Reduction of AC losses applying novel resistive interfilamentary carbonate barriers in multifilamentary Bi(2223) tapes

Hysteresis losses and coupling losses, a main component of the AC losses in Bi(2223) tapes, can effectively be reduced by enhancing the resistivity of the matrix material between the filaments and applying a filament twist. Since through alloying the sheath, as using AgAu(8 wt.%), the resistivity can only be raised by a factor <10 (77 K), a new conductor configuration with a quite novel composite matrix having resistive SrCO₃ barriers inside the Ag matrix between the filaments was developed. These new barriers, a cheap and commercial material, withstand the tape annealing, do not react with the superconductor, sinter dense and have a good bonding to Ag. Applying two different preparation techniques for 19 filament prototype tapes, critical current densities up to 20.7 kA cm⁻² were achieved. We report on tape preparation, the effect on the phase texture and the superconducting properties of such barrier tapes.     

Self-injection length in La0.7Ca0.3MnO3-YBa2Cu3O7-δ ferromagnet-superconductor multilayer thin films

We have carried out extensive studies on the self-injection problem in barrierless heterojunctions between La_0.7Ca_0.3MnO₃ (LCMO) and YBa₂Cu₃O_7-δ (YBCO) thin films. The heterojunctions were formed in situ by sequentially growing LCMO and YBCO films on 〈100〉 LaAlO₃ (LAO) substrate using a pulsed laser deposition (PLD) system. YBCO micro-bridges with 64 μm width were patterned both on the LAO (control) and LCMO side of the substrate. Critical current, I _c, was measured at 77 K on both the control side as well as the LCMO side for different YBCO film thickness. It was observed that while the control side showed a J _c of ∼ 2 × 10⁶ A/cm², the LCMO side showed about half the value for the same thickness (1800 ?). The difference in J _c indicates that a certain thickness of YBCO has become ‘effectively’ normal due to self-injection. From the measurement of J _c at two different thicknesses (1800 ? and 1500 ?) of YBCO films both on the LAO as well as the LCMO side, the value of self-injection length (at 77 K) was estimated to be ∼ 900 ?. To the authors’ best knowledge, this is the first time that self-injection length has been quantified. A control experiment carried out with LaNiO₃ deposited by PLD on YBCO did not show any evidence of self-injection.     

Current distributions in multifilamentary conductors: the influence of intergrowths

The modelling of both critical and remanent states (i.e., the current density and field distributions) in periodic arrays of flat superconducting strips is important for calculating the AC losses in multifilamentary tapes made for power applications. We model the current and field profiles for such magnetically coupled conductors, and have measured these dependences for BSCCO-22223 tapes using a miniature scanning Hall probe technique. The results indicate that the filaments are also electrically connected to a significant extent, which must be caused by superconducting intergrowths between individual filaments.     

A variable angle method of calibration for X-probes applied to wall-bounded turbulent shear flow

A variable angle calibration technique for hot wire and hot film X-probes incorporating a new method of interpolation is described here along with measurements in a fully developed turbulent channel flow. Results based on the new method of calibration include the mean velocity profile, Reynolds stress, and probability density distributions for fluctuating velocity components u and and for the flow angle. Also skewness and flatness factors for u and are given. Measurement data were also evaluated using the conventional method. A comparison of both techniques shows that the new method does not yield appreciable differences in statistical flow analyses but is more accurate in measuring rare flow events associated with large flow angles. An extended version of the new method of calibration allowing three dimensional measurements in turbulent flow will be discussed.     

Application of a partly submerged two component laser-Doppler anemometer in a turbulent flow

A partly submerged two comportent laser-Doppler anemometer has been employed in the simultaneous measurement of the velocity components in streamwise direction and perpendicular to the wall in a fully developed turbulent channel flow. Partial submersion of the laser-Doppler anemometer in the fluid allows measurements at variable distance from the wall without requiring readjustments of the optics.     

