A simple,rapid and sensitive method based on modified multiwalled carbon nanotube for preconcentration and determination of lead ions in aqueous media in natural pHs

In this study, multiwalled carbon nanotube (MWCNT) was modified by the pyridine group using a silane agent and characterized by infrared spectroscopy (IR), thermal analysis (TG/DTA), and elemental analysis (CHN) and scanning electron microscopy (SEM). The application of this sorbent was investigated in determination of lead ions in aqueous samples, using flame atomic absorption spectrometry (FAAS). Through this study, different parameters such as pH and sample flow rate on adsorption process and eluent concentration, volume and flow rate were optimized. The limit of detection (LOD), the relative standard deviation and the recovery of the method were 2 ng mL^?1, 1.3% and 99.7%, respectively. Two standard reference materials (NIST 1571 and NIST 1572) were used to verify accuracy of this method. Finally, the sorbent was successfully applied for extraction and determination of low levels of Pb(II) ions in aqueous samples.     

Syntheses of 5‐alkylthio‐1,3‐diaryl‐1,2,4‐triazoles

Arylation of the readily available 3‐alkythio‐5‐aryl‐1,2,4‐triazoles gave 5‐alkylthio‐1,3‐diaryl‐1,2,4‐triazoles in moderate yield. The structures of the latter were confirmed by NOE and ¹³C‐NMR.     

Electromagnetic interference shielding and radiation absorption in thin polypyrrole films

Results of permittivity measurements, electromagnetic interference shielding effectiveness, and heat generation due to microwave absorption in conducting polymer coated textiles are reported and discussed. The intrinsically conducting polymer, polypyrrole, doped with anthraquinone-2-sulfonic acid (AQSA) or para-toluene-2-sulfonic acid (pTSA) was applied on textile substrates and the resulting materials were investigated in the frequency range 1-18 GHz. The 0.54 mm thick conducting textile/polypyrrole composites absorbed up to 49.5% of the incident 30-35 W microwave radiation. A thermography station was used to monitor the temperature of these composites during the irradiation process, where absorption was confirmed via visible heat losses. Samples with lower conductivity showed larger temperature increases caused by microwave absorption compared to samples with higher conductivity. A sample with an average sheet resistivity of 150 Ω/sq. showed a maximum temperature increase of 5.27 °C, whilst a sample with a lower resistivity (105 Ω/sq.) rose by 3.85 °C.     

Spectrophotometric Study of the Complexation of Some Lanthanide (III) Ions with a Series of 18-Crowns-6 in DMSO Solution Using Murexide as a Metallochromic Indicator

The complexation of La(III), Ce(III), Pr(III) and Er(III) with 18-crown-6(18C6), dibenzo-18-crown-6 (DB18C6), dicyclohexano-18-crown-6 (DCY18C6) anddibenzopyridino-18-crown-6 (DBPY18C6) has been studied in dimethylsulfoxide(DMSO) by means of a competitive spectrophotometric method using murexide asa metal ion indicator. The formation constants of the 1 : 1 complexeswere found tovary in the order La(III) > Ce(III) > Pr(III) > Er(III). It was foundthat the structure influences the formation and stability of the resultingcomplexes. The effects ofvarious parameters on complexation are discussed. The order of the stabilityconstants of each lanthanide ion with these macrocycles are18C6 > DC18C6 > DB18C6 > DBPY18C6.     

Determination of association constants between enantiomers of orciprenaline and methyl-beta-cyclodextrin as chiral selector by capillary zone electrophoresis using a partial filling technique

The principles for the determination of conditional association constants of enantiomers by capillary zone electrophoresis employing a partial filling technique (PFT) using methyl-beta-cyclodextrin as chiral selector is presented. Orciprenaline was used as a model compound. Partial filling is a separation technique, where different lengths of the chiral selector solution are introduced into the capillary to a final zone length shorter than the effective length of the capillary, prior to application of the solutes. Lengthening of the separation zone results in improving enantioresolution in addition to decreasing electrophoretic mobility of the enantiomers, because of longer interaction time between the solute and chiral selector. The degree of the reduction in electromobility depends on the affinity of the solute to the chiral selector, i.e. strength of the complex formed between the solute and cyclodextrin. The decrease in the electrophoretic mobility with increasing length of the separation zone is used for determination of the association constant. The association constants of the enantiomers of orciprenaline and the chiral selector were evaluated from the slope of the plot, observed electrophoretic mobility versus the ratio between the length of the separation zone and the effective length of the capillary. It was found that the association constants were independent of the chiral selector concentration. The mean values were 110 M(-1) and 160 M(-1) for respective enantiomer. Constants obtained by a conventional CE technique were in good agreement with those from the PFT experiments. The highest enantioselectivityy was obtained when about 50% of the solute was distributed to the selector phase.     

