Accumulation of uranium by filamentous green algae under natural environmental conditions

The capacity of algae to concentrate uranium under natural environmental conditions is measured by a-spectrometry. Spirogyra, a filamentous green fresh-water alga, has concentrated uranium from a surface concrete ponds with elevated uranium levels (140-1140 ppb). The concentration factors (CFs) ranged from 8.9-67 with an average value of 22.Cladophora spp, a filamentous green marine alga has concentrated uranium from the marine water with a concentration factor ranged from 220–280. The average concentration factor was 250. The factors affecting the sorption process are discussed in detail. This revised version was published online in July 2006 with corrections to the Cover Date.     

On the Use of the Restitution Condition in Flexible Body Dynamics

The difference between the classical treatment offlexible body impact and the treatment of impact in flexiblemultibody dynamics is due to several fundamental reasons. Inthe classical impact theory, simple structures such as beamsand plates are used. Infinite dimensional models can bedeveloped for these simple structural elements to study theimpact dynamics and the wave propagation problem. Flexiblemultibody impact problems, on the other hand, involve bodieswith complex geometry that cannot be modeled using infinitenumber of degrees of freedom. Furthermore, the classicalimpact theory has been mainly concerned with the impactbetween a rigid mass that moves without constraints beforeit impacts a simple flexible structure. This is not amultibody simulation scenario in which the impact occursbetween kinematically constrained bodies that are subjectedto impulsive constraint forces in addition to the impactforces. These constraint forces can influence the motion ofthe two bodies immediately after impact, and as aconsequence, the simple classical theory scenario of impactdoes not apply. It is the objective of this paper to discussthe use of the restitution condition in flexible multibodyimpact problems and demonstrate that the use of thisapproach does not exclude the classical formulation.Nonetheless, the impulse momentum balance approach can serveas an effective and efficient procedure for solving theimpact problem in finite dimensional models that do not obeythe classical wave theory. Energy results of simplestructural elements are presented in order to demonstratethe consistency of using the impulse momentum balanceapproach in solving impact problems in finite dimensionalflexible body applications.     

Ion exchange behaviour of hydrous tin oxide: Kinetics of anion exchange

The kinetic behaviour of Cl(-), Br(-) and SCN(-) exchanges on hydrous tin oxide have been investigated under conditions of particle diffusion and the limited bath technique. Values for the diffusion coefficients, energy of activation and entropy of activation have been calculated. The data obtained have been compared with those reported for other organic and inorganic exchangers.     

On the extraction of mineral acids and uranium from alcoholic and acetonic solutions with tri-N-butyl phosphate

The extraction of hydrochloric, nitric, and sulphuric acids with TBP was studied as a function of methanol, ethanol, isopropanol, and acetone concentration in the aqueous phase. Extraction increases in the order: methanol相似文献   

Synthesis of PDMAEMA-PCL-PDMAEMA triblock copolymers

The synthesis of ABA triblock copolymers of the type PDMAEMA-PCL-PDMAEMA was achieved by atom transfer radical polymerization (ATRP) of DMAEMA using difunctional polycaprolactone (PCL) as macroinitiator. First, ring-opening polymerization (ROP) of ε-caprolactone (ε-CL) was carried out in the presence of 1,2-diaminoethane/tin (II) octanoate. Dihydroxy PCL thus obtained was end-functionalized in a quantitative manner using 2-bromoisobutyryl bromide. The resulting Br-PCL-Br was used as macroinitiator in the ATRP of DMAEMA leading to triblock copolymers with PCL as the central block and PDMAEMA sequences of different lengths. NMR and SEC analyses confirmed the formation of ABA triblocks.     