AC losses in multifilamentary Bi(2223) tapes with an interfilamentary resistive carbonate barrier

For the most common AC application frequencies, the main component of the AC losses in multifilamentary Bi(2223) tapes are caused by hysteresis- and coupling losses. These losses can be reduced enhancing the matrix resistivity and applying a twist to the filaments. We report on the AC loss properties of 37-filament tapes with AgAu (8 wt.%) matrix, and novel 19-filament tapes with SrCO₃ barriers between the filaments. We performed transport AC loss and magnetic AC loss measurements in parallel and perpendicular magnetic fields. Both kinds of tapes were also prepared with filament twists below a twist pitch of 20 mm. The influence of the different tape modifications on the AC loss behaviour is presented and compared with theoretical models to understand the effect of the resistive matrix. In the case of magnetic AC loss measurements, reduced AC losses due to decoupled filaments were observed for the twisted tapes with a resistive matrix in low parallel fields.     

Magnetoelectric effect in cobalt ferrite-barium titanate composites and their electrical properties

CoFe₂O₄-BaTiO₃ composites were prepared using conventional ceramic double sintering process with various compositions. Presence of two phases in the composites was confirmed using X-ray diffraction. The dc resistivity and thermoemf as a function of temperature in the temperature range 300 K to 600 K were measured. Variation of dielectric constant (ɛ′) with frequency in the range 100 Hz to 1 MHz and also with temperature at a fixed frequency of 1 kHz was studied. The ac conductivity was derived from dielectric constant (ɛ′) and loss tangent (tan δ). The nature of conduction is discussed on the basis of small polaron hopping model. The static value of magnetoelectric conversion factor has been studied as a function of magnetic field.     

Energy dependence of multiplicity in proton-nucleus collisions and models of multiparticle production

This is a continuation of our earlier investigation (Gurtuet al 1974Phys. Lett. 50 B 391) on multiparticle production in proton-nucleus collisions based on an exposure of emulsion stack to 200 GeV/c beam at the NAL. It is found that the ratioR _em = 〈n _s〉/〈n _ch〉, where 〈n _ch〉 is the charged particle multiplicity in pp-collisions, increases slowly from about 1 at 10 GeV/c to 1·6 at 68 GeV/c and attains a constant value of 1·71 ± 0·04 in the region 200 to 8000 GeV/c. Furthermore,R _em = 1·71 implies an effectiveA-dependence ofR _A =A ^0.18,i.e., a very weak dependence. Predictions ofR _em on various models are discussed and compared with the emulsion data. Data seem to favour models of hadron-nucleon collisions in which production of particles takes place through adouble step mechanism,e.g., diffractive excitation, hydrodynamical and energy flux cascade as opposed to models which envisage instantaneous production.     

Second‐Generation Supramolecular Dendrimer with a Defined Structure due to Orthogonal Binding

A second‐generation supramolecular dendrimer has been prepared by orthogonal multiple hydrogen bonding. In the first (inner) recognition domain, the interaction of one bis‐isocyanuric acid ( 25 ) with two branching units ( 21 ) that carry complementary Hamilton receptors has been exploited. In the second (outer) generation, the two ADDA (A=hydrogen‐bond acceptor, D=donor) receptors of each branching unit ( 21 ) have bound complementary DAAD units ( 4 ). The problem of limited solubility of the building blocks has been overcome by the introduction of branched ethylhexyl residues and by the use of flexible alkylene or oligo(ethylene glycol) linking chains. The orthogonal binding of the two hydrogen‐bonding pairs was elucidated by chemical induced shift NMR titrations, which proved that the two pairs, isocyanuric acid with the Hamilton receptor and ADDA with DAAD, bind preferentially. The formation of the supramolecular self‐assembled 1:2:4 dendrimer with a molecular weight of 5065 g mol^?1 was investigated by diffusion NMR spectroscopy.