Surface thermodynamic functions of dilute solutions of methylcyclohexanols in ethylene glycol

Surface thermodynamic functions (surface entropy, surface enthalpy, and surface composition) of dilute solutions of 2-, 3-, and 4-methylcyclohexanol in ethylene glycol were obtained using surface tension measurements at various temperatures. Surface excess values and surface mole fractions were obtained from Gibbs equation and extended Langmuir model respectively. The results show that all methylcyclohexanols are surface active in ethylene glycol. The lyophobicity of solutes decreases with increasing temperature. The presence of a maximum point in the surface entropy diagram in all systems is explained by the formation of clathrate-like solvates at the surface of these systems.     

Structural Elucidation of {[(CH3)2SnCl2·H2O]2·18-crown-6} n and its Hydrogen Bonding in Solution by HMBC Spectroscopy

Behavior of {[(CH₃)₂SnCl₂·H₂O]₂·18-crown-6}_n in solution have been investigated by HMBC NMR. The results show that coordination of water to tin containing species and its hydrogen bonding to crown ether remains intact in non-coordinating solvent in contrast to coordinating solvent. H-NMR reveals that the chemical shift of water in complex varies by solvent of crystallization.     

NMR study of the stoichiometry,stability and exchange kinetics of complexation reaction between Pb2+ ion and 18-crown-6 in binary acetonitrile-water mixtures

Proton NMR was used to study the complexation reaction between lead ion and 18-crown-6 in a number of binary acetonitrile-water mixtures. Formation constant for the resulting 11 complexes in different solvent mixtures was determined by computer fitting of the chemical shift-mole ratio data. There is an inverse relationship between the complex stability and amount of water in the mixed solvent. The dissociative kinetics of the complex was studied by proton line-shape analysis. The Arrhenius plots showed a distinct isokinetic temperature at about 25°C at which the decomplexation rate is more or less independent of the solvent composition. the complexation rate and the activation parameters E _a , H and S, for the exchange have been determined and found to be strongly solvent dependent. There is actually a linear relationship between the mole fraction of acetonitrile in the mixed solvent and logarithm of the stability constant as well as activation parameters.     

Theoretical study on interaction of different coordination modes of BH4 ligand with transition metal in [TM(BH4)(CO)4] (TM = Cr, Mo)

Density functional calculations were performed on bonding and structural features of [(ηⁿ-BH₄)TM(CO)₄]⁻ (n = 1, 2, 3; TM = Cr, Mo) complexes. Calculations show that the ground state is bidentate which is in good agreement with experimental results. It has been found that the bridge and terminal hydrogen atoms will interchange by two pathways: (i) twist of BH₄ about one of the bridge B-H and (ii) twist of BH₄ about one of the terminal B-H. The molecular orbital calculations and natural bond orbital methodologies for different isomers of these complexes have been evaluated. The final results indicate that case (i) is more preferable relative to another case.     

Solid phase extraction of gold by sorption on octadecyl silica membrane disks modified with pentathia-15-crown-5 and determination by AAS

A simple and selective method for rapid and efficient concentration and determination of μg l⁻¹ levels of Au(III) ions in aqueous solution using octadecyl silica membrane disks modified by pentathia-15-crown-5 and flame atomic absorption spectrometry is presented. The influence of flow rates of eluent and sample solution, amount of ligand, types and least amount of eluent for elution of Au from disks were investigated. Break through volume and limit of detection of the membrane disks modified by 5 mg of the thiacrown ether was found to be 2.0 l and 1.0 μg l⁻¹, respectively. The effects of various cationic interferences on percent recovery of gold were studied. The method was successfully applied for the determinations of gold in some pharmaceutical samples and for the recovery of trace Au³⁺ ions from synthetic and water samples.