Extraction of tungsten and rhenium by basic or neutral extractants in xylene from mineral acidic media

Extraction of WO ₄ ^2– and ReO ₄ ^– by Adogen-381, tricaprylmethylammonium chloride, Hyamine 10-X, trioctylphosphine oxide or dibenzylsulphoxide in xylene from HNO₃, HCl or H₂SO₄ acid medium was investigated. Based on the separation factors obtained, the separation of ReO ₄ ^– from WO ₄ ^2– was elucidated. ReO ₄ ^– was separated from WO ₄ ^2– in high radiochemical purity: >99.9% by three successive extractions and strippings using Adogen-381 from HCl or HNO₃ acid medium.     

Extraction of protactinium(V) chloro complexes by tri-capryl amine and its separation from thorium(IV), uranium(VI) and rare earths

The distribution of Pa(V) between aqueous HCl solutions and organic phases of tricaprylamine has been described. The dependence of extraction on acidity, salting-agent and extractant concentration was investigated. The possible extraction mechanism is discussed in the light of results obtained. The separation of Pa(V) from Th(IV), U(VI) and rare earths, is also suggested.     

Screening of urban aerosol particulate composites for selected metal distribution and their dependence on meteorological parameters

Local atmospheric aerosol particulate samples, collected as composites on daily 6-12 hour basis, at Quaid-i-Azam University campus, Islamabad, Pakistan, using high volume sampling technique, were analysed for Pb, Na, K, Fe, Mn, Cd, Cr, Ni, Zn and Co by FAAS method. The monitoring period ran from October, 2001 through March, 2002, with a total of 105 samples collected on cellulose filters, treated in part with the HNO3-based wet digestion method for metal quantification, and for particle size distribution separately. The metal content of the aerosols was examined in relation to dependence on meteorological parameters, such as temperature, relative humidity, wind speed, sun shine and pan evaporation. Statistical correlation analysis was conducted for multiple metal pairs in aerosols, and the data were examined in relation to meteorological parameters and relevant aerosol particle size fractions. The study revealed no viable strong correlation between the meteorological parameters and metal levels; in general, however, a significant positive correlation was found for temperature. A strong positive correlation was observed for PM<25 and PM2.5-10. For coarse particles (PM10-100 and PM>100), however, a negative correlation was observed. The levels of Na, K, Fe and Zn were found in the range of 1-5 microg/m3 while those for the rest of the metals in the sub microg/m3 range. Principal component analysis and cluster analysis were performed on dataset for source identification and appointment. Largest contribution (33%) was shown by the industrial emissions followed by traffic/road dust (16.7%).     

Plutonium extraction from mixed aqueous media. Plutonium—Uranium separation

A systematic study is presented on Pu IV extraction with tri-n-butyl phosphate and trilaurylamine from binary mixtures of H₂SO₄ with HCl and HBr. The addition of sulfuric acid to the mentioned mineral acid solutions, was found to affect appreciably D_Pu, which recommended some useful purification procedures. The effect of water-miscible alcohols on the extraction of plutonium from HCl and HNO₃ solutions was also investigated.     

Mixed micelle behavior of Pluronic L64 and Triton X-100 with conventional and dimeric cationic surfactants

The mixed micellar properties of a triblock copolymer, Pluronic L64, (EO)13(PO)30(EO)13, and a nonionic surfactant, Triton X-100, in aqueous solution with conventional alkyl ammonium bromides and their dimeric homologues were investigated with the help of fluorescence and cloud point measurements. The composition of mixed micelles and the interaction parameter, beta, evaluated from the critical micelle concentration (cmc) data for different mixtures using Rubingh's and Motomura's theories are discussed. It has been observed that the mixed micelle formation between monomeric/dimeric alkyl ammonium bromides and L64 was due to synergistic interactions which increase with the increase in hydrophobicity of the cationic component. On the other hand, synergistic mixing was observed in the mixed micelles of Triton X-100 and monomeric cationic surfactants, the magnitude of which decreases slightly with the increase in hydrophobicity of the cationic component. Antagonistic interactions were observed in the case of Triton X-100 and dimeric cationic surfactants.