by post-collection addition of matrix solution.     

Anodic stripping voltammetry of sulphide at a nickel film: towards the development of a reagentless sensor

The determination of sulphide at an electrochemically generated nickel oxide layer at glassy carbon and screen-printed electrodes in acidic media has been examined and appraised. The NiO layer was found to produce a stripping-like signal to sulphide and gave a linear peak current response from 20 to 90 μM. The response was further enhanced by repetitive cycling allowing accumulation of nickel sulphide at the electrode surface such that lower micromolar levels of sulphide (i.e. 5 μM) can be determined. The response at the NiO layer to sulphide is shown to be reproducible over a period of 24 h, thereby offering the development of a disposable amperometric sensor for sulphide.     

Channel flow cell studies on the evaluation of surface pretreatments using phosphoric acid or polymaleic acid for calcite stone protection

The dissolution kinetics of surface-pretreated and weathered calcite was investigated in dilute acid using a channel flow cell with microdisk detection. Two pretreatments were studied, polymaleic acid and phosphoric acid. Treatment with polymaleic acid was shown to significantly passivate calcite but to a lesser extent than the phosphoric acid and the former coating was found to be less effective for protection of calcite from acid attack. However, treatment of calcite with phosphoric acid resulted in the passivation of calcite from acid attack which strongly inhibited dissolution, an effect that was enhanced even further after exposure to the environment.     

THE PHOTOSENSITIZED FORMATION AND REACTION OF SINGLET OXYGEN, O2*(1Δ), IN AQUEOUS MICELLAR SYSTEMS

Abstract— Oxygenated aqueous solutions of methylene blue containing dispersions of sodium dodecyl sulphate micelles with solubilised diphenyl isobenzofuran were irradiated with red light and the rate of loss of furan was followed over several min. The results are consistent with a mechanism in which singlet oxygen is produced by energy transfer from methylene blue triplet in the aqueous phase, and then diffuses to and penetrates the interior of the micelles where it reacts with the furan. The competition between this process and the natural decay of the excited oxygen has been examined and a β-value of 9.7 times 10^-5 M determined which is comparable to that for the same reaction in homogeneous solvents. A model of the system is proposed and its kinetic features discussed.     

Generic serial and parallel on-line direct-injection using turbulent flow liquid chromatography/tandem mass spectrometry

The development of turbulent flow chromatography (TFC) has enabled considerable growth in the utility of on-line direct-injection technologies. TFC has now become established in a large number of varied analytical environments, particularly drug discovery/pharmacokinetics, metabolite profiling, combinatorial library purification, pre-clinical and clinical GLP applications. The utility of turbulent flow technology for in-house pre-clinical and clinical quantitative applications has necessitated extensive valve-cleaning procedures, and consequently lengthy cycle-times, to effectively remove the system carry-over. In-house requirements for assay validation require carry-over less than 20% of the lowest level of quantification (LLOQ), corresponding to 0.02% carry-over for a linear calibration range incorporating 3 orders. A generic turbulent flow chromatography protocol has been developed for drug discovery that incorporates polymeric turbulent flow extraction (cyclone) with C18-based reverse-phase chromatography. Further, multiple wash steps are incorporated within the methodology to meet in-house requirements for carry-over. Selection of novel switching-valve materials based on polyarylethyl ketone (PAEK) and Hastelloy/Valcon E autosampler injection hardware has enabled us to significantly impact the cycle-time required to reduce carry-over. Consequently, optimal usage of switching valves has enabled parallel operation for a generic on-line direct-injection methodology to successfully reduce the total cycle-time. Overall reductions from 4 min per sample to 90 s per sample are shown with comparable data quality using a proprietary target molecule from 0.1-100 ng/mL. This paper describes the hardware configuration and methodologies utilized to perform generic serial and parallel on-line direct-injection using a Turboflow HTLC 2300 system.     

Dendritic encapsulation-roles of cores and branches

Examples of new dendrimers are presented. In the first, the effect on electron transfer rate attenuation is investigated for two dendrimer isomers that differ only in the linkage (ortho- versus meta-linked) of the phenyl ether units within one generation of the structure. Second, the effect of encapsulation on electrochemical and luminescence behavior of a new type of rhenium selenide cluster core dendrimer is illustrated.     

ANTHRALIN-DERIVED TRANSIENTS—II. FORMATION OF THE RADICAL BY SPONTANEOUS FRAGMENTATION OF BOTH SINGLET AND TRIPLET STATES OF THE 10,10''-DEHYDRODIMER: RADICAL PAIR MULTIPLICITY EFFECTS

The singlet and triplet states of the anthralin (1,8-dihydroxy-9-anthrone) dehydrodimer have been produced selectively in benzene via pulsed laser excitation and pulse radiolysis respectively. The lifetime of S1 is less than or equal to 30 ps, that of T1 short but unspecified. Both states fragment spontaneously to yield a pair of anthralin radicals. The singlet radical pair predominantly undergoes geminate recombination within the solvent cage. In contrast, the corresponding triplet radical pair undergoes essentially exclusive cage escape to give the anthralin free radical (lambda max 370, 490 and 720 nm) which recombines under normal diffusive conditions. Both recombination processes lead, at least in part, to one or more species which have been assigned as tautomeric forms of the original dimer. The anthralin free radical in benzene is insensitive to the vitamin E model 6-hydroxy-2,2,5,7,8-pentamethylchroman and reacts only slowly with oxygen.