Fundamental groups of the complements of certain plane non-tame torus sextics

The moduli space of torus sextics with the configuration of singularities {A₂+A₅+2E₆} has two connected components. We compute the fundamental groups π₁(CP²−C) for sextics C in both components and study their differences.     

Modelling of a single drop impact onto liquid film using particle method

The process of single liquid drop impact on thin liquid surface is numerically simulated with moving particle semi‐implicit method. The mathematical model involves gravity, viscosity and surface tension. The model is validated by the simulation of the experimental cases. It is found that the dynamic processes after impact are sensitive to the liquid pool depth and the initial drop velocity. In the cases that the initial drop velocity is low, the drop will be merged with the liquid pool and no big splash is seen. If the initial drop velocity is high enough, the dynamic process depends on the liquid depth. If the liquid film is very thin, a bowl‐shaped thin crown is formed immediately after the impact. The total crown subsequently expands outward and breaks into many tiny droplets. When the thickness of the liquid film increases, the direction of the liquid crown becomes normal to the surface and the crown propagates outward. It is also found that the radius of the crown is described by a square function of time: r_C = [c(t ? t₀)]^0.5. When the liquid film is thick enough, a crown and a deep cavity inside it are formed shortly after the impact. The bottom of the cavity is initially oblate and then the base grows downward to form a sharp corner and subsequently the corner moves downward. Copyright © 2004 John Wiley & Sons, Ltd.     

A simple and sensitive method for the determination of hydroxylamine in fresh-water samples using hypochlorite followed by gas chromatography.

A new and simple method for the determination of hydroxylamine in environmental water, such as fresh rivers and lakes using hypochlorite, followed by its gas choromatographic detection, has been developed. A glass vial filled with sample water was sealed by a butyl-rubber stopper and aluminum cap without head-space, and then sodium hypochlorite solution was injected into the vial through a syringe to convert hydroxylamine to nitrous oxide. The head-space in the glass vial was prepared with 99.9% grade N2 using a gas-tight syringe. After the glass vial was shaken for a few minutes, nitrous oxide in the gas-phase was measured by a gas chromatograph with an electron-capture detector. The dissolved nitrous oxide in the liquid-phase was calculated according to the solubility formula. The proposed method was applied to the analysis of fresh-water samples taken from Iu river and Hii river, flowing into brackish Lakes Nakaumi and Shinji, respectively.     

Effect of core-shell micelle formation on the redox properties of phenothiazine-labeled poly(ethyl glycidy ether)-block-poly(ethylene oxide)

Redox properties of phenothiazine-labeled poly(ethyl glycidy ether)-block-poly(ethylene oxide) (PT-EGE_n-b-EO_m) are reversibly changed by core-shell micelle formation. In the temperature range higher than the critical micellization temperature (cmt), the anodic potential of PT group positively shifts and concomitantly its anodic current decrease, or levels off compared to those of the reference polymer PT-EO_m without the thermo-responsive EGE_n segment. The former alteration is caused by incorporation of hydrophobic PT groups into a core of the micelle and the latter by the decrease in the diffusion coefficient of PT groups due to formation of the core-shell micelles. The cmt value and the temperature-dependent alteration in the redox properties strongly depend on the polymer structure, especially the length of thermo-responsive EGE_n segment. The electrochemically determined hydrodynamic radii of the polymer aggregates seem to be overestimated, compared to the values reported for the aggregates of other thermo-responsive polymers with similar molecular weights, implying the presence of electrochemically inactive PT groups in the copolymers having longer thermo-responsive segments.     

Development of a “Built-in” Scanning Near Field Microscope Head for an Atomic Force Microscope System and Stress Mapping of an Al2O3/ZrO2 Eutectic Composite

We constructed a scanning near-field optical microscope (SNOM) on a commercially available atomic force microscopy (AFM) apparatus (SPM-9500J2; Shimadzu Corp.) to measure the stress distribution in ceramic composite materials. Features of our SNOM system are: (1) a compact SNOM head substituted for the original AFM head; (2) a wide scanning range (125 × 125 μm²) inherited from the original scanner; (3) use of conventional shear-force regulation; (4) an optical system for the illumination-collection (I-C) mode; (5) excitation by a 488 nm line of an Ar-ion laser, and (6) light detection by photon counting or a polychromator equipped with an electronically cooled charge coupled device (CCD). This SNOM system was used to measure the surface structure and stress distribution of an Al₂O₃/ZrO₂ eutectic composite. We simultaneously measured topographic images and fluorescence spectra of an Al₂O₃/ZrO₂ eutectic composite. We estimated its peak intensity, peak position, and peak width from the fluorescence spectrum during scanning, which respectively correspond to the abundance of Al₂O₃, stress in the grain, and the anisotropy of that stress. Mapping images showed that the stress and its anisotropy were weaker in the center of the Al₂O₃ grain than its boundary between Al₂O₃ and ZrO₂. That observation suggests that Al₂O₃ underwent intense anisotropic stress induced by volume expansion in the phase transition of ZrO₂ from the cubic phase to the monoclinic phase during preparation.     

Determination of cyclosporin A in the serum of kidney transplant patients by rapid-flow fractionation and normal-phase high-performance liquid chromatography

High-performance liquid chromatography was used to determine cyclosporin A (CsA) concentrations in the serum of kidney transplant patients by rapid-flow fractionation (RFF) followed by silica gel normal-phase high-performance liquid chromatography (HPLC). The extraction of CsA from serum was achieved by RFF using a short diatomaceous earth column eluted with diethyl ether-n-hexane (50:50, v/v). The recovery was more than 80% at concentrations of 50-150 micrograms/l. The concentration of this compound was determined by HPLC using a conventional silica gel column with 3.3 M ammonia solution-ethanol-n-hexane (0.31:10.69:89, v/v) as eluent. Concentration calibration was made on the basis of the peak-height ratio of CsA to CsD as the internal standard. The coefficient of variation of this assay was less than 6.5% and the results were used for the therapeutic drug monitoring of CsA administered to kidney transplant patients. Measurements of the CsA concentrations in 160 serum specimens were also made by conventional radioimmunoassay (RIA) using commercial kits. The data obtained by RIA were on average 2.5 times those obtained by HPLC. Higher values in RIA were observed characteristically with patients with severe disfunction resulting from CsA hepatotoxicity. From the results, it appeared that HPLC rather than RIA provides more precise and reliable values for the concentration of this drug.     

Divergence-free WKB theory

We present a divergence-free WKB theory, which is a new semiclassical theory modified by nonperturbative quantum corrections. Conventionally, the WKB theory is constructed upon a trajectory that obeys the bare classical dynamics expressed by a quadratic equation in momentum space. Contrary to this, the divergence-free WKB theory is based on a higher-order algebraic equation in momentum space, which represents a dressed classical dynamics. More precisely, this higher-order algebraic equation is obtained by including quantum corrections to the quadratic equation, which is the bare classical limit. An additional solution of the higher-order algebraic equation enables us to construct a uniformly converging perturbative expansion of the wavefunction. Namely, our theory removes the notorious divergence of wavefunction at a turning point from the WKB theory. Moreover, our theory is able to produce wavefunctions and eigenenergies more accurate than those given by the traditional WKB method. In addition, the divergence-free WKB theory that is based on the cubic equation allows us to construct a uniformly valid wavefunction for the nonlinear Schrödinger equation (NLSE). A recent short letter [T. Hyouguchi, S. Adachi, M. Ueda, Phys. Rev. Lett. 88 (2002) 170404] is the opening of the divergence-free WKB theory. This paper presents full formalism of this theory and its several applications concerning wavefunction and eigenenergy to show that our theory is a natural extension of the traditional WKB theory that incorporates nonperturbative quantum corrections.     

Phase Measurement Algorithm in Wavelength Scanned Fizeau Interferometer

Wavelength scanned interferometry allows the simultaneous measurement of top surface shape and optical thickness variation of a transparent object consisting of several parallel surfaces. Interference signals from these surfaces can be separated in frequency space, and their phases are detected by discrete Fourier analysis. However, these signal frequencies are shifted from the detection frequency by the refractive index dispersion of the object and a nonlinearity of the wavelength scanning. The Fourier analysis is sensitive to the detuning of the signal frequency and suffers from the multiple-beam interference noise. Conventional error-compensating algorithms cannot be applied to an object consisting of more than three reflecting surfaces. We derive a new 2N-1 sample error-compensating algorithm, which allows the phase detection of any order of harmonic frequency among the interference signals. The new algorithm suppresses the effect of signal frequency detuning as well as the multiple-beam interference noise and can be applied to the measurement of complex objects consisting of more than three reflecting surfaces.     

Chiral discrimination of a helically organized crown ether array parallel to the helix axis of polyisocyanate

The asymmetric polymerization of 4′‐isocyanatobenzo‐18‐crown‐6 with the lithium amide of (S)‐(2‐methoxymethyl)pyrrolidine successfully proceeded to afford end‐functionalized poly(4′‐isocyanatobenzo‐18‐crown‐6) with (S)‐(2‐methoxymethyl)pyrrolidine (polymer 2 ). In the circular dichroism (CD) spectrum of 2 , a clear positive Cotton effect was observed in the range of 240–350 nm corresponding to the absorption of the polymer backbone, indicating that 2 partially formed a one‐handed helical structure, which was preserved by the chirality of (S)‐(2‐methoxymethyl)pyrrolidine bonding to the terminal end in 2 . In the titration experiments for the CD intensity of 2 in the presence of D ‐ and L ‐Phe·HClO₄ (where Phe is phenylalanine), a small but remarkable difference was observed in the amount of the chiral guest needed for saturation of the CD intensity and in the saturated CD intensity, indicating that the extremely stable, one‐handed helical part should exist in the main chain of 2 , which was not inverted even when the unfavorable chiral guest for the predominant helical sense, L ‐Phe·HClO₄, was added. In addition, helical polymer 2 exhibited a chiral discrimination ability toward racemic guests; that is, the guests were extracted from the aqueous phase into the organic phase with enantiomeric excess. The driving force of the chiral discrimination ability of 2 should certainly be attributed to the one‐handed helical structure in 2 . © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 325–334, 2006