Planar ZrO2 Waveguides Prepared by the Sol-Gel Process: Structural and Optical Properties

ZrO₂ waveguides are prepared by the sol-gel process from a solution containing zirconiumn-propoxide and acetylacetone in propanol-2. Structural characterizations are investigated for different annealing temperatures using suitable techniques including Waveguide Raman Spectroscopy, Electron Microscopy and Atomic Force Microscopy. Films are amorphous at 300°C and the pure ZrO₂ tetragonal crystalline phase appears beyond 400°C. Crystallized films present a dense, uniform and polycrystalline structure made up by randomly oriented nanocrystallites, the diameter of which increases from 38 Å at 400°C to 53 Å at 600°C. Waveguides are at least monomode TE₀ at 632.8 nm. At this wavelength, optical losses are about, 0.8±0.2dB/cm for amorphous layers and increase up to 2.5±0.4 dB/cm for 600°C heat-treated waveguides.     

Kinetics of bond formation in cross-linked gelatin gels

In chemical cross-linking of gelatin solutions, two different time scales affect the kinetics of the gel formation in the experiments. We complement the experimental study with Monte Carlo numerical simulations of a lattice model. This approach shows that the two characteristic time scales are related to the formation of single bond cross-linker-chain and of bridges between chains. In particular, their ratio turns out to control the kinetics of the gel formation. We discuss the effect of the concentration of chains. Finally our results suggest that by varying the probability of forming bridges as an independent parameter, one can finely tune the kinetics of the gelation via the ratio of the two characteristic times.     

Dynamical processes in sol-gel derived rare-earth doped glasses

We have investigated the dynamical processes of rare-earth photoluminescence in silica glasses produced by the sol-gel method. Generally, static spectroscopic properties are used as a tool to probe the local structure near dopants as well as for the study of glass formation. Rare earth ions are preferred structural probes, especially the Eu³⁺ ion for its sensitivity to local structural modifications and its spectroscopic simplicity. By an analysis of the decaying emission that follows a pulsed laser excitation, we have studied several dynamical processes. Importance of a distribution of different environments for the dopant is clearly seen even for the wet gels. The evolution of the lifetimes allow to study the densification process.     

Resonance-enhanced multiphoton ionisation photoelectron spectroscopy of the ClO radical: the C 2 sigma- state

A (2 + 1) one-colour resonance-enhanced multiphoton ionisation study is carried out on the C 2 sigma- state of the ClO radical in the one-photon energy range 29,500-31,250 cm-1. The ClO radical is produced by one-photon photolysis of ClO2 employing 359.2 nm photons derived from a separate laser. In this way a significant concentration of vibrationally excited ClO in its spin-orbit split X 2 pi omega (omega = 3/2 or 1/2) electronic ground state is produced. In addition to mass-resolved excitation spectra, kinetic-energy resolved photoelectron spectra for the X 3 sigma-(v+)<--C 2 sigma-(v' = 3-5) transitions are measured. These transitions are not completely Frank-Condon diagonal, and indicate a decrease in bond length on removal of the Rydberg electron from the C 2 sigma- state. In addition to an unambiguous assignment of the C 2 sigma- state, valuable information is obtained on the degree of vibrational excitation with which the nascent ClO radical is formed in the photolysis of ClO2. Analysis of the photoelectron spectra is supported by Franck-Condon calculations based on potential energy curves either from experimental spectroscopic parameters, or obtained by theoretical ab initio methods.     

Photoelastic determination of stresses in multiple-pin connectors

The design, fabrication, and testing of photoelastic models of double-lap, multiple-pin connectors are discussed. Interest is in the stresses in the inner laps. These stresses are determined by constructing models with photoelastic inner laps and transparent-acrylic outer laps. The connectors have two pins, in tandem, parallel to the load direction. A photoelastic-isotropic point is shown to permit the evaluation of load sharing between the two pins. A numerical scheme, utilizing the isochromatic- and isoclinic-photoelastic data and a finite-difference representation of the planestress equilibrium equations, is used to compute the stresses around the two pins. Representative stress distributions and stress-concentration factors are shown.     

Phage display-derived inhibitor of the essential cell wall biosynthesis enzyme MurF

Background  

To develop antibacterial agents having novel modes of action against bacterial cell wall biosynthesis, we targeted the essential MurF enzyme of the antibiotic resistant pathogen Pseudomonas aeruginosa. MurF catalyzes the formation of a peptide bond between D-Alanyl-D-Alanine (D-Ala-D-Ala) and the cell wall precursor uridine 5'-diphosphoryl N-acetylmuramoyl-L-alanyl-D-glutamyl-meso-diaminopimelic acid (UDP-MurNAc-Ala-Glu-meso-A2pm) with the concomitant hydrolysis of ATP to ADP and inorganic phosphate, yielding UDP-N-acetylmuramyl-pentapeptide. As MurF acts on a dipeptide, we exploited a phage display approach to identify peptide ligands having high binding affinities for the enzyme.     

Fracture of thick laminated composites

The fracture of thick laminated graphite/epoxy composites has been the subject of an extensive research program. The program was divided into three major areas of investigation which included laminate thickness, laminate stacking sequence, and part-through surface flaws. The results from this program are reviewed with emphasis placed on their applicability to the design of thick laminated composite structures. Paper was presented at 1985 SEM Spring Conference on Experimental Mechanics held in Las Vegas on June 9–14, 1